seat memory INFINITI QX30 2017 Owner's Manual

Power seat adjustment
Operating tips:
•The power seat motor has an auto-reset
overload protection circuit. If the motor stops
during the seat adjustment, wait 30 seconds,
then reactivate the switch.
•To avoid discharge of the battery, do not
operate the power seats for a long period of
time when the engine is not running.
NOTE
You can store the seat settings using the
memory function (see Memory function (if
equipped) in the3. Pre-driving checks and ad-
justments section). Forward and backward
:
Move forward or backward the adjusting switch
1to the desired position.
Reclining
:
Move forward or backward the adjusting switch
2to the desired position.
The reclining feature allows the adjustment of
the seatback for occupants of different sizes to
help obtain the proper seat belt fit. (See Seat
belts later in this section.)
The seatback may be reclined to allow occu-
pants to rest when the vehicle is parked. Seat lifter (if equipped)
:
1. Pull up or push down the adjusting switch
3to adjust the seat height until the desired
position is achieved.
2. Tilt up or down the adjusting switch
4to
adjust the front angle of the seat until the
desired position is achieved.
NIC2606
1-4Safety — seats, seat belts and supplemental restraint system

Setting and storing the parking position using
the memory button:
You can set the front-passenger side exterior
mirror so that you can see the rear wheel on
that side as soon as you engage reverse gear.
This setting can be stored using memory button
M
4.
1. Make sure that the vehicle is stationary.
2. Switch the ignition switch to the ON posi- tion.
3. Press button
2for the external mirror on
the front-passenger side.
4. Engage reverse gear. The exterior mirror on the front-passenger side moves to the preset
parking position.
5. Use adjustment button
3to adjust the
exterior mirror. You should see the rear
wheel and the curb in the exterior mirror.
6. Press memory button M
4and one of the
arrows on adjustment button
3within
three seconds. The parking position is
stored if the exterior mirror does not move.
7. If the mirror moves out of position, repeat the steps. Calling up a stored parking position
:
1. Switch the ignition switch to the ON position.
2. Adjust the exterior mirror on the front pas-
senger side with the corresponding button.
3. Engage reverse gear. The exterior mirror on the front-passenger side moves to the stored
parking position
The exterior mirror on the front-passenger side
moves back to its original position:
•As soon as you exceed a speed of 15 km/h.
•About ten seconds after you have disen-
gaged reverse gear.
•If you press button1for the exterior mirror
on the driver’s side.
WARNING
•If you use the memory function on the driv-
er’s side while driving, the adjustments
could cause you to lose control of the ve-
hicle. There is a risk of an accident. Only use
the memory function on the driver’s side
while the vehicle is stationary.
Only use the memory function on the driv-
er’s side while the vehicle is stationary.
•If the memory function adjusts the seat, you
and other vehicle occupants-particularly
children-could become trapped. There is a
risk of injury.
While the memory function is making ad-
justments, make sure that no one has any
part of their body within the sweep of the
NIC2637
MEMORY FUNCTION (IF EQUIPPED)
3-20Pre-driving checks and adjustments

seat. If someone becomes trapped, immedi-
ately release the memory function position
button The adjustment is stopped.
•If children activate the memory function,
they could become trapped, especially if
they are unattended. There is a risk of in-
jury.
When leaving the vehicle, always take the
key with you and lock the vehicle. Never
leave children unattended in the vehicle.
The memory function can be used at any time,
e.g. even when the key isn’t in the ignition lock.
STORING SETTINGS
With the memory function, you can store up to
three different settings.
•Seat and seatback position
•Driver’s side: position of the exterior mirrors
on the driver’s and front-passenger sides.
To store settings:
1. Adjust the seat (see Power seat adjustment
in the 1. Safety — seats, seat belts and
supplemental restraint system section).
2. Adjust the exterior mirror on the driver’s side (see Adjusting in the3. Pre-driving checks
and adjustments section).
3. Briefly press the M memory button
1, and
then press preset position button 1, 2 or 3
2within three seconds.
The settings are stored in the selected pre-
set position. A tone sounds when the set-
tings have been completed.
CALLING UP A STORED SETTING
Press and hold the relevant preset position
button 1, 2 or 3 until the seat and exterior
mirrors are in the stored position.
NOTE
The setting procedure is interrupted as soon as
you release the storage position button.
Pre-driving checks and adjustments3-21

– CDs with a paper label
– CDs that are warped, scratched, or haveabnormal edges
•This audio system can only play prerecorded
CDs. It has no capabilities to record or burn
CDs.
•If a CD cannot be played, one of the following
messages will be displayed.
[Disc Reading Error]
Indicates a CLV/Focus, TOC or Access error.
Check and re-insert the CD. Make sure that it
is inserted correctly.
[Please Eject Disc]
Indicates a mechanism error. If the CD can be
ejected, eject and re-insert the CD. If the CD
cannot be ejected, have the system checked.
It if recommended you contact an INFINITI
retailer for this service.
[File type is not supported]
Indicates that no readable files are found on
the inserted CD. Check the data on your CD.
USB (Universal Serial Bus) connection
port/ iPod
The Media Hub is located in the center console
and consists of the USB connectors. 1) USB/iPod connection port
Connect to play media from an iPod
R,
iPhone
Ror a USB memory device. When
using INFINITI InTouch Apps with an
iPhone
R, connect via a USB cable. Refer to
the device manufacturer’s owner information
regarding the proper use and care of the
device.
WARNING
Do not connect, disconnect or operate the USB
device while driving. Doing so can be a distrac-
tion. If distracted you could lose control of your
vehicle and cause an accident or serious injury.
CAUTION
•Do not force the USB device into the USB
port. Inserting the USB device tilted or up-
side-down into the port may damage the
port. Make sure that the USB device is con-
nected correctly into the USB port.
•Do not grab the USB port cover (if equipped)
when pulling the USB device out of the port.
This could damage the port and the cover.
•Do not leave the USB cable in a place where
it can be pulled unintentionally. Pulling the
cable may damage the port.
The vehicle is not equipped with a USB device.
USB devices should be purchased separately as
necessary.
This system cannot be used to format USB
devices. To format a USB device, use a personal
computer.
In some areas, the USB device for the front
seats plays only sound without images for
regulatory reasons, even when the vehicle is
parked.
This system supports various USB memory de-
vices, USB hard drives and iPod players. Some
NAA1628
4-56Display screen, heater and air conditioner, and audio system

Seats........................1-2
Adjustment ...................1-4
Adjustment (Manual) ..............1-3
Boosterseats.................1-35
Head restraints .................1-7
Heating ....................2-70
Leather .....................7-6
Memory ....................3-20
Overview ....................0-2
Rear .......................1-5
Rearseats-Folding..............1-6
Seatbelts....................1-11
Security system .................2-58
Servicing .....................4-51
Air conditioner .................4-51
Sparkplugs....................8-13 Information ..................8-13
Replacement ..................8-13
Speedometer ....................2-5
Starting ......................5-16
Before starting the engine ..........5-16
Engine .....................5-16
Jump-starting .................6-10
Precautions...................5-4
Push-starting .................6-12
Steering ......................5-86
Power steering system ............5-86
Steering lock ..................5-15
Steering lock ...................5-15
Steering wheel ..................3-16
Adjustment ..................3-16 Steering wheel controls
.............4-3
Storage......................2-77 Luggage hooks ................2-81
Luggage net ..................2-82
Map pocket ..................2-82
Sunshade .....................2-75
Operation ...................2-75
Sun visors .....................3-17
Supplemental Restraint System ........1-38
Overview ....................0-2
Supplemental Restraint System (SRS) .....0-2
Air bags .....................0-2
Switches .....................2-69
Brightness...................2-69
Defroster ....................2-61
Foglights...................2-69
Front passenger air bag ...........1-47
Hazard warning

flasher............6-2
Headlight ...................2-63
Ignition .....................5-15
Ignition positions ...............5-15
Parkingbrake.................5-25
Parking sensor system ............5-79
Power door lock ................3-6
Seat ......................3-20
Seat adjustment ................1-4
Turn signal ..................2-65
Windshield de-icer ..............2-62
Wiperandwasher ..............2-59
Tachometer .....................2-5 Three-way catalyst
.................5-4
Precautions ...................5-4
Tire chains ....................8-31
Tires ........................8-32
Changing ...................8-32
Cold weather .................5-94
Equipment...................5-94
Flat tire .....................6-2
Inflation pressure ...............8-26
Placard ....................10-11
Quality grading ................10-16
Sizes......................10-8
tire chains ...................8-31
Wear and damage ..............8-31
Wheelbalance ................8-34
Wheels and tires ............8-26,10-8
Touchpanel ....................4-5 Operation....................4-5
Towing.......................6-14 Recommendations ..............6-14
Your vehicle ..................6-14
Trailer.......................10-15 Towing ....................10-15
Transferring registration to another country. .10-9
Transmission ...................5-18
Automatic Transmission (AT) operation . . .5-18
Automatic transmission fluid (ATF) ......8-7
Traveling .....................10-9
Turn signal ....................8-22
Bulb information ...............8-22
Operation...................8-22
11-6Index