tire pressure reset KIA SPORTAGE 2019 Features and Functions Guide

*IF EQUIPPED 7ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPER ATING INFORMATION AND SAFET Y WARNINGS
INSTRUMENT CLUSTER
Service Mode
To enter Service Mode, press the Mode button A and cycle
to Service Mode Then press the OK button C to enter
System will display tire pressure status, number of miles
remaining until next service is due, as well as the type of
service due
When service is required, the following will be displayed:
Service Required.
To reset the Service Mode system, press and hold the OK
button C for more than 1 second
To turn Service In OFF, go to User Settings
Service Interval Setting
To set the service interval in User
Settings mode:
• Press the Mode button A to
cycle to User Settings
•
If Service Interval is OFF, press the
OK button C to turn ON
•
Use the Move switch B to
select/change the interval setting
•
Press the OK button C to
select the interval
User Settings Modes:
Driving Assist*
• Rear Cross-Traf fic Collision Warning
• Forward Collision-Avoidance Assist (FCA)*
• Forward Collision Warning (FCW )*
Door/Liftgate
• Automatic Lock
• Automatic Unlock
• Two Press Unlock*
• Power Liftgate*
• Smart Liftgate*
Lights
• One-Touch Turn Signal
• Head Lamp Delay
• Welcome Light*
Sound
• Parking Distance Warning-Forward* and Reverse Volume*
• Blind-Spot Collision Warning Sound*
• Welcome Sound*
Service Interval
• ON/OFF
• Set mileage/months
Convenience
• Steering Position
• Wiper/Light Display*
Other Features
• Fuel Economy Auto Reset
• Fuel Economy Unit
• Temperature Unit
• Tire Pressure Unit*
Service in
Off
Service Required
-200mi -8days
Service in
1500mi 365days
To view these videos on your mobile device, snap these QR codes or visit the listed website
Refer to page 2 for more information
LCD Display Video
LCD Display: Maintenance Video
www.youtube.com/KiaFeatureVideos
www.youtube.com/KiaFeatureVideos
QR CODESUser Settings Mode
To enter the User Settings mode in the LCD Instrument
Cluster Modes, press the Mode button A when the
vehicle is at a standstill and with the Engine Start /Stop
button in the ON position and select User Settings
by pressing the Move button B up/down
You can navigate the selections on the display by
pressing the Move button B Select the item by
pressing the SET/RESET (OK ) button C
(Images are for illustration purposes only and may vary)