service Lancia Musa 2009 Owner handbook (in English)
[x] Cancel search | Manufacturer: LANCIA, Model Year: 2009, Model line: Musa, Model: Lancia Musa 2009Pages: 218, PDF Size: 3.7 MB
Page 179 of 218

178
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
Using the battery when the
fluid is too low can damage
it irreparably and generate a risk of
explosion.
WARNING
CHANGING THE BATTERY
If required, replace the battery with a
genuine spare part having the same
specifications.
If a battery with different specifica-
tions is fitted, the service intervals
given in the “Service schedule” in this
section will no longer be valid.
Refer therefore to the instructions pro-
vided by the battery manufacturer.Batteries contain substances
that can be very dangerous
for the environment. t is ad-
visable to have the battery
changed by a Lancia Dealership
where it will be disposed of according
to the law.Incorrect assembly of electric
and electronic devices may
cause severe damage to your
car. Go to a Lancia Dealer-
ship if you want to install accessories
(alarms, mobile phone, etc.): they will
suggest the most suitable devices and
advise you if a higher capacity battery
needs to be installed.USEFUL ADVICE FOR
LENGTHENING THE LIFE OF
YOUR BATTERY
To avoid draining your battery and to
lengthen its life, observe the following
indications:
❒when you park your car, ensure
that doors, bonnet and flaps are
well closed in order to ensure that
no lights remain on inside the pas-
senger compartment;
❒switch off all lights inside the car:
the car is however equipped with
a system which switches all inter-
nal lights off automatically;
❒when the engine is off, do not keep
devices running for long periods
(e.g. sound system, hazard lights
etc.);
❒before performing any operation
on the electrical system, discon-
nect the battery negative terminal
cable;
❒screw the terminals of the battery
down hard.
If the vehicle must remain
unused for a long time at
very low temperatures, remove the
battery and carry it to a warm place,
to avoid freezing.
WARNING
When performing any oper-
ations on the battery or near
it, always protect your eyes with the
special goggles.
WARNING
165-186 MUSA 1ed GB 10-07-2008 9:39 Pagina 178
Page 181 of 218

180
WARNING
LIGHTS AND
MESSAGES
TECHNICALSPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
❒the tyre ages even if rarely used.
Cracks in the tread and on the
sidewalls are a sign of ageing.
Have the tyres checked by spe-
cialised personnel if they have
been fitted for longer than 6 years.
Remember to check the spare
wheel very carefully;
❒In the case of replacement, always
fit new tyres, avoiding those of du-
bious origin;
❒If a tyre is changed, also change
the inflation valve;
❒to allow even wear between the
front and rear tyres, it is advisable
to change them over every 10-15
thousand kilometres, keeping
them on the same side of the car
so as not to reverse the direction of
rotation.
Remember that road hold-
ing depends also on the cor-
rect tyre inflation pressure.
WARNING
If the pressure is too low the
tyre overheats and this can
cause it serious damage.
WARNING
Do not cross switch the tyres,
moving them from the right
of the car to the left and vice versa.
WARNING
Never subject alloy rims to
repainting treatments re-
quiring the use of temperatures ex-
ceeding 150°C. The mechanical
properties of the wheels could be im-
paired.
WARNING
RUBBER HOSES
As far as the brake system and fuel
rubber hoses are concerned, carefully
follow the “Service schedule” in this
section.
Ozone, high temperatures and pro-
longed lack of fluid in the system may
cause hardening and cracking of the
hoses, with possible leaks. Careful in-
spections are therefore necessary.
165-186 MUSA 1ed GB 10-07-2008 9:39 Pagina 180
Page 194 of 218

193
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
BRAKES
Service brakes:
– front
– rear
Parking brake
IMPORTANT Water, ice and salt sprinkled on roads can deposit on the brake discs and reduce the braking efficiency when braking for
the first time.1.4
8V(▲)-1.416V- 1.3 Multijet 70HP
Self-ventilating discs (257 mm x 22 mm)
Drum (203 mm x 38 mm)
Controlled by hand lever, acting
on rear brakes
SUSPENSIONS
Front
Rear1.4
8V(▲)-1.416V- 1.3 Multijet - 1.6 Multijet
Mc Pherson independent wheels
Semi-independent wheels connected by crank axle
STEERING
Type
Minimum steering
cycle m
(
▲) Engine provided for some versions/markets only1.4
8V(▲)-1.416V- 1.3 Multijet - 1.6 Multijet
Rack and pinion with electric power steering
10.0
1.3 Multijet 90HP - 1.6 Multijet
Self-ventilating discs (284 mm x 22 mm)
1.3 Multijet 90HP: drum (228 mm x 40 mm)
1.6 Multijet: disc (240 mm x 11 mm)
Controlled by hand lever, acting on
rear brakes
187-205 MUSA 1ed GB 10-07-2008 9:40 Pagina 193
Page 203 of 218

202
WARNING
LIGHTS AND
MESSAGES
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
STARTING
AND
DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICALSPECIFICATIONS
FLUIDS AND LUBRICANTS
RECOMMENDED PRODUCTS AND SPECIFICATIONS
Use
Lubricants
for engines
running on petrol
Lubricants for
engines running
on diesel
To ensure the proper operation of the Multijet versions with DPF only use genuine lubricant. In an emergency, if the genuine product is
not available, top up with at most 0.5 l and drive to a Lancia Dealership as soon as possible.
If genuine SAE 5W-40 products cannot be used, lubricants with minimal performance ACEA A3 for petrol engines and ACEA B4 for
diesel engines are admissible; in this case, optimal performance of the engine is not guaranteed. Using products with lower characteristics
than ACEA A3 and ACEA B4 could cause damage to the engine not covered by the guarantee.
When the car is to be used under particularly harsh climate conditions, ask a Lancia Dealership for the appropriate product from the Se -
leniarange.Quality characteristics of fluids and lubricants
for the proper operation of the car
Synthetic base lubricants SAE 10W-40 grade,
FIAT 9.55535-G2qualification or ACEA A3,
AP SL specifications;
Synthetic base lubricants SAE 5W-40 grade
FIAT 9.55535-N2qualification.Genuine fluids and
lubricants
SELENIA 20K
Contractual Technical
Reference N° F405.N04
SELENIA WR
Contractual Technical
Reference N° F151.D06Replacement
interval
According to
Service Schedule
According to
Service Schedule
187-205 MUSA 1ed GB 10-07-2008 9:40 Pagina 202
Page 211 of 218

PROVISIONS FOR THE PROCESSING OF A VEHICLE
AT THE END OF ITS LIFE-CYCLE
For years now Lancia has been developing its global commitment towards the safeguarding and protection of the
Environment through the continuous improvement of its production processes and the making of increasingly
more “eco friendly” products. With a view to guaranteeing the best possible service to clients in full observance of
environmental standards and in response to the obligations imposed by European Directive 2000/53/EC on end-
of-life vehicles, Lancia offers its clients the possibility to hand in their vehicle* at the end of its life span without
additional costs.
The European Directive, in fact, provides for the take-back of the vehicle without the last holder or owner of the
same incurring expenses due to the fact that the market value of the vehicle is zero or negative. In particular, in
almost all of the countries of the European Union, up until 1st January 2007, take-back of the vehicle free of
charge only applies to vehicles registered from 1 July 2002 on, while, from 2007 on, take-back will be carried out
free of charge, independently of the year of registration, provided that the vehicle still contains all its essential
component parts (especially engine and body) and is free from additional waste materials.
Our contracted network of authorised treatment facilities has been carefully selected in order to provide a quality
service to our customers by de-polluting and recycling “End of Life Vehicles” to approved environmental
standards. To find out the location of your nearest authorised treatment facility, offering free of charge take-back,
simply contact one of our dealers or refer to the Lancia web site or call the toll free number 00800 526242 00.
*
Passenger transportation vehicles to seat a max. of nine persons, having a total admissible weight of 3.5 t
206-216 MUSA 1ed GB 10-07-2008 11:08 Pagina 210
Page 217 of 218

Fiat Group Automobiles S.p.A. - Customer Services - Technical Services - Service Engineering
Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print no. 603.81.461 - 07/2008 - 1
stedition
ENGINE OIL CHANGE COLD TYRE INFLATION PRESSURE (bar)
STANDARD TYRES
SizeMedium loadFull load
FrontRearFrontRear
FUEL CAPACITIES (litres)
1.48V - 1.416V1.3 Multijet 1.9 Multijet
Tank capacity 47 47 47
Reserve 5 - 7 5 - 7 5 - 7
Refuel petrol engines with unleaded petrol with an octane rating (RON) no lower than 95 only.
Refuel diesel engines with diesel fuel for motor vehicles (EN590 specifications) only.
1.418V1.416V1.3 Multijet 1.9 Multijet
litres kg litres kg litres kg litres kg
Engine sump 2.4 2.1 2.5 2.2 2.85 2.5 4.2 3.75
Engine sump and filter 2.62.25 2.7 2.35 3.0 2.6 4.4 3.9
185/65 R14 86T 2,2 2,1 2,3 2,3
195/60 R15 88T 2,2 2,1 2,3 2,3
205/50 R16 87V 2,2 2,1 2,3 2,3
135/80 B14 84M 2,8SPARE WHEEL
125/80 R15 95M 4,2
Add +0.3 bar to the prescribed inflation pressure when the tyres are warm. Recheck pressure value with cold tyres.
With snow tyres, add +0.2 bar to the inflation pressure value prescribed for standard tyres.
206-216 MUSA 1ed GB 10-07-2008 11:08 Pagina 216