light ISUZU KB P190 2007 Workshop Repair Manual

ELECTRICAL-BODY AND CHASSIS 8A-367

Connector No. B24 SOUTH
AFRICA SAUDI
ARABIA ISRAEL EUROPE OTHER
Terminal Connector place
4JJ1-TC HFV6 4JA1T(L) HFV6 4JJ1-TC HFV6 RHD LHD G.EXP
RHD 4JJ1-TC
C24SE
AUSTRALIAHFV6AUSTRALIA
1 Signal ground
2 SRS ground
3 A/T shift indicator
“3” ―
4 A/T shift indicator
“D” ―
5 A/T shift indicator
“N” ―
6 A/T shift indicator
“R” ―
7 A/T shift indicator
“P” ―
8 Ignition
9 Ambient
temperature sensor ―
10 RR fog light
― ― ― ― ― ―
―
― ― ―
11 FRT fog light
― ― ― ― ―
― ―
12 A/T shift indicator
“2” ―
13 A/T shift indicator
“L” ―
14 Turn signal - RH
15 Door SW - driver
16 Power source




BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-369
Low Fuel Indicator Light
1. Disconnect the fuel gauge unit wire connector.
2. Turn the key switch on. Check that the bulb lights.
If operation is not correct, remove and check the bulb or circuit.
or If check whether low fuel turns on fuel input (B-24) at the
time of open and key on.
∗ meter is check at low fuel



RTW 78ASH001501




Check level sensor operation
1. Remove the fuel gauge unit.
2. Apply battery voltage between terminal (B) and (C) through a 1.12 watt bulb. Check that the bulb lights.
Note:
It will take a short time for the bulb light.
3. Submerge the sensor in fuel. Check that the bulb goes out.
If operation is not correct, replace the fuel tank unit.

BRAKE SYSTEM WARNING LIGHT
The brake system warning light comes on while the parking
brake is set and the engine run position.

RTW 48AMH000101


Note:
The parking brake indicator light circuit is designed to
prevent driving of the vehicle with the parking brake on.
It does not indicate the condition of the parking brake
system.

The parking brake switch is in parallel with the brake fluid
switch.


The brake system warning light also comes on when reservoir
brake fluid level falls below the specified limit with the parking
brake released and the engine run position.

BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-440 ELECTRICAL-BODY AND CHASSIS
AUDIO, CLOCK AND CIGARETTE LIGHTER
PARTS LOCATION (RHD)







RTW 78AXF039701 & RTW 78AXF045901

BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

8A-462 ELECTRICAL-BODY AND CHASSIS
TROUBLESHOOTING
CIGARETTE LIGHTER
1. Lighter does not pop out after being pushed in. It does not become hot.

Checkpoint Trouble Cause Countermeasure


Reinstall or replace the fuse
No. C12 (20A)

Poor Fuse No. C-12 (20A,
Fuse box) contact or blown

NG


Replace the lighter

Lighter continuity between
center part and outer area

Open circuit or poor connector
contact


Repair open circuit or
connector contact
Voltage between connector 1

B21 and the ground at
starter SW . is ACC position
(Should be battery voltage
present)

Open circuit or poor connector
contact

NG
NG
OK
OK
OK

Audio system (System should
receive power)


Repair open circuit or
connector contact

Open circuit or poor connector
contact

NG
Continuity between connector
1
B22 and the ground



2. Lighter pops out prematurely before becoming hot

Repair or replace the lighter
and/or casingDeformed lighter or casing
NGLighter and casing



3. Lighter becomes too hot

Repair or replace the lighter
and/or casingDeformed lighter and casing
NGLighter and casing



BACK TO CHAPTER INDEX
TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-463
REMOVAL AND INSTALLATION



AUDIO
Refer to Section 9 “ACCESSORIES” for details.


RTW 780SH001801
CIGARETTE LIGHTER
Removal
1. Disconnect the battery ground cable.
2. Remove the center cluster ASM.
3. Remove the lighter
1.
4. Disconnect the connector
2.
5. Loosen the ring nut
3 at the back side.
6. Remove the outer case
4.
7. Remove the lighter holder
5 from the bezel.




Installation
Follow the removal procedure in the reverse order to install the
lighter.
Pay close attention to the important points mentioned in the
following paragraphs.



Connector
Be absolutely sure that the lighter connector is securely
connected.
This will prevent a poor contact and an open circuit.



RTW 780SH001901
ACC SOCKET
Removal
1. Disconnect the battery ground cable.
2. Remove the center cluster ASM.
3. Disconnect the connector.
4. Remove the holder nut
1.
5. Remove the ACC Socket
2

Installation
Follow the removal procedure in the reverse order to install the
lighter.



BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-547
Pin-outs









RUW 580SF000301

No. Pin Function
1 Door ajar switch
2 Door ajar indicator light
3 Tailgate switch
4 Test pin (Internal use only)
5 Key switch remote
6 Ignition switch
7 Battery
8 Hazard battery
9 Unlock
10 Lock
11 Front map light
12 Hazard-RH
13 Hazard-LH
14 Ground

BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-552 ELECTRICAL-BODY AND CHASSIS
ID Code Check
Numbers of registered ID code shall be checked in this
mode.

Step Action Yes No
1 NOTE: Make sure that the all the doors are closed.
Is the action complete? Go to Step 2 
2 Insert the ignition key into the key lock twice, and then re-
inserted.
NOTE: This step must be carried out within five seconds.
Count the number of times the hazard lights flash on and off.
This number is equal to the number of registrations.
Is the action complete? Go to Step 1 Go to Step 1




RUW 59DLF000101


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-585

RTW 38DSH001701
Turn Signal Test
Check the turn signal lamp lights up by operation of
Tech-2.
1. Turn the key “OFF”.
2. Turn the key “ON”.
3. Check the display and test menu.
4. Operate the Tech-2.


060R200289
Programming
Erase Remove Key
To erase remove control key code in the control unit.
1. Check the display of Tech-2 and press “Confirm”
key.
RTW 38DSH001001
2. Enter security code.
3. Press “Not Okay” or “Okay” key.

BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

8A-606 ELECTRICAL-BODY AND CHASSIS

CONNECTOR LIST
No. Connector face No. Connector face
B1

~
B6 NOT USED B16
(
HFV6
4JH1-TC
)

White
Hazard switch
B7


Black
Rear defogger relay B16
(4JJ1-TC
4JA1T-(L))
Gray Hazard switch
B8


Black
Power window relay B17

~
B19 NOT USED
B9



NOT USED B20



White
Cigar lighter illumination
B10


White
Clock B21



WhiteCigar lighter-1
B11


White
Ash tray illumination B22



BlackCigar lighter-2
B12


NOT USED B23



White
Meter-A
B13


White
Fan switch B24



WhiteMeter-B
B14


Gray
Audio B25

~
B27 NOT USED
B15



NOT USED B28



Silver
Dash side-RH


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007

ELECTRICAL-BODY AND CHASSIS 8A-607


No. Connector face No. Connector face
B29

~
B30 NOT USED B43



Black
Anti theft control unit (A)
B31


Yellow
SRS control unit B44



BlackAnti theft control unit (B)
B32


NOT USED B45



NOT USED
B33



White
Illumination control B46



WhiteRear defogger timer
B34


NOT USED B47



White
Glove box illumination
B35


Yellow
Infrator; passenger side B48



BlackG sensor
B36


Yellow
Infrator; driver side B49



NOT USED
B37

~
B40 NOT USED B50



White
Power/3rd start switch
B41


White
Acc socket B51



WhiteHeadlight levering switch
B42


White
Acc socket B52



BlackAnti theft indicator


BACK TO CHAPTER INDEX TO MODEL INDEXISUZU KB P190 2007