Heat JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual LIBERTY 2002 KJ / 1.G JEEP JEEP https://www.carmanualsonline.info/img/16/7176/w960_7176-0.png JEEP LIBERTY 2002 KJ / 1.G Workshop Manual

Page 3 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual GROUP TAB LOCATOR
Introduction
0Lubrication & Maintenance
2Suspension
2SSuspension
3Differential & Driveline
5Brakes
5SBrakes
6Clutch
7Cooling
7SCooling
8AAudio
8BChime/Buzzer
8EElectronic Control Mod

Page 15 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual odor that may change with age. Consequently, odor
and color cannot be used to indicate the fluid condi-
tion or the need for a fluid change.
FLUID ADDITIVES
DaimlerChrysler strongly recommends against

Page 16 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual centage of antifreeze can cause the engine to over-
heat because specific heat of antifreeze is lower than
that of water.
CAUTION: Richer antifreeze mixtures cannot be
measured with normal field equip

Page 18 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual JUMP STARTING
STANDARD PROCEDURE - JUMP STARTING
PROCEDURE
WARNING: REVIEW ALL SAFETY PRECAUTIONS
AND WARNINGS IN GROUP 8A, BATTERY/START-
ING/CHARGING SYSTEMS DIAGNOSTICS.
²DO NOT JUMP START A FROZE

Page 23 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual WHEEL ALIGNMENT
TABLE OF CONTENTS
page page
WHEEL ALIGNMENT
DESCRIPTION..........................3
OPERATION............................3
STANDARD PROCEDURE
STANDARD PROCEDURE - HEIGHT
MEASUREMENT....

Page 40 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual UPPER BALL JOINT
REMOVAL
(1) Raise and support the vehicle.
(2) Support the rear axle with a hydraulic jack.
(3) Remove the ball joint pinch bolt from the top of
the axle. (Fig. 7)
(4) Seperate the ba

Page 41 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual INSTALLATION
(1) Position the upper suspension arm in the
frame rail brackets (Fig. 8).
(2) Install the mounting bolts and tighten to 100
N´m (74 ft. lbs.).
(3) Retighten the heat shield back into pl

Page 71 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual Condition Possible Causes Correction
Differential Cracked 1. Improper adjustment of the
differential bearings.1. Replace case and inspect gears
and bearings for further damage.
Set differential bearin

Page 102 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual Condition Possible Causes Correction
Loss Of Lubricant 1. Lubricant level too high. 1. Drain lubricant to the correct
level.
2. Worn axle shaft seals. 2. Replace seals.
3. Cracked differential housing

Page 139 of 1803

JEEP LIBERTY 2002 KJ / 1.G Workshop Manual Condition Possible Causes Correction
Loss Of Lubricant 1. Lubricant level too high. 1. Drain lubricant to the correct
level.
2. Worn axle shaft seals. 2. Replace seals.
3. Cracked differential housing
Page:   1-10 11-20 21-30 31-40 41-50 ... 300 next >