c24se ISUZU TF SERIES 2004 Owner's Guide

ELECTRICAL-BODY AND CHASSIS 8A-65

C24SE / 6VE1 / 4JA1-L / 4JH1-TC (LHD)
















RTW48AXF004101

8A-66 ELECTRICAL-BODY AND CHASSIS
C24SE

8A-70 ELECTRICAL-BODY AND CHASSIS
C24SE / 6VE1 / 4A1-TC / 4JA1-TC / 4JH1-TC
RTW48AXF031801

8A-78 ELECTRICAL-BODY AND CHASSIS
CIRCUIT DIAGRAM C24SE (RHD)



RTW48AXF027301

ELECTRICAL-BODY AND CHASSIS 8A-83
CIRCUIT DIAGRAM C24SE (LHD)



RTW48AXF009001

ELECTRICAL-BODY AND CHASSIS 8A-91
PARTS LOCATION C24SE

8A-96 ELECTRICAL-BODY AND CHASSIS

CIRCUIT DIAGRAM C24SE Sheet 1/2



RTW48AXF027501

ELECTRICAL-BODY AND CHASSIS 8A-97

CIRCUIT DIAGRAM C24SE Sheet 2/2

RTW48AXF001301

ELECTRICAL-BODY AND CHASSIS 8A-105
REMOVAL AND INSTALLATION


ECM (ENGINE CONTROL MODULE):
C24SE

Removal
1. Lift both the ECM harness connector locking levers and
remove the two harness connectors form the ECM.
2. Remove the four socket head screws securing the ECM to
the mounting bracket.
3. Remove the ECM from the engine compartment
.


4. Pull out the ECM.
5. Disconnect both red and tan connectors.
Refer to the Section 6E-ENGINE of this Manual.
IMPORTANT: The replacement ECM must be programmed.
“SPS (Service Programming System) and immobiliser
programming (if equipped) is/are necessary”





Installation
Follow the removal procedure in the reverse order to install the
ECM.
Pay close attention to the important points mentioned in the
following paragraphs.



Connector
Be absolutely sure that ECM is securely connected.
This will prevent a poor contact and open circuit.

ELECTRICAL-BODY AND CHASSIS 8A-225
PARTS LOCATION C24SE