instrument panel INFINITI Q70 HYBRID 2015 First Responder´s

2-4 High Voltage Safety Measures
Circuit insulation
The high voltage positive (+) and negative (-) circuits are insulated from the
metal chassis.
Reducing the risk of
electrocution The high voltage components and harnesses have insulated cases or
orange-colored coverings which provide insulation and easy identification.
The high voltage battery case is electrically connected to the vehicle ground.
This connection helps protect the vehicle occupants and emergency responders
from high voltage electrical shock.
Identification The high voltage components are labeled “WARNING” similar to label shown
below. All high voltage harnesses are coated in orange.
2-4.1 Warning Labels To avoid serious injury, keep clear of engine parts at all times. Engine\
may start at any time if
t

he start switch and the READY lamps on the instrument panel are "ON". Make sure both
lamps are "OFF" before working in the engine compartment. See Owners Man\
ual. ¾¯¸æ/WARNING/AVERTISSEMENT ÖØ ´ó
ÏûµÆ
Pour éviter des blessures graves, assurez-vous que les témoins STA\
RT SWITCH et READY
d

ans le tableau de bord sont éteints (OFF) avant d' entreprendre tout travail a l' intérieur du
compartiment moteur. Le moteur peut démarrer a tout moment si le contacteur d' allumage
est a la position ON et que les témoins READY du tableau de bord sont allumés. Assurez-vous
que les deux témonins sont éteints avant de travailler dans le com\
partiment moteur.
Reportez-vous au manuel du conducteur. ÉË º¦
¶¯³ö
Ïê ÀÀ
¸º
×÷ Òµ ʱ
È· ÈÏ ×Ô ¶¯ µÄʼ ¶¯ READY
A
AAYIA0410ZZ AAYIA0010ZZ
FRG–13

Primary Procedure
NO
TE:
Before disconnecting the 12-volt battery terminal, if necessary, lower the windows, adjust the steering
column, adjust the seats, unlock the doors, etc. Once 12-volt battery is disconnected, power controls will
not operate.
1. Check the READY indicator (A) status in the instrument cluster. If it is on, the high voltage systemis active.
2. Place the shift selector in the Park (P) position.
3. Push the ignition switch (B) once to turn OFF the high voltage system. Then verify whether the READY indicator (A) is off.
If the READY indicator (A) does not turn off, continue to the next steps to open the trunk for
12-volt battery negative cable access.
4.
If possible, keep the Infiniti Intelligent Key at least 5 meters
(16 feet) away from the vehicle (except as noted below) .
5. Open the trunk using any of the following: a. push-button switch (C) on the lower LH side ofthe instrument panel.
b. trunk button (D) on the Infiniti Intelligent Key [press for longer than one (1) second].
c. trunk open request switch (E) (located above license plate)*.
d. with the mechanical key (F) housed inside the
Infiniti Intelligent Key.
* You must have the Infiniti Intelligent Key within approximately 1 meter (3 feet) range of
trunk request switch to use the trunk open request switch function. AAYIA0062ZZ
AAYIA0068ZZ
FRG–22

5. Open the trunk. The trunk can be opened with the push-button switch (D) on the lower LH side
of the instrument panel or with the mechanical key (E) housed inside the Infiniti Intelligent Key.
6. Open the 12-volt battery service access cover (F) .
7. Disconnect negative (-) battery cable (G) and cover it with insulated tape.
8. Wait approximately ten (10) minutes for complete discharge of the high voltage capacitor after the fuse is pulled and battery cable has been disconnected.
9. Perform the first response action. OrD
E D
GF
AAYIA0126GB
FRG–25

4.If possible, keep the Infiniti Intelligent Key at least 5 meters
(16 feet) away from the vehicle (except as noted below) .
5. Open the trunk using any of the following: a. push-button switch (C) on the lower LH side ofthe instrument panel.
b. trunk button (D) on the Infiniti Intelligent Key [press for longer than one (1) second].
c. trunk open request switch (E) (located above license plate)*.
d. with the mechanical key (F) housed inside the
Infiniti Intelligent Key.
* You must have the Infiniti Intelligent Key within approximately 1 meter (3 feet) range of
trunk request switch to use the trunk open request switch function. AAYIA0068ZZ
FRG–27