parking brake KIA STONIC 2018 Service Manual

Maintenance Under Severe Usage Conditions - For Diesel Engine [Except Europe (Including Russia)]
MAINTENANCE ITEMMAINTENANCEOPERATIONMAINTENANCE INTERVALSDRIVING CONDI‐TION
Engine oil and en‐ gine oil filter For Russia, Australiaand New Zealand
R Every 7,500 km (5,000 miles) or 6 months A, B, C, D, E, F, G,
H, I, J, K
Except Russia, Aus‐tralia and New Zea‐land R Every 5,000 km (3,000 miles) or 6 months
A, B, C, D, E, F, G,
H, I, J, K
Automatic transaxle fluid R Every 90,000 km (60,000 miles) A, C, D, E, F, G, H, I
Manual transaxle fluid R Every 120,000 km (80,000 miles) C, D, E, F, G, H, I, J
Drive shaft and boots I Inspect more frequently depending on the
condition C, D, E, F, G, H, I, J
Air cleaner filter R Replace more frequently depending on the
condition C, E
Climate control air filter R Replace more frequently depending on the
condition C, E, G
Brake discs and pads, calipers and rotors I Inspect more frequently depending on the
condition C, D, E, G, H
Brake drums and linings I Inspect more frequently depending on the
condition C, D, E, G, H
Parking brake IInspect more frequently depending on the
condition C, D, G, H
Steering gear rack, linkage and boots I Inspect more frequently depending on the
condition C, D, E, F, G


8-39
8
Maintenance

AUTOMATIC TRANSAXLE FLUID (IF EQUIPPED)
Checking the automatic
transaxle fluid level
The automatic transaxle fluid level
should be checked regularly.
Keep the vehicle on level ground with the parking brake applied and check the
fluid level according to the following
procedure. 1. Place the shift lever in N (Neutral) position and confirm if the engine is
running at normal idle speed.
NOTICE
Insert the level gauge, after checking
the automatic transaxle fluid level. In
the direction referred in the picture.
CAUTION
If you insert the level gauge in thewrong direction, it can cause defor‐mation (or damage) to level gauge.
2. After the transaxle is warmed up sufficiently [fluid temperature
70~80°C (158~176°F)], for example
by 10 minutes usual driving, move
the shift lever through all positions
then place the shift lever in N(Neu‐
tral) or P(Park) position.
)05
$0-%
3. Confirm if the fluid level is in the "HOT" range on the level gauge. If
the fluid level is lower, add the
specified fluid from the fill hole. If
the fluid level is higher, drain the
fluid from the drain hole.
4. If the fluid level is checked in cold condition [fluid temperature
20~30°C (68~86°F)], add the fluid to
the "COLD" line and then recheck the fluid level according to the
above step 2.

8-53
8
Maintenance

WARNING
nTransaxle fluid
The transaxle fluid level should bechecked when the engine is at nor‐mal operating temperature. Thismeans that the engine, radiator, ra‐diator hose and exhaust system etc.,are very hot. Exercise great care notto burn yourself during this proce‐dure.
CAUTION
•Low fluid level causes transaxleshift slippage. Overfilling can causefoaming, loss of fluid and trans‐axle malfunction.
•The use of a non-specified fluidcould cause transaxle malfunctionand failure.
WARNING
nParking brake
(Continued)
(Continued)
To avoid sudden movement of thevehicle, apply the parking brake anddepress the brake pedal before mov‐ing the shift lever.
NOTICE
The L

PARKING BRAKE
Checking the parking brake
Check the stroke of the parking brake
by counting the number of L