brake sensor ISUZU TF SERIES 2004 User Guide
[x] Cancel search | Manufacturer: ISUZU, Model Year: 2004, Model line: TF SERIES, Model: ISUZU TF SERIES 2004Pages: 4264, PDF Size: 72.63 MB
Page 267 of 4264
FRONT WHEEL DRIVE 4C1-47
Important Operations
1. Wheel Pin
(1) Place hub on a wood workbench or a block of wood,
approx. 6” by 6” to protect the wheel stud ends and threads.
(2) Install wheel stud using a hammer.
Be sure wheel stud is started squarely and seats
completely.
(3) Align index marks and install hub to disc.
2. Bolt
Torque N
m (kgf
m/lb
ft)
103
10 (10.5
1/75.9
7.2)
3. ABS sensor rotor
(1) Set a new ABS sensor rotor, if replacement is required.
(2) Install the ABS sensor rotor in the hub, using special tools.
Installer : 5-8840-2789-0
Grip : 5-8840-0007-0
Refer to the section Brake.
4. Inner Bearing and Outer Race
5. Oil Seal
Outer Bearing Outer Race
(1) Install the bearing outer race by driving into the hub.
Installer (Outer) : 5-8822-0053-0 (J-29016)
Installer (Inner) : 5-8822-0054-0 (J-29015)
Drive handle : 5-8840-0007-0 (J-8092)
Page 271 of 4264
FRONT WHEEL DRIVE 4C1-51
Important Operations
6. Hub nut
Wrench : 5-8840-2117-0
(J-36827)
7. Hub and disc assembly
Before disassembly, remove the disc brake caliper assembly
and hang it on the frame with wires.
Refer to Section “Brake” for disc brake caliper removal
procedure.
12. Bolt
13. Wheel Pin ; Front Hub
(1) Scribe mark on hub to disc before disassembly to insure
proper assembly.
(2) Drive out the ABS sensor rotor using a metal bar and
hammer through the two bolt holes.
Discard the used ABS sensor rotor
Refer to the section Brake.
(3) Clamp hub and disc assembly in vise using protective pads
and remove six (6) disc to hub retaining bolts.
(4) Place hub on a suitable work surface and remove wheel
studs, as required, using a hammer.
Page 272 of 4264
4C1-52 FRONT WHEEL DRIVE
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage or any other abnormal conditions are found
through inspection.
For inspection and servicing of disc caliper, and relative parts, and ABS parts, refer to Section Brakes.
Hub
Hub bearing, oil seal
Knuckle spindle
Disc
Caliper
ABS sensor rotor
Cap, Hub flange, Shim, Snap ring
Visual Check
Check the following parts for wear, damage or other abnormal
conditions.
Page 274 of 4264
4C1-54 FRONT WHEEL DRIVE
Important Operations
1. Wheel Pin
(1) Place hub on a wood workbench or a block of wood,
approx. 6” by 6” to protect the wheel stud ends and threads.
(2) Install wheel stud using a hammer.
Be sure wheel stud is started squarely and seats
completely.
(3) Align index marks and install hub to disc.
2. Bolt
Torque N
m (kgf
m/lb
ft)
103
10 (10.5
1/75.9
7.2)
3. ABS sensor rotor
(1) Set a new ABS sensor rotor, if replacement is required.
(2) Install the ABS sensor rotor in the hub, using special tools.
Installer : 5-8840-2789-0
Grip : 5-8840-0007-0
Refer to the section Brake.
4. Inner Bearing
Outer race ; outer bearing
Install the outer race by driving it into the hub.
Installer : 5-8840-2119-0
(J-36829)
Grip : 5-8840-0007-0
(J-8092)
Page 279 of 4264
FRONT WHEEL DRIVE 4C1-59
12. Bolt
13. Wheel Pin ; Front Hub
(1) Scribe mark on hub to disc before disassembly to insure
proper assembly.
(2) Drive out the ABS sensor rotor using a metal bar and
hammer through the two bolt holes.
Discard the used ABS sensor rotor
Refer to the section Brake.
(3) Clamp hub and disc assembly in vise using protective pads
and remove six (6) disc to hub retaining bolts.
(4) Place hub on a suitable work surface and remove wheel
studs, as required, using a hammer.
Page 280 of 4264
4C1-60 FRONT WHEEL DRIVE
INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage or any other abnormal conditions are found
through inspection.
For inspection and servicing of disc caliper, and relative parts, and ABS parts, refer to Section Brakes.
Hub
Hub bearing, oil seal
Knuckle spindle
Disc
Caliper
ABS sensor rotor
Cap, Hub flange, Shim, Snap ring
Free wheeling hub parts (Option)
Clutch, Knob, follower, inner, ring and
spring
Visual Check
Check the following parts for wear, damage or other abnormal
conditions.
Page 283 of 4264
FRONT WHEEL DRIVE 4C1-63
13. Wheel Pin
(1) Place hub on a wood workbench or a block of wood,
approx. 6” by 6” to protect the wheel stud ends and threads.
(2) Install wheel stud using a hammer.
Be sure wheel stud is started squarely and seats
completely.
(3) Align index marks and install hub to disc.
14. Bolt
Torque N
m (kgf
m/lb
ft)
103
10 (10.5
1/75.9
7.2)
15. ABS sensor rotor
(1) Set a new ABS sensor rotor, if replacement is required.
(2) Install the ABS sensor rotor in the hub, using special tools.
Installer : 5-8840-2789-0
Grip : 5-8840-0007-0
Refer to the section Brake.
16. Inner Bearing
Outer race ; outer bearing
Install the outer race by driving it into the hub.
Installer : 5-8840-2119-0
(J-36829)
Grip : 5-8840-0007-0
(J-8092)
Page 317 of 4264
BRAKE CONTROL SYSTEM 5A-1
SECTION 5A
BRAKE CONTROL SYSTEM
CONTENTS
Service Precaution ............................................................................................................. 5A-4
General Description ........................................................................................................... 5A-5
EHCU, Brake Pipe Diagram .......................................................................................... 5A-6
Hydraulic Unit (H/U)....................................................................................................... 5A-7
Normal Braking ......................................................................................................... 5A-8
Pressure Isolation (Pressure Maintain) .................................................................. 5A-9
Pressure Reduction .................................................................................................. 5A-10
Brake Release ........................................................................................................... 5A-11
Circuit Diagram.............................................................................................................. 5A-12
Connector List ............................................................................................................... 5A-13
Part Location ................................................................................................................. 5A-15
EHCU Pin-outs ............................................................................................................... 5A-17
System Components ..................................................................................................... 5A-19
Electronic Hydraulic Control Unit (EHCU) .............................................................. 5A-19
ABS Warning Lamp .................................................................................................. 5A-19
Wheel Speed Sensor (WSS)..................................................................................... 5A-19
G-Sensor ................................................................................................................... 5A-19
Normal and Anti-lock Braking ................................................................................. 5A-19
Electronic Brake-force Distribution (EBD) System ................................................ 5A-20
Brake Pedal Travel.................................................................................................... 5A-20
Acronyms and Abbreviations ....................................................................................... 5A-20
General Diagnosis ............................................................................................................. 5A-20
General Information ...................................................................................................... 5A-20
ABS Service Precautions.............................................................................................. 5A-20
Computer System Service Precautions....................................................................... 5A-21
General Service Precautions........................................................................................ 5A-21
Note on Intermittents .................................................................................................... 5A-21
Test Driving ABS Complaint Vehicles ......................................................................... 5A-21
"ABS and Brake" Warning Lamp ................................................................................. 5A-22
Normal Operation .......................................................................................................... 5A-22
Page 318 of 4264
5A-2 BRAKE CONTROL SYSTEM
Brake (EBD) Warning Lamp.......................................................................................... 5A-22
Tech 2 Scan Tool ........................................................................................................... 5A-23
DATA LIST (Tech 2) ....................................................................................................... 5A-26
Actuator Test (Tech 2)................................................................................................... 5A-27
Diagnostic Trouble Codes................................................................................................. 5A-30
Diagnosis By "ABS" Warning Lamp Illumination Pattern .............................................. 5A-32
Basic Diagnostic Flow Chart ............................................................................................ 5A-35
Basic Inspection Procedure .............................................................................................. 5A-37
1. Basic Inspection of Service Brake ........................................................................... 5A-37
2. Ground Inspection .................................................................................................... 5A-37
Wheel Speed Sensor Inspection Procedure .................................................................... 5A-38
Symptom Diagnosis........................................................................................................... 5A-39
ABS Works Frequently But Vehicle Does Not Decelerate ......................................... 5A-39
Uneven Braking Occurs While ABS Works ................................................................. 5A-40
The Wheels Are Locked ................................................................................................ 5A-40
Brake Pedal Feed Is Abnormal ..................................................................................... 5A-41
Braking Sound (From EHCU) Is Heard
While Not Braking ....................................................................................................... 5A-42
No ABS Warning Lamp ................................................................................................. 5A-43
DTC C0221 (Flash Code 21) Front Right Wheel Speed Sensor
Short Circuit or Circuit Open ......................................................................................... 5A-44
DTC C0222 (Flash Code 22) Front Right Wheel Speed Sensor Incorrect Signal.......... 5A-46
DTC C0223 (Flash Code 23) Front Right Wheel Speed Sensor
Signal - Tooth Chipping................................................................................................... 5A-48
DTC C0225 (Flash Code 25) Front Left Wheel Speed Sensor Short Circuit or
Circuit Open .................................................................................................................... 5A-50
DTC C0226 (Flash Code 26) Front Left Wheel Speed Sensor Incorrect Signal ............ 5A-52
DTC C0227 (Flash Code 27) Front Left Wheel Speed Sensor Signal - Tooth
Chipping ........................................................................................................................... 5A-54
DTC C0231 (Flash Code 31) Rear Right Wheel Speed Sensor Short Circuit or
Circuit Open .................................................................................................................... 5A-56
DTC C0232 (Flash Code 32) Rear Right Wheel Speed Sensor Incorrect Signal ........... 5A-58
DTC C0233 (Flash Code 33) Rear Right Wheel Speed Sensor Signal - Tooth
Chipping ........................................................................................................................... 5A-60
Page 319 of 4264
BRAKE CONTROL SYSTEM 5A-3
DTC C0235 (Flash Code 35) Rear Left Wheel Speed Sensor Short Circuit or
Circuit Open .................................................................................................................... 5A-62
DTC C0236 (Flash Code 36) Rear Left Wheel Speed Sensor Incorrect Signal ............. 5A-64
DTC C0237 (Flash Code 37) Rear Left Wheel Speed Sensor Signal - Tooth
Chipping ........................................................................................................................... 5A-66
DTC C0238 (Flash Code 38) Tire Diameter Error ............................................................. 5A-68
DTC C0241 (Flash Code 41) Front Right Isolation Solenoid Circuit Open or
Shorted to Ground ........................................................................................................... 5A-69
DTC C0242 (Flash Code 42) Front Right Dump Solenoid Circuit Open or Shorted
to Ground.......................................................................................................................... 5A-69
DTC C0243 (Flash Code 43) Front Right Isolation Solenoid Circuit Shorted to
Battery............................................................................................................................... 5A-69
DTC C0244 (Flash Code 44) Front Right Dump Solenoid Circuit Shorted to
Battery............................................................................................................................... 5A-69
DTC C0245 (Flash Code 45) Front Left Isolation Solenoid Circuit Open or
Shorted to Ground ........................................................................................................... 5A-71
DTC C0246 (Flash Code 46) Front Left Dump Solenoid Circuit Open or Shorted
to Ground.......................................................................................................................... 5A-71
DTC C0247 (Flash Code 47) Front Left Isolation Solenoid Circuit Shorted to
Battery............................................................................................................................... 5A-71
DTC C0248 (Flash Code 48) Front Left Dump Solenoid Circuit Shorted to
Battery............................................................................................................................... 5A-71
DTC C0251 (Flash Code 51) Rear Isolation Solenoid Circuit Open or Shorted to
Ground .............................................................................................................................. 5A-73
DTC C0252 (Flash Code 52) Rear Dump Solenoid Circuit Open or Shorted to
Ground .............................................................................................................................. 5A-73
DTC C0253 (Flash Code 53) Rear Isolation Solenoid Circuit Shorted to Battery ......... 5A-73
DTC C0254 (Flash Code 54) Rear Dump Solenoid Circuit Shorted to Battery .............. 5A-73
DTC C0265 (Flash Code 65) Fail Safe Relay (FSR) Shorted to Ground ......................... 5A-75
DTC C0266 (Flash Code 66) Fail Safe Relay (FSR) Shorted to Battery.......................... 5A-75
DTC C0267 (Flash Code 67) ABS Motor Shorted to Ground .......................................... 5A-77
DTC C0268 (Flash Code 68) ABS Motor Shorted to Battery ........................................... 5A-77
DTC C0271 (Flash Code 71) ECU Failure or Valve +B Circuit Open .............................. 5A-79
DTC C0274 (Flash Code 74) ABS Operation Long Time ................................................. 5A-80
DTC C0276 (Flash Code 76) G-Sensor Malfunction ........................................................ 5A-82