oil dipstick Lancia Thesis 2006 Owner handbook (in English)
[x] Cancel search | Manufacturer: LANCIA, Model Year: 2006, Model line: Thesis, Model: Lancia Thesis 2006Pages: 386, PDF Size: 8.69 MB
Page 114 of 386

113
Engine oil level check (JTD versions only)
Indication is correct only if oil level has been checked with the car on a level surface.
If oil level is low, before topping up, check it by the proper dipstick as described in paragraph “Checking fluid levels”
in the “Car maintenance” chapter.
Warning light/symbol
Ç
k
Ñ
Note
If oil level is near or below
the MIN reference line
top up as soon as possible
Restore proper oil level
Use the dipstick to check that
the oil level is not exceeding
the MAX reference line
If oil level is exceed-
ing the MAX refer-
ence line contact a
Lancia Dealership as soon
as possibleMessage
ENGINE OIL LEVEL
LOW ENGINE OIL LEVEL
SWITCH OFF ENGINE
DO NOT PROCEED
MAXIMUM ENGINE
OIL LEVELMeaning of the message
Engine oil level
indication
Engine oil level is below
the minimum
Engine oil level
could exceed
the maximum
Page 321 of 386

320
IMPORTANTAfter topping up, let
the engine turn for a few seconds
and wait a few minutes after stop-
ping it before you check the level.
Engine oil consumption
Max. engine oil consumption is
usually 400 grams every 1000 km.
When the car is new, the engine
needs to run in, therefore the engine
oil consumption can only be consid-
ered stabilised after the first 5000 -
6000 km. ENGINE OIL
(fig. 7-8-9-10-11-12)
Check engine oil with the car on
level ground and while the engine is
still warm (approximately five min-
utes after stopping the engine).
Remove dipstick Aand clean it,
than plunge it down and check
whether the oil level is included
between the MINand MAXrefer-
ence lines on the dipstick. The gap
between the MINand MAXrefer-
ence lines corresponds to approxi-
mately one litre of oil.Do not add oil with dif-
ferent specifications (class,
viscosity, etc.) from the oil
already in the engine.
If the oil level is near or even below
the MINline, pour in oil through the
filler hole B, until it reaches the
MAXline.
IMPORTANTIf during a routine
check you will find that the oil level
is above the MAXreference line,
contact a Lancia Dealershipto
have the proper level restored. Be very careful under the
bonnet: you risk burning
yourself. Rememberthat
when the engine is hot, the fan
can start up and cause injuries.
fig. 7 - 2.0 TB version
L0A0323b
fig. 8 - 2.4 - 2.4 CAE versions
L0A0291b
Page 323 of 386

322
fig. 14
L0A0293b
fig. 15
L0A0158b
The engine cooling sys-
tem works with PARAFLU
UP. Top up only with the
same fluid contained in the cool-
ing circuit. PARAFLU UP cannot
be mixed up with PARAFLU 11 or
other fluids. Should this take
place, do not start the engine and
contact a Lancia Dealership. In
case of need, lacking the speci-
fied fluid, top up with water and
contact a Lancia Dealership to
have the proper proportions
restored.
The cooling system is
pressurised. If necessary,
replace the cap with a
genuine spare part to avoid com-
promising the system efficiency.
The mixture of distilled water
and PARAFLU gives freeze pro-
tection down to -35°C. POWER STEERING FLUID
(fig. 14-15)
Fluid level in the reservoir should
be at the maximum.
This check should be performed
when the engine is cold and with the
car on level ground.
For topping up, remove cap A,
after loosening the fastening screws
Bwith the wrench provided (in the
tool bag), then remove hose Cand
loosen cap D.
Check that the level reaches the
MAXreference line on the dipstick
integral with the reservoir cap (for
cold check use the level indicated on
the 20 °C side of the dipstick).If the fluid level in the reservoir is
below the specified one, top up only
with one of the products shown in
table “Fluids and lubricants” in
chapter “Technical Specifications”
proceeding as follows:
– Start the engine and wait for the
oil level in the reservoir to stabilise.
– With the engine running, turn the
steering wheel lock to lock a few
minutes.
– Top up to the MAXreference line
and then refit the cap D.