clock Lancia Delta 2008 Owner handbook (in English)

16GETTING TO KNOW YOUR CAR
Go to a Lancia Dealership as soon as possi-
ble if warning light Ueither does not light up
when the key is turned to MAR or if while
travelling the warning light comes on either steady
or blinking (on some versions along with a message
on the display). The operation of the warning light
Umay be checked by the traffic police using spe-
cific devices. Follow the laws in force in the coun-
try where you are driving.
Advanced ESP system (amber)
This warning light comes on when the ignition
key is turned to MAR, but it should go off after
a few seconds. If the warning light does not go off
or stays on together with the LED on the ASR button when
travelling, contact a Lancia Dealership. On certain versions
a dedicated message is displayed. If the warning light
flashes when driving, this indicates that the Advanced ESP
system has cut in.
á
Hill holder system failure (amber)
The áwarning light turns on to indicate a Hill
holder system failure. In this case, contact a
Lancia Dealership as soon as possible. Alter-
natively, on some versions the *symbol is
lit up on the display.
The display will show a dedicated message.
á
*
Glow plug preheating
This warning light comes on when the key is
turned to MAR. It will go out as soon as the glow
plugs have reached a predetermined temperature.
Start the engine as soon as the warning light goes out.
IMPORTANT At high outdoor temperatures the warning
light stays on for an extremely short time.
m
To switch the warning light off, carry out the following
initialization procedure:
turn the ignition key to the ON position;
turn the steering wheel fully both clockwise and anti-
clockwise (to move from the position with the wheels
straight);
turn the ignition key to the OFF position and then turn
it back ON.
If the
áwarning light does not go out after a few
seconds, seek assistance from a Lancia Dealership.

22GETTING TO KNOW YOUR CAR
fig. 7L0E0005m
CONTROL BUTTONS Fig. 7
Õ: to scroll up through the displayed menu and the re-
lated options or to increase the displayed value.
SET: press briefly to access the menu and/or go to next
screen or confirm the required menu option. Hold down
to go back to the standard screen.
Ô: to scroll down through the displayed menu and the re-
lated options or to decrease the value displayed.IMPORTANT Buttons
ÕandÔactivate different func-
tions according to the following situations:
– within the menu, they allow you to scroll up and down
through the options;
- when carrying out settings they allow you to increase
or decrease values.
IMPORTANT When one of the front doors is opened, the
display will turn on and show the clock and km or mi cov-
ered for a few seconds.

26GETTING TO KNOW YOUR CAR
Cornering lights (activation/deactivation
“Cornering lights - Front fog lights with Cornering
function) (where provided)
This function allows you to activate/deactivate the Cor-
nering lights. To activate/deactivate (ON/OFF) the lights,
proceed as follows:
– briefly press SET: “On” or “Off” will flash on the dis-
play (according to previous setting);
– press
Õor Ôto change the setting;
– briefly press SET to go back to the menu screen or hold
the button down to go back to the standard screen with-
out storing the new settings.
Trip B activation/info (Trip B on)
Through this option it is possible to activate (On) or de-
activate (Off) the Trip B (partial trip) display.
For further information see “Trip computer”.
For activation / deactivation, proceed as follows:
– briefly press SET: (On) or (Off) will flash on the display
(according to previous setting);
– press
Õor Ôto change the setting;
– briefly press SET to go back to the menu screen or hold
the button down to go back to the standard screen with-
out storing the new settings.Time setting (Clock)
Using this function, it is possible to set the clock through
two sub-menus: “Time” and “Mode”.
Proceed as follows:
– briefly press SET: the display will show two sub-menus
“Time” and “Mode”;
– press
Õor Ôto navigate the two sub-menus;
– once you have selected a sub-menu, press SET briefly;
– when accessing the “Time” submenu: briefly press SET:
“hours” will flash on the display;
– press
Õor Ôto change the setting;
– briefly press SET: “minutes” will flash on the display;
– press
Õor Ôto change the setting;

GETTING TO KNOW YOUR CAR81
1
fig. 50L0E0109m
INITIALISATION PROCEDURE
The sunroof must be re-initialised after disconnecting the
battery or if the relevant protection fuse is blown.
Proceed as follows:
press button A-fig. 49 until the sunroof is completely
closed. Release the button;
press and hold down button A for at least 10 seconds
and/or until the glass panel moves forwards by one
click. Release the button at this point;
within 5 seconds of the previous operation, press and
hold down button A: The glass panel will carry out a
complete opening and closing cycle. Only release the
button when this cycle is complete.EMERGENCY OPERATION
If the switch does not work, the sunroof can be operated
manually as follows:
remove protective cap A-fig. 50 on the rear part of
the internal cover;
take the Allen key provided from the container with
the on-board documentation or from the luggage com-
partment (versions with Fix&Go automatic);
fit the key into seat B and turn it:
– clockwise to open the sunroof;
– counter-clockwise to close the sunroof.

84GETTING TO KNOW YOUR CAR
fig. 53L0E0044m
EMERGENCY REAR DOOR LOCKING
DEVICE A-fig. 53
The rear doors are fitted with an emergency device that
allows the doors to be locked when there is no current.
Proceed as follows:
insert the metal insert on the ignition key into housing
A;
turn the key clockwise and then remove it from hous-
ing A.
The door lock knob can be realigned (only when the bat-
tery charge has been restored) as follows:
press button
Ëon the key;
press door locking/unlocking button
≈on the dash-
board;
open a front door by inserting the key into the key
pawl;
operate the internal door handle.

SAFETY143
2
IMPORTANT The front and /or side air bags may activate
in the event of sharp knocks to the underbody of the ve-
hicle (e.g. impact with steps, pavements, potholes or road
bumps etc.).
IMPORTANT A small amount of dust will be released
when the airbags are deployed. The dust is not harmful
and is not the result of a fire. Furthermore, the surface of
the deployed bag and the interior of the car may be cov-
ered in a dusty residue: This dust may irritate the skin and
the eyes. Wash with mild soap and water in the event of
exposure. The expiry date of the explosive charge and the
clock wire are shown on a specific label on the door edge.
Refer to the Lancia Dealership when it’s time to replace
them.
Do not rest your head, arms or elbows on the
door, on the windows and on the window bag
area to avoid injuries during inflation. Nev-
er lean your head, arms or elbows out of window.
IMPORTANT Pretensioners, front airbags and side bags
are deployed according to different logics on the basis of
the type of collision. Non-deployment of one of the devices
does not necessarily indicate a system malfunction.
IMPORTANT If any safety device has activated due to
an accident, refer to a Lancia Dealership to replace them
and check system integrity.
Airbag checking, repair and replacement must only be car-
ried out c/o a Lancia Dealership. If you are having the car
scrapped, have the airbag system deactivated at a Lan-
cia Dealership first. If the car changes ownership, the new
owner must be informed of how to use the airbags and the
above warnings: s/he must also be given this “Owner’s
Handbook”.

166IN AN EMERGENCY
CYLINDER REPLACEMENTPROCEDURE
To replace the cylinder proceed as follows:
disconnect connection A-fig. 7;
turn the cylinder to be replaced anticlockwise and
raise it;
fit the new cylinder and turn it clockwise;
connect connection A to the cylinder and fit the trans-
parent tube B into the proper space.
fig. 7L0E0080m

176IN AN EMERGENCY
fig. 14L0E0084m
BULB TYPES fig. 14
Various types of bulbs are fitted to your car:
A. All glass bulbs: clipped into place. Pull to extract.
B. Bayonet bulbs: to remove this type of bulb from its
holder, press the bulb and turn it anticlockwise.
C. Cylindrical bulbs: release from the contacts to extract.
D. Halogen bulbs: release the fastening clip from the cor-
responding seat to remove the bulb.
E. Halogen bulbs: release the fastening clip from the cor-
responding seat to remove the lamp.

180IN AN EMERGENCY
SIDELIGHTS/DAYTIME LIGHTS
The direction indicators/daylight lights are LED-based.
Contact a Lancia dealership to have there lights replaced.
DIRECTION INDICATORS
Front indicators
To change the bulb, proceed as follows:
remove the protective cover C-fig. 15;
press down near the bulb holder locking tabs (shown
in fig. 18 by the arrows) and simultaneously pull the
unit;
remove the bulb A and replace it;
refit the protective cover C.Side indicators
To change the bulb, proceed as follows:
work on lens A-fig. 19 to compress catch B, then pull
the unit outwards;
turn the bulb holder C, anticlockwise, extract the press-
fitted bulb D and replace it;
refit the bulb holder C in the lens and turn it clock-
wise;
refit the unit making sure that internal catch B clips
into position.
fig. 18L0E0157mfig. 19L0E0158m

182IN AN EMERGENCY
THIRD BRAKE LIGHT fig. 23
Contact a Lancia Dealership to replace the LED lights in
the third brake light.
NUMBER PLATE LIGHTS
To change the bulb proceed as follows:
operate in the area shown by the arrows and remove
the lens cover unit A-fig. 24;
fig. 23L0E0162mfig. 25L0E0164m
fig. 24L0E0163m
turn the bulb holder B-fig. 25 anti-clockwise;
remove the bulb C and replace it.