4WD JEEP COMPASS 2019 Owner handbook (in English)

The suggested Four Wheel Drive (4WD) Tire
rotation method is the “rearward cross”
shown in the following diagram.
CAUTION!
Proper operation of four-wheel drive ve-
hicles depends on tires of equal size, type
and circumference on each wheel. Any
difference in tire size can cause damage to
the power transfer unit. Tire rotation
schedule should be followed to balance
tire wear.
STORING THE VEHICLE
If the vehicle should remain stationary for
more than a month, observe the following
precautions:
• Park your vehicle in a covered, dry and
possibly airy location the windows open
slightly.
• Check that the Electric Park Brake is not
engaged.
• Disconnect the negative (-) terminal from
the battery post and be sure that the battery
is fully charged. During storage check bat-
tery charge quarterly.
• If you do not disconnect the battery from
the electrical system, check the battery
charge every 30 days.
• Clean and protect the painted parts by
applying protective waxes.
• Clean and protect polished metal parts by
applying protective waxes.
• Apply talcum powder to the front and rear
wiper blades and leave raised from the
glass.• Cover the vehicle with an appropriate cover
taking care not to damage the painted sur-
face by dragging across dirty surfaces. Do
not use plastic sheeting which will not allow
the evaporation of moisture present on the
surface of the vehicle.
• Inflate the tires at a pressure of +7.25 psi
(+0.5 bar) higher than recommended on
the tire placard and check it periodically.
• Do not drain the engine cooling system.
• Whenever you leave the vehicle stationary
for two weeks or more, idle the engine for
approximately five minutes, with the air
conditioning system on and high fan speed.
This will ensure proper lubrication of the
system, thus minimizing the possibility of
damage to the compressor when the vehicle
is put back into operation.
NOTE:
When the vehicle has not been started or
driven for at least 30 days, an Extended Park
Start Procedure is required to start the ve-
hicle.
Refer to “Starting The Engine” in “Starting
And Operating” for further information.
Four Wheel Drive (4WD) Tire Rotation
259

WEIGHTS
Mass Parameters
Axle Load / lbs (kg) (GAWR)
Curb Mass
/ lbs (kg)Allowable
Maximum Gross
Mass / lbs (kg)
(GVWR)Maximum
Allowable Mass
of the
Combination
(vehicle + trailer)
/ lbs (kg)Max Payload
/ lbs (kg)Max Roof Load
/ lbs (kg)
Front Axle Rear Axle
1.6 Multijet
120HP MTX
FWD2,399 (1,088) 2,260 (1,025) 3,395 (1,540) 4,599 (2,086) 6,803 (3,086) 1203.7 (546) 150 (68)
2.0 Multijet
140HP MTX
AWD2,599 (1,179) 2,423 (1,099) 3,627 (1,645) 4,824 (2,188) 9,012 (4,088) 1197.1 (543) 150 (68)
2.0 Multijet
140HP ATX
AWD2,599 (1,179) 2,423 (1,099) 3,660 (1,660) 4,824 (2,188) 8,131 (3,688) 1164.0 (528) 150 (68)
2.0 Multijet
170HP ATX
4WD (TRAIL-
HAWK)2,599 (1,179) 2,423 (1,099) 3,825 (1,735) 4,923 (2,233) 8,230 (3,733) 1097.9 (498) 150 (68)
1.4 Mair2
140HP MTX
FWD2,370 (1,075) 2,075 (941) 3,153 (1,430) 4,275 (1,939) 6,479 (2,939) 1122.2 (509) 150 (68)
1.4 Mair2
170HP ATX
AWD2,599 (1,179) 2,379 (1,079) 3,395 (1,540) 4,599 (2,086) 6,803 (3,086) 1203.7 (546) 150 (68)
TECHNICAL SPECIFICATIONS
268

Chassis
Component Fluid, Lubricant, or Genuine Part
Manual Transmission – If Equipped We recommend you use TUTELA TRANSMISSION GEARFORCE Fluid, or equivalent, meeting the
requirement of FCA Material Standard 9.55550-MZ6 or MS.90030-M1.
Automatic Transmission 6 Speed
(FWD Models) – If EquippedUse only TUTELA TRANSMISSION GI/VI Fluid, or equivalent, meeting the requirement of FCA Material
Standard 9.55550-AV2. Failure to use the correct fluid may affect the function or performance of your
transmission.
Automatic Transmission 9 Speed
(4WD Models) – If EquippedUse only TUTELA TRANSMISSION AS8 Fluid, or equivalent, meeting the requirements of FCA Material
Standard 9.55550-AV5 or MS.90030-A5. Failure to use the correct fluid may affect the function or
performance of your transmission.
Power Transfer Unit (PTU) –
If Equipped
We recommended you use TUTELA TRANSMISSION B-5X Fluid, or equivalent, SAE 75W-90 (API GL-5)
meeting the requirement of FCA Material Standard 9.55550-DA6.
Rear Differential (RDM) –
If EquippedWe recommended you use TUTELA TRANSMISSION COMPAQ DRIVE Fluid, or equivalent,
SAE 75W-90 (API GL-5) meeting the requirement of FCA Material Standard 9.55550-DA7.
Brake Master Cylinder We recommend you use TUTELA TOP4/S, FMVSS no. 116 DOT 4, ISO 4925 SAE J1704.
If DOT 4 brake fluid is not available then DOT 3, SAE J1703 brake fluid, or equivalent, is acceptable.
If using DOT 4 brake fluid, the fluid must be changed every 24 months regardless of mileage.
RefrigerantRefrigerant R134a — If Equipped
Charge Amount:
All engines — 567g (1.25 lb)
Refrigerant R-1234yf — If Equipped
Charge Amount:
All engines — 482 g (1.063 lb)
Compressor Oil Use Only PAG Oil PSD1:
1.4L Gasoline engines — 120ml (4.1 fl oz)
Use Only PAG Oil ND12:
1.6L Diesel engines — 90 ml (3.0 fl oz)
2.0L Diesel engines — 90 ml (3.0 fl oz)
279