ignition Lancia Delta 2009 Owner handbook (in English)

GETTING TO KNOW YOUR CAR43
1
VOLUME SENSING/ANTI-TILT PROTECTION
To guarantee the correct operation of the protection, close
the side windows and sunroof completely (where provid-
ed).
If necessary this function can be excluded (e.g. when leav-
ing pets on board) by pressing button A-fig. 14, located
on the front courtesy light, before activating the alarm.
When the function is disabled, this is indicated by the LED
on the button flashing for several seconds. Any disabling
of the volume sensing/anti-tilt protection must be repeat-
ed each time the instrument panel is switched off.
BREAK IN ATTEMPT INDICATION
Any break in attempt is indicated by the
Ywarning light
(or symbol in the display) lighting up, together with a mes-
sage shown on the display (see “Instrument panel warn-
ing lights”).DISABLING THE ALARM
To permanently disable the alarm (e.g. during a lengthy
period of idleness), simply lock the vehicle by turning the
metal insert of the key with remote control in the lock.
IMPORTANT If the battery of the key with the remote
control goes flat or the system fails, the alarm can be
switched off by placing the key in the ignition switch and
turning it to MAR.
fig. 14L0E0153m

44GETTING TO KNOW YOUR CAR
IGNITION SWITCH
The key can be turned to 3 different positions fig. 15:
STOP: the engine is off, the key can be extracted, the
steering is locked. Some electrical devices (e.g. car ra-
dio, central door locking system, etc.) are enabled
MAR: driving position. All electrical devices are en-
abled
AVV: engine start-up.
The ignition switch is fitted with an electronic safety sys-
tem that requires the ignition key to be turned back to
STOP if the engine will not start, before the starting op-
eration can be repeated.STEERING COLUMN LOCK
Engagement
When the key is at STOP, remove the key and turn the
steering wheel until it locks.
Disengagement
Move the steering wheel slightly as you turn the ignition
key to MAR.
IMPORTANT In some parking conditions (e.g.: wheels
turned) the effort required to move the steering wheel and
disengage the steering lock may be increased.
fig. 15L0E0107m
Never extract the key while the vehicle is
moving. The steering wheel would lock as
soon as the steering wheel is turned. This al-
so applies to when the car is towed. Under no cir-
cumstances should after-market operations be car-
ried out involving steering system or steering col-
umn modifications (e.g.: installation of anti-theft
device). This could negatively affect performance
and safety, invalidate the warranty and also re-
sult in vehicle non-compliance with type-approval
requirements.

46GETTING TO KNOW YOUR CAR
Height adjustment fig. 16
Operate lever C to raise or lower the rear part of the seat
cushion to improve comfort.
Lumbar adjustment (driver’s seat) fig. 16
for lumbar adjustment, turn knob D.
ELECTRICALLY ADJUSTABLE FRONT SEATS
(where provided) fig. 17
Adjustment is possible when the ignition key is at MAR or
within 1 minute with ignition key at STOP or removed.
When opening one of the front doors, it is possible to ad-
just the seat on the side of the door opened for about 3
minutes or until closing the door.
Seat adjustment controls are the following:
Multifunction control A:
to adjust height;
to move seat backwards or forwards.
Multifunction control B:
back rest angle adjustment;
lumbar adjustment.Seat warming (where provided) fig. 17
With ignition key at MAR, press buttons
Cto switch the
seat warming on/off.
The led on the button will light up when the function is
on.
fig. 17L0E0009m

60GETTING TO KNOW YOUR CAR
Switching the climate control compressor
on/off I-fig. 26
Press button
to switch on the climate control system
compressor.
Compressor engagement
the LED on button
is lit up;
Symbol
is shown on the display.
Compressor disengagement
the LED on button
is off;
symbol
disappears from the display;
internal air recirculation is excluded;
the AQS function is disabled.
With the climate control system compressor disengaged,
it is not possible to introduce air of a lower temperature
than the outside temperature into the passenger com-
partment; in this case the symbol on the display will flash.
The disengagement of the climate control compressor re-
mains in the system memory even after the engine has
been stopped. To engage the climate control compressor
press the button
once again or press AUTO: in this last
case any manual settings will be cancelled.
EXTERNAL LIGHTS
The left-hand lever operates most of the external lights.
The external lights can only be switched on when the ig-
nition key is on MAR. The instrument panel and the var-
ious controls on the dashboard will be illuminated when
the external lights are switched on.
DAYLIGHT lights (D.R.L. - Adaptive Daylight Led)
(where provided)
With the ignition key turned to MAR and the selector wheel
turned to position Othe daylight lights are automatical-
ly activated; the other lights and internal illumination re-
main off. The automatic lighting up of the daytime lights
can be switched on/off using the display menus (see “Dis-
play” section in this chapter). If the daytime lights are
switched off, when the selector wheel is turned to Ono
lights will come on.
fig. 27L0E0019m

62GETTING TO KNOW YOUR CAR
DIPPED BEAM HEADLIGHTS/SIDE LIGHTS
With the ignition key turned to MAR, turn the selector
wheel to 2. If dipped beam headlights are activated, the
daytime lights are switched off and the side lights, num-
ber plate light and dipped beam headlights are lit up. The
3warning light will come on in the instrument panel.
When the ignition key is turned to STOP or removed, and
the selector wheel is turned from
Oto2, the number plate
light and side lights are lit. The 3warning light will
come on in the instrument panel.
Parking function
With the side lights on and the ignition key turned to STOP
or removed, it is possible to light up one side of the vehi-
cle by moving the lighting lever down (left-hand side) or
up (right-hand side). In this case warning light
3on the
instrument panel will go out.
MAIN BEAM HEADLIGHTS
With the selector wheel in position 2, push the lever for-
ward toward the dashboard (stable position). The 1warn-
ing light will come on in the instrument panel. They are
switched off by pulling the lever towards the steering wheel.
Flashing the headlights
You can flash the headlights by pulling the lever towards
the wheel (unstable position). The
1warning light on the
instrument panel will come on.DIRECTION INDICATORS Fig. 28
Push the lever to (stable) position:
– up (position
a): right-hand indicator ON;
– down (position
b): left-hand indicator ON.
Warning light
¥or Îwill blink on the instrument pan-
el.. The direction indicators are switched off automatically
when the steering wheel is straightened.
fig. 28L0E0020m

GETTING TO KNOW YOUR CAR63
1
LANE CHANGE FUNCTION
If you want to signal that you are changing lane, hold the
left-hand lever in the unstable position for less than half
a second. The direction indicator on the selected side flash-
es 5 times and then switches off automatically.
“FOLLOW ME HOME” DEVICE
This function allows the space in front of the car to be lit
up for a preset period of time.
Activation
With the ignition key on STOP or removed, pull the lever
towards the steering wheel within 2 minutes of switching
the engine off. The amount of time the lights remain on
is extended by 30 seconds at each movement of the lever,
up to a maximum of 210 seconds; after this the lights are
switched off automatically. Each time the lever is oper-
ated, the warning light on the instrument panel comes
on and the display shows how long the function will re-
main active. The warning light comes on the first time the
lever is operated, and stays on until the function is auto-
matically deactivated. Each time you operate the lever, the
amount of time the lights will remain lit up increases.
Deactivation
Keep the lever pulled towards the steering wheel for more
than 2 seconds.WINDOW WASHING
The right-hand lever fig. 29 controls windscreen
wiper/washer and heated rear window wiper/washer op-
eration.
WINDSCREEN WIPER/WASHER fig. 29
This only operates with the ignition turned to MAR.
The right-hand lever can take five different positions:
A: windscreen wiper off.
B: intermittent operation;
With the lever in position B, turn selector wheel F to se-
lect one of four different speeds for the intermittent op-
eration mode:
,= very slow intermittent operation
= slow intermittent operation.
= normal intermittent operation
= fast intermittent operation.
C: continuous slow operation;
D: continuous fast operation;
E: temporary fast operation (unstable position).

64GETTING TO KNOW YOUR CAR
“Smart washing” function
Pull the lever towards the steering wheel (unstable posi-
tion) to operate the windscreen washer jet. Keep the lever
pulled to activate both the windscreen washer jet and the
windscreen wiper with a single movement; the latter turns
on automatically if you keep the lever pulled for over half
a second. The windscreen wiper stops operating a few
strokes after the lever is released; after a few seconds, a
further cleaning stroke completes the wiping operation.
fig. 29L0E0021m
REAR WINDOW WIPER/REAR WINDOW
WASHER
This only operates with the ignition turned to MAR.
Turn the selector wheel to
'to operate the rear window
wiper.
With the windscreen wiper active, turn the selector wheel
to
'activate the rear window wiper which, in this case,
operates (in the different positions) in sync with the wind-
screen wipe but at half its rate. When reverse gear is en-
gaged with windscreen wiper active, the rear window wiper
automatically turns on in slow continuous mode.
It stops when the reverse gear is disengaged.
Do not use the windscreen or rearscreen
wiper to remove layers of snow or ice from
the windscreen. In such conditions, the wind-
screen wiper may be subjected to excessive stress
and the motor protection which prevents operation
for a few seconds may trip. If the issue persists, con-
tact a Lancia Dealership.
“Smart washing” function
Pushing the lever towards the dashboard (unstable posi-
tion) will activate the rear window washer.
Keep the lever pushed to activate the rear window wash-
er jet and the rear window wiper with a single movement;
the latter turns on automatically if you keep the lever
pushed for over half a second.

66GETTING TO KNOW YOUR CAR
Deactivation
Turn the ignition key to STOP.
The next time the vehicle is started (ignition key to MAR),
the sensor is not reactivated even if the lever is still in po-
sition B-fig. 29. To activate the sensor, move the lever to
position A or C and then back to position B.
Rain sensor activation is indicated by at least one wiper
stroke even if the windscreen is dry.
Do not activate the rain sensor when wash-
ing the car in an automatic car wash.
Make sure the device is switched off if there
is ice on the windscreen.
Make sure the device is switched off whenev-
er the windscreen is being cleaned.
fig. 31L0E0022m
CRUISE CONTROL (constant speed
regulator) (where provided)
This is an electronically controlled driving aid, which al-
lows you to drive at speeds of over 30 km/h on long and
straight dry roads (e.g.: motorways), at a constant speed,
without pressing the accelerator pedal.
It is not recommended for use on extra-urban roads with
traffic. Do not use it in town.
ENGAGING THE DEVICE
Turn selector wheel A-fig. 31 to ON.
The device may only be engaged in 4th or higher speeds.

68GETTING TO KNOW YOUR CAR
DISENGAGING THE DEVICE
Turn selector wheel A-fig. 31 to OFF or turn the ignition
key to STOP. In addition, the device is automatically dis-
engaged in any of the following cases:
when the brake or clutch pedal is pressed;
if the ASR or Advanced ESP system cuts in (where pro-
vided);
When travelling with the device engaged, do
not set the gearshift lever to neutral.
In the event of a malfunction or fault, turn se-
lector wheel A-fig. 31 to OFF and contact a
Lancia Dealership after having checked the
condition of the protective fuse.
COURTESY LIGHTS
FRONT COURTESY LIGHT WITH SPOT LIGHTS
fig. 32
Switch A- turns these lights on/off.
With switch A in the central position, lights C and D will
turn on/off when the front doors are opened/closed.
With switch A switched to the left, lights C and D will re-
main off. With switch A switched to the right, lights C and
D will remain on.
The lights turn on/off gradually.
Switch B performs the spot light function; with the light
off, it will turn on:
light C if switched to the left;
light D if switched to the right.
fig. 32L0E0024m

GETTING TO KNOW YOUR CAR69
1
Environmental lights are provided as part of the cour-
tesy light; these illuminate the vehicle when the dipped
beam headlights or side lights are switched on.
IMPORTANT Before getting out of the car, make sure that
both switches are in the central position: lights off with
doors closed in order to avoid draining the battery. In any
case, if the switch is left inadvertently in the On position,
the lights will turn off automatically 15 minutes after turn-
ing the engine off.
Courtesy light timing
To facilitate getting in/out of the car at night or with poor
lighting, 2 different timed switching on modes have been
provided.
Light timing when getting into the car
The courtesy lights will turn on as follows:
for about 10 seconds when the front doors are un-
locked;
for about 3 minutes when one of the side doors is
opened;
for about 10 seconds when the doors are closed.
Timing is interrupted when the ignition key is turned to
MAR.Light timing when getting out of the car
After removing the key from the ignition switch, the cour-
tesy lights will turn on as follows:
within 2 minutes of turning the engine off, for about
10 seconds;
for about 3 minutes when one of the side doors is
opened;
for about 10 seconds when one of the doors is closed.
in the event of the fuel cut-off system cutting in, the
lights remain on for approximately 15 minutes, after
which they go out automatically.
The lights go out immediately when the doors are locked
(unless the fuel cut-off system has cut in.).
fig. 33L0E0025m