sensor KIA SORENTO 2014 Features and Functions Guide

SORENTO FEATURES & FUNCTIONS GUIDE6*IF EQUIPPED SORENTO FEATURES & FUNCTIONS GUIDE6
DRIVER’S PANELDRIVER’S PANELDRIVER’S PANEL
Hood Release Lever and LatchElectronic Stability Control (ESC)
The ESC system is designed to help stabilize the vehicle during cornering maneuvers
It is a good idea to keep the ESC turned on for daily driving whenever possible
Press ESC button A to turn ESC OFF/ON
REMINDER: ESC is turned ON at vehicle start-up
REMINDER: The ESC Indicator Light in the instrument cluster will be lit momentarily whenever the ESC is active
Opening the Hood:
1 Pull the Hood
Release Lever A
to unlatch the Hood







2 In the front of the vehicle, lift
the Hood slightly and pull the
secondary Latch B inside of
the Hood’s center
and lift the Hood







Closing the Hood:
Lower the Hood about halfway
and then press down to securely
lock in place When HAC is active (e g , during initial acceleration from a stop on an incline), you may notice that the brakes will momentarily remain engaged after you depress the accelerator
QUICK TIPS
Blind Spot Detection (BSD) System*
The system uses a radar sensor to help alert driver
while driving The BSD indicator on the button B
will illuminate when turned ON
The system will become active when the
vehicle is traveling more than 19 mph and
will alert the driver when another vehicle is
detected by the radar sensor
1st stage alert: When another vehicle is detected within the
BSD System boundary, a yellow light will illuminate on the
outside rearview mirrors
2nd stage alert: When 1st stage alert is on and a turn signal
is turned on or the hazard lights are on, an alarm will sound
Hillstart Assist Control (HAC)
HAC helps prevent the vehicle from rolling backwards when accelerating from
a stop while on a steep incline
The HAC automatically activates whether the ESC is OFF or ON but does NOT
activate when the ESC has malfunctioned
REMINDER: The HAC does not operate when the gear shift is in the P (Park) or the N (Neutral) position
A
B
X
X
X
AB
(button panel located lef t of Steering Wheel)

SORENTO FEATURES & FUNCTIONS GUIDE30*IF EQUIPPED
OTHER KEY FEATURES
•
• You can reprogram a single HomeLink ® button by repeating Step 2
• Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
The Auto-Dimming Rearview Mirror is designed to help
reduce glare from a vehicle’s headlights located in the
rear and also connect up to three electronic transmitters
in one location
To turn automatic dimming ON or OFF, press button F
HomeLink® with Auto-Dimming
Rearview Mirror*
How to Sync Transmitter with HomeLink®*
Erasing programmed buttons:
A HomeLink® button
B HomeLink® button
C Indicator light
D HomeLink® button
E Glare detection sensor
F Automatic dimming ON/OFF
G Compass control button
If programming for the first time, begin with Step 1
(repeating this step will delete all information)
To program non-rolling and rolling code garage door
openers and other devices:
1 Press and hold the left A and center D buttons
simultaneously until the indicator light C begins to
flash (to reprogram buttons, skip this step)
2 Press and hold the desired button A B D and hold
the button on the transmitter while it is approximately
1 to 3 inches away from the mirror The HomeLink®
Indicator light C will flash rapidly once the frequency
signal has been successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3 Locate the “learn” or “smart” button on the garage
door’s motor head unit Press and release the button
and complete Step 4 within 30 seconds
4 Firmly press and release the programmed HomeLink®
button up to three times
Press and hold the left A and center D buttons
simultaneously for approximately 20 seconds,
and then release both buttons within 30 seconds
Operating HomeLink®:
Press one of the programmed HomeLink® buttons REMINDER: Mirror indicator light C will illuminate when automatic dimming is ON
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink® system, you may need to purchase a HomeLink® Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515 .
ABCDEFG