instrument panel JAGUAR XF 2012 1.G Quick Start Guide

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
3
Vehicle accessDriver controls
Emergency key access
If there is a problem with the Smart Key and it will not unlock the vehicle, use the emergency key access procedure. Press the Smart Key release button 1.Remove the key blade 2.
Insert the blade into the slot beneath the front left-hand door lock cover. Lift slightly and twist to remove the cover. Insert the key into the exposed lock and turn it towards the rear of the vehicle then release it to unlock.
If the vehicle security system was previously armed with the Smart Key, the alarm will sound. To disarm the alarm, press the START STOP button while the Smart Key is inside the vehicle.
Unlocking mode alternatives
Single-point entry allows only the driver’s door to unlock with a single press. A second press unlocks all other doors and the luggage area.
Multi-point entry will unlock all doors and luggage area with a single press.
To change between modes, with the vehicle unlocked, press the lock and unlock buttons simultaneously for three seconds. The hazard warning lamps will flash twice to confirm the change.
Trunk opening
With the vehicle unlocked, the luggage compartment can also be opened by pressing the release button under the chrome finisher at the rear of the vehicle.
Powerfold mirrors
Press buttons 31 simultaneously to fold the mirrors inward. Press again to unfold.
Jaguar Smart Key Jaguar Smart Key
Keyless entry/exit Keyless entry/exit
2
Press once to lock the vehicle and arm only the exterior (perimetric) alarm.
Multi-point entry - Press once to disarm the alarm, unlock all doors and unlock the luggage compartment.
Press once to switch the headlamps on for 25 seconds. Press again to switch off.
Press to open only the luggage compartment. The rest of the security system remains active.
Press and hold for three seconds to activate/cancel the panic alarm.1
2
To unlock the vehicle and disarm the alarm, simply press a door handle button or luggage compartment release button while the Smart Key is within 3 ft (1 metre) of the vehicle.
To lock the vehicle and arm the alarm, first ensure that the Smart Key is outside the vehicle but within 3 ft (1 metre).
Press a door handle button once to single lock. Press it twice within three seconds to double lock.
Rear seat release handles
The split fold rear seats have release handles located in the luggage compartment. Pull to release one or both seat backs and fold forward. Head restraints can be removed if required.
412567
15
19
20
21
22
23
1716
18
2425
29
28
27
26
30
31
32
33
3
891110121314
Turn signals and headlamp control1.
Gearshift down2.
Audio and phone switches3.
Instrument panel, message centre and warning lamps4.
Cruise control switches5.
Gearshift up6.
Wiper/washers7.
Central locking/unlocking8.
Touch screen on/off9.
Touch screen10.
Hazard warning lamps on/off11.
Navigation menu 12.
Phone menu13.
Home menu14.
Climate controls15.
JaguarDrive selector16.
Stability control (DSC) 17.
Speed limiter (ASL)18.
Parking brake 19.
Dynamic mode 20.
Winter mode21.
STOP/START22.
Audio controls23.
Horn/air bag24.
Steering column adjuster25.
Instrument illumination26.
Fog lamps on/off27.
Trunk release28.
Forward alert29.
Mirror controls30.
Powerfold mirror controls31.
Window controls32.
Rear window isolator33.
Care point
The Smart Key may not be detected if it is placed within a metal container or if it is shielded by a device with a back lit LCD screen, (e.g. laptop, smartphone etc.) Keep the Smart Key clear of such devices when attempting Keyless entry or Keyless starting.
Do not leave your Jaguar Smart Key within the luggage compartment, the vehicle WILL NOT automatically unlock (should it become shielded).

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
Setting the driving position Setting the driving position See page 3, items See page 3, items 25, 30 25, 30 and 31and 31and Engine start/stop Engine start/stop See page 3, item See page 3, item 22
Transmission See page 3, items See page 3, items 2, 6 2, 6 and 16and 16and
Restraints
Comfort adjustmentsStarting and driving
5
4
Driver’s seat
Set the seat position using the following controls.
Cushion length.1.
Side bolster - inflate.2.
Side bolster - deflate.3.
Lumber support.4.
Seat back angle and head restraint.5.
Seat forwards and back, cushion height and cushion 6. angle.
Note:Seat heater controls are accessed via the touch screen.
Steering column
With the vehicle stationary, adjust the steering column 7. to your ideal driving position.
Door mirrors
1. Press the left or right mirror selector.
2. Use the mirror adjuster to set mirror position.
Storing the driving position to memory
Once you have adjusted the driver’s seat, steering column and door mirrors for your ideal driving position, the settings can be stored.
8. Press the SET button to activate the memory store function. The button will illuminate to indicate the memory store function is active.
9. Within 5 seconds, press button 1 or 2 to store the current driving position.
A stored memory position can now be recalled with a press of the appropriate button; 1 or 2. The seat, steering wheel and mirrors will move to their preset positions.
Operating note
Memory buttons must be pressed within five seconds after pressing the SET button otherwise the memory store function will cancel.
Operating note
The engine will continue to run even if the Smart Key is removed from the vehicle by more than 3ft (1 metre). However, if the engine is stopped, it cannot be restarted until the Smart Key is returned to the vehicle.
Operating note
If the engine is switched off with Neutral selected, automatic selection of P is delayed for 10 minutes. DONOTuse this feature to enable towing of the vehicle. Refer to Vehicle recovery in the Owner’s Handbook.A warning indicator on the instrument panel will illuminate if the seat belt of an occupied front seat is not fastened. This may be accompanied by an audible warning.
Using child seats
Refer to Child Seats in the Owner’s Handbook to determine the correct seat for your child.
If it becomes necessary to fit a child restraint on the front passenger seat, make the following seat adjustments.
Move the seat fully rearward.•
Lumber support to minimum setting.•
Seat cushion to highest position.•
Cushion front tilt to lowest position.•
Seat back to upright position.•
Adjust the upper seat belt anchorage to its lowest • position.
Ignition on:
With the Jaguar Smart Key inside the vehicle, press • the START/STOP button to switch on ignition.
A second press will switch off the ignition.•
Engine start
The selector lever must be in • Park or Neutral position to enable engine starting.
With the foot brake depressed, press and release the • START/STOP button to start the engine.
Press again to stop the engine and switch off the • ignition.

Rolling start
If the engine is switched off while the vehicle is moving, it can be restarted by selecting N position then pressing the START/STOP button.
Gearshift interlock
The brake pedal must be depressed before the selector can be moved from the Park position. Maintain brake pressure until a gear is selected.
Select P before switching off the engine. However, if the engine is switched off with Reverse, Drive or Sport selected, the selector will automatically return to P while retracting.
Automatic gear selection
Select D for fully automatic gear changes.
Sport mode
This is an automatic gear change mode, however, change points are modified to make full use of engine power.
Press the selector down and rotate from D to Sport.
Manual gear changes
Manual gear change mode is effective when rapid acceleration and engine braking are required.
To shift down, briefly pull the left-hand paddle.•
To shift up, briefly pull the right-hand paddle.•
P R N D S
STARTENGINESTOP
DSC
5432
1
6
8
7
9
Supercharged vehicles: When the paddles are used in D, gear selection will revert to automatic if use of the paddles is not maintained. With Sselected, continuous manual operation is initiated if the paddles are used.
Non Supercharged vehicles: Manual gear selection is only available in S.
Note:To return to automatic operation pull and hold the right-hand paddle for two seconds.
JJM189640121.indd 4-5JJM189640121.indd 4-5JJM189640121.indd 4-521/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:3721/03/2011 13:48:37

JAGUAR XF JAGUAR XF JAGUAR XF
JAGUAR XF JAGUAR XF JAGUAR XF
Warning lamps Warning lamps Displayed on the instrument panelDisplayed on the instrument panel
Electric parking brake Electric parking brake See page 3, item See page 3, item 19
Auto headlamps and wipers Auto headlamps and wipers See page 3, items See page 3, items 1 and 7and 7and
Starting and driving
6
Releasing
With the ignition on, apply the foot brake and press • down on the parking brake lever.
If the vehicle is stationary with the parking brake • applied and either Drive or Reverse selected, pressing the accelerator will automatically release the parking brake.
Note:Do NOT use the recess in the electric parking brake as a storage area.
Cruise control and forward alert See page 3, items See page 3, items 5 and 29and 29and
Starting and driving
7
Braking system fault or brake fluid low
Braking system fault or brake fluid low. USA only
Dynamic stability control. Flashes when DSC is operating
DSC switched off, Trac DSC on
Automatic speed limiter active
Seat belt reminder
Low tire pressure
Anti-lock braking system fault.
Anti-lock braking system fault. USA only
Engine malfunction
Applying
With the vehicle stationary, lift up the parking brake • lever and then release it. The red warning indicator in the instrument panel will illuminate.
Operating note
The brake must be manually applied when parking.
Cruise control override
Cruise control disengages when brakes are applied or when speed is below 18mph (30 km/h).
Auto high beam
1. When AUTO is selected on the lighting control the side lamps and headlamps will turn on automatically when ambient light fades. With the control in the low beam position, high beam will activate automatically when ambient light falls below a pre set level. Vehicle speed must be above 25 mph (40 km/h).
Exit delay
2, 3, 4. The headlamps can be set to temporarily light your way when you exit the car at night. Rotate the control for exit delay periods of 30 seconds, 60 seconds or 120 seconds.
1
432
MAX
MIN
MAX
MIN
6
5
7
Auto wipers
Automatic wipers are activated by a rain sensor. When the wiper control is moved up to the first position the wipers will operate automatically as required. Sensitivity can be adjusted.
5. First stop for auto position.
6. Rain sensor maximum sensitivity.
7. Rain sensor minimum sensitivity.
Setting cruise control speed
Use to set cruise speed or increase/decrease 1. speed while cruise control is operating.
Resumes the set speed after a cancellation.2.
Cancels current setting but retains in memory.3.
automatically slow down and then maintain your set gap until the road ahead clears. At that point your vehicle will accelerate to the set cruise control speed.
ACC gap setting
4. Press to increase or decrease the set gap to the vehicle ahead. An amber warning icon will illuminate in the instrument panel. The message centre will display the current set gap. There are four gap settings to choose from.
Forward alert
An additional feature of ACC, forward alert provides limited detection of objects in the road ahead. When necessary it will give an audible warning plus the visual warning FORWARDALERT in the message centre. The driver must take appropriate action.
5. Press to activate the Forward Alert function.
The Forward Alert icon will illuminate in the instrument panel.
Sensitivity of detection can be adjusted. With ACC disengaged, use the GAP SETTING control 4 to adjust the setting.
Adaptive cruise control (ACC)
ACC can be programmed to maintain a set gap to the vehicle ahead. If the vehicle ahead is travelling slower than your set cruise control speed, your vehicle will
Driver intervention
ACC IS NOT a collision warning or avoidance system. Additionally the system WILLNOT detect:
Stationary or slow moving vehicles below • 6 mph (10 km/h).
Pedestrians or objects in the roadway.•
Oncoming vehicles in the same lane.•
Automatic car wash
Before entering an automatic car wash, turn the wipers off to deactivate the rain sensor. Otherwise, the wipers will operate during the washing process and may be damaged.
4
32
1
5
Air bag fault
Rear fog lamp on
Forward alert active
Adaptive cruise control active
Automatic speed limiter (ASL) Automatic speed limiter (ASL) See page 3, item See page 3, item 18
ASL allows any speed between 30 km/h and 240 km/h (18 to 150 mph) to be set as a maximum speed. This is useful to ensure any given speed limit is not exceeded.
Setting a speed
The setting procedure can be made while the vehicle is stationary.
Press the 1.ASL button. An ASL warning lamp illuminates in the instrument panel.
Use the cruise control + and - 2.controls to set a speed. The message centre will display the set speed. Adjustment can be made at any time to suit variable speed limits.
If ASL is cancelled due to kick down acceleration or by pressing the cruise control CANCEL, the message centre will display a ‘LIMITERCANCELLED’ message.
Press the RESUME control to reinstate the ASL set speed.
ASL
Driver intervention
When negotiating a steep downhill gradient, vehicle speed may exceed the set speed. The message centre will display a warning.