turn signal INFINITI Q50 2015 Quick Reference Guide

*See your Owner’s Manual for information.
Behind
steering wheel Behind
steering wheel

1 VEHICLE INFORMATION DISPLAY

2 LOW TIRE PRESSURE WARNING LIGHT

3 HEADLIGHT AND TURN SIGNAL SWITCH

4 PUSH BUTTON IGNITION SWITCH

5 PADDLE SHIFTERS*

6 WINDSHIELD WIPER AND WASHER SWITCH

7 INTELLIGENT CRUISE/CRUISE CONTROL/
DRIVER’S ASSISTANCE SWITCHES

8 STEERING WHEEL SWITCHES FOR

AUDIO*/BLUETOOTH®
9 INSTRUMENT BRIGHTNESS CONTROL*/
TRIP RESET SWITCH
10 VEHICLE INFORMATION DISPLAY SWITCHES
11 TILT AND TELESCOPIC STEERING COLUMN*
12
VEHICLE DYNAMIC CONTROL (VDC)
OFF SWITCH*
13 TRUNK RELEASE SWITCH
14 HOOD RELEASE*
15 UPPER DISPLAY
16 CLIMATE CONTROL SWITCHES
17 LOWER DISPLAY
18 AUDIO SYSTEM
19 FRONT PASSENGER AIR BAG

STATUS LIGHT*
20 HEATED SEAT SWITCHES
21 INFINITI CONTROLLER
22 DRIVE MODE SWITCH*
22
21
2020
19
18
171616
14
11
8 7
4 3 2 1
6 5 5
910
15
1312
2045927_15c_Infiniti_Q50_QRG_071415.indd 37/14/15 3:38 PM

16
first drive features
LANE CHANGE SIGNAL

Move the lever up or down until the turn signal begins to flash but the lever does not latch
to signal a lane change. Hold the lever until the lane change is completed.

Move the lever up or down until the turn signal begins to flash but the lever does not latch
and release the lever. The turn signal will automatically flash three times.

Choose the appropriate method to signal a lane change based on road and
traffic conditions.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
Windshield Wiper and Washer Switch
RAIN-SENSING AUTO WIPER SYSTEM (if so equipped)

Move the lever to one of the following positions to
operate the windshield wipers:

1 Mist (MIST) – One sweep operation of
the wipers.

2 Auto (AUTO ) – Operates the rain-sensing wipers
intermittently. The intermittent speed can be
adjusted by twisting the time control ring
3
to increase or decrease wiper sensitivity.

4 Low (LO) – Wipers operate at a continuous
low-speed.

5 High (HI) – Wipers operate at a continuous
high-speed.

6 Pull the lever toward you to activate the washer.
The wipers will operate several times.
PULLING UP THE WIPER ARM

The wiper arm should be in the up position when
replacing the wiper.

To pull up the wiper arm, push the wiper switch to
the MIST
1 position twice when the ignition
switch is in the OFF position within 1 minute. The
wiper operation stops in mid-operation and the wiper arm can be pulled up.

The shift lever should be in the P (PARK) position.

To return the wiper arm, place the wiper arm in the down position and operate the wiper
switch once.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
6
MIST
OFFAUTO
LO
HI
3
1
2
4
5
2045927_15c_Infiniti_Q50_QRG_071415.indd 167/14/15 3:39 PM