ELECTRICAL
7
DESCRIPTION AND OPERATION ALARM SYSTEM FUSES
When the vehicle immobilisation and alarm system is
fitted, three fuses are used to protect the circuit:
·Alarm system 15 amp fuse, main harness, located
behind instrument binnacle.
·Alarm sounder 20 amp fuse No.10, located in main
fuse box.
·Alarm system 5 amp fuse No.20, located in main
fuse box.
The main fuse box is positioned in the centre of the
fascia, in front of the main gear lever. A label in the
fuse box cover shows the circuits protected, the fuse
rating and their locations. They are also listed below.
MAIN FUSE BOX
Fuse No. Value (amps) Electrical circuit
1 15 Hazard warning lights
2 20 Interior lamp, horn
3 15 Wipers & washers - rear
4 10 Wipers & washers - front
5 15 Heater
6 7.5 Rear fog guard lamps
7 5 Radio/cassette player
8 15 Heated rear window
9 10 Cigar lighter
10 20 Alarm sounder
11 7.5 Headlamp - RH, dipped beam
12 7.5 Headlamp - LH, dipped beam
13 7.5 Headlamp - RH, main beam
14 7.5 Headlamp - LH, main beam
15 5 Side lamps - LH
16 5 Side lamps - RH
17 15 Stop & reverse lamps
18 20 Air conditioning
19 5 Air conditioning
20 5 Alarm system
86ELECTRICAL
24
REPAIRREV: 05/99 HEADLAMP BEAM ALIGNMENT
Service repair no - 86.40.17
Check
Check main beam alignment using beam setting
equipment. Should this not be available the beam can
be temporarily checked and adjusted as follows:-
1.Position vehicle, unladen, on level ground with
tyres correctly inflated, approximately 4 metres
from a wall or screen, marked as illustrated
below.
2.The beam centres 'A' are measured horizontally
on the vehicle and dimension 'B' vertically from
the ground.
3.Switch on main beam and adjust setting, as
necessary, with trimmer screws.On vehicles fitted with headlamp levelling units, check
and adjust headlamp beam alignment as previously
described, with fascia mounted levelling switch at
position '0'. The headlamps can then be adjusted,
according to load conditions, as follows:-
Position '0' - Driver only, or driver and all front seats
occupied (loadspace empty).
Position '1' - All seats occupied (loadspace empty).
Position '2' - All seats occupied by adults and
loadspace loaded to maximum rear axle weight.
Position '3' - Driver only with loadspace loaded to
maximum rear axle weight.
