JEEP COMMANDER 2010 1.G Owners Manual

JEEP COMMANDER 2010 1.G Owners Manual COMMANDER 2010 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7066/w960_7066-0.png JEEP COMMANDER 2010 1.G Owners Manual
Trending: coolant level, fuel additives, service indicator, radiator, transmission fluid, length, snow chains

Page 341 of 460

JEEP COMMANDER 2010 1.G Owners Manual WHAT TO DO IN EMERGENCIES
CONTENTS
Hazard Warning Flashers ................ 342
 If Your Engine Overheats ................ 342
 Jacking And Tire Changing ............... 343
▫ Jack Location .....

Page 342 of 460

JEEP COMMANDER 2010 1.G Owners Manual HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on the
switch bank just above the climate controls.Press the switch to turn on the Hazard Warning
flasher. When the switch is activ

Page 343 of 460

JEEP COMMANDER 2010 1.G Owners Manual NOTE:There are steps that you can take to slow down
an impending overheat condition:
•If your air conditioner (A/C) is on, turn it off. The A/C
system adds heat to the engine cooling system and
turn

Page 344 of 460

JEEP COMMANDER 2010 1.G Owners Manual Jack Location
The scissor-type jack and tire changing tools are located
in a compartment behind the third row seat. Refer to
“Cargo Area Features” in Section 3 for further informa-
tion.
Spare Tir

Page 345 of 460

JEEP COMMANDER 2010 1.G Owners Manual Spare Tire Removal
Fit the jack handle extension over the drive nut. Use the
lug wrench to rotate the nut counterclockwise until the
spare is on the ground with enough slack in the cable to
allow pull

Page 346 of 460

JEEP COMMANDER 2010 1.G Owners Manual WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid being hit when operating the jack
or changing the wheel.
2. Set the p

Page 347 of 460

JEEP COMMANDER 2010 1.G Owners Manual WARNING! (Continued)
•Never start or run the engine with the vehicle on a
jack.
•Do not let anyone sit in the vehicle when it is on a
jack.
•Do not get under the vehicle when it is on a jack.

Page 348 of 460

JEEP COMMANDER 2010 1.G Owners Manual 4. Locate the jack as shown. For the front axle, place it
under the front lower control arm.Do not raise the
vehicle until you are sure the jack is fully engaged. For the rear axle, place it under the

Page 349 of 460

JEEP COMMANDER 2010 1.G Owners Manual 5. Raise the vehicle by turning the jack screw clockwise.
Raise the vehicle only until the tire just clears the surface
and enough clearance is obtained to install the spare tire.
Minimum tire lift pr

Page 350 of 460

JEEP COMMANDER 2010 1.G Owners Manual 9. Finish tightening the lug nuts. Push down on the
wrench while tightening for increased leverage. Alternate
nuts until each nut has been tightened twice. The correct
wheel nut tightness is 95 ft lbs
Trending: engine oil, clock, roof, mileage, horn, check oil, hood release