warning light LAND ROVER DEFENDER 1999 User Guide

86ELECTRICAL
18
DESCRIPTION AND OPERATION FASCIA CONSOLE
1.Rear fog lamp switch
2.Rear wiper switch
3.Heated front screen switch (if fitted)
4.Hazard warning lamp switch
5.Heated rear window switch
6.Rear washer switch
7.Front fog lamps switch (if fitted)8.RH front window switch
9.RH heated front seat switch (if fitted)
10.Headlamp levelling control switch
11.Cigar lighter (if fitted)
12.LH heated front seat switch (if fitted)
13.LH front window switch
ProCarManuals.com

ELECTRICAL
19
DESCRIPTION AND OPERATION For 02MY a new fascia console has been introduced to accommodate the additional switches for electric windows
etc.
The console comprises a plastic moulding secured to the fascia with five screws. The new console allows existing
switches to be repositioned and has provided the opportunity to commonise the switches with other Land Rover
models. The switches and components located in the console are as follows:
Cigar lighter (if fitted)
Headlamp levelling control
LH and RH heated front seat switches (if fitted)
LH and RH front window lift switches
Front fog lamp switch (if fitted)
Rear fog lamp switch
Rear wash/wipe switch
Rear wiper switch
Hazard warning lamp switch
Heated rear window switch
Heated front screen switch (if fitted)
A central cut-out in the console provides for the installation of the radio, where fitted, or a coin tray for markets
without a standard radio installation.
ProCarManuals.com

86ELECTRICAL
26
DESCRIPTION AND OPERATION PASSENGER COMPARTMENT FUSE BOX
FROM 02MY
The increase in electrical systems on Defender 02MY vehicles has necessitated an increase in the number of
fuses required.
The passenger compartment fuse box now contains three rows of fuses instead of the previous two rows and
relays to control the CDL system, heated front screen, headlamps, anti-theft alarm ECU and seat heaters and
window lift system.
1.Fuse 8 - Anti-theft alarm ECU/BBUS (10A)
2.Fuse 9 - Front wiper motor and washer pump
(15A)
3.Fuse 10 - Rear wiper relay (10A)
4.Fuse 11 - ABS ECU (10A)
5.Fuse 12 - Engine Control Module (10A)
6.Fuse 13 - Brake pedal switch (10A)
7.Fuse 14 - Reverse lamp switch/Glowplugs (10A)
8.Fuse 15 - Miscellaneous relay control. See
Electrical Library (5A)
9.Fuse 16 - Cigar lighter/Heater blower (20A)
10.Fuse 17 - Radio (5A)
11.Fuse 18 - LH side lamps/trailer pick up (10A)
12.Fuse 19 - RH side lamps/trailer pick up (10A)
13.Fuse 20 - Headlamp levelling/Illumination (10A)
14.Fuse 21 - Direction indicators (10A)
15.Fuse 22 - RH headlamp dip beam (10A)
16.Fuse 23 - LH headlamp dip beam (10A)
17.Fuse 24 - RH headlamp main beam (10A)
18.Fuse 25 - LH headlamp main beam (10A)19.Fuse 26 - Rear fog lamp ECU (10A)
20.Fuse 27 - Alarm relay (10A)
21.Fuse 28 - Air conditioning blower relay (30A)
22.Fuse 29 - Air conditioning compressor
relay/cooling fan relay (20A)
23.Fuse 30 - Interior lamps/radio/alarm
LED/clock/diagnostic socket/tachometer (South
African vehicles only) (5A)
24.Fuse 31 - Hazard warning lamps (15A)
25.Fuse 32 - Heated rear window (20A)
26.Fuse 33 - Seat heat relay (20A)
27.Fuse 34 - RH window lift switch (20A)
28.Fuse 35 - LH window lift switch (20A)
29.Fuse 36 - Heated front screen (30A)
30.Relay - Heated Front Screen
31.Relay - Starter motor
32.Relay - Heated Rear Window
33.Relay - Headlamps
34.Relay - Anti-theft alarm
35.Relay - Seat heat/window lift
ProCarManuals.com

86ELECTRICAL
16
REPAIR LAMP ASSEMBLY - CENTRE HIGH MOUNTED
STOP LIGHT (CHMSL) - FROM 02MY
Service repair no - 86.41.32
Remove
1.Open rear door.
2.Remove 2 screws and cover from CHMSL.
3.Remove insulated cover from Lucar connector,
release catch’s and disconnect Lucar’s taking
care not to damage screen element.
4.Remove nuts securing lamp to rear screen,
withdraw lamp assembly, collect seals and
washers.
5.Remove rubber backing pad, taking care not to
damage screen obscuration band.
Refit
6.Clean obscuration band and fit new backing pad.
7.Fit lamp assembly, seals and washers. Fit nuts
and tighten to3 Nm (2.2 lbf.ft).
8.Insulate Lucar connector.
9.Connect Lucars to heated rear screen.
10.Fit cover to CHMSL and secure with screws.FLASHER UNIT - HAZARD WARNING - FROM
02MY
Service repair no - 86.55.12
Service repair no - 86.55.15
NOTE: This procedure also covers
removal of the Heated Front Screen Timer
Relay, 86.55.15.
Remove
1.Disconnect battery negative lead.See this
Section.
2.Remove 4 screws securing instrument pack and
release pack from fascia.
3.Disconnect 2 multiplugs from warning lamp
panel.
4.Disconnect instrument pack multiplug from main
harness.
5.Remove instrument pack.
ProCarManuals.com

88INSTRUMENTS
2
DESCRIPTION AND OPERATION FASCIA CONSOLE
1.Rear fog lamp switch
2.Rear wiper switch
3.Heated front screen switch (if fitted)
4.Hazard warning lamp switch
5.Heated rear window switch
6.Rear washer switch
7.Front fog lamps switch (if fitted)8.RH front window switch
9.RH heated front seat switch (if fitted)
10.Headlamp levelling control switch
11.Cigar lighter (if fitted)
12.LH heated front seat switch (if fitted)
13.LH front window switch
ProCarManuals.com

INSTRUMENTS
3
DESCRIPTION AND OPERATION For 02MY a new fascia console has been introduced
to accommodate the additional switches for electric
windows etc.
The console comprises a plastic moulding secured to
the fascia with five screws. The new console allows
existing switches to be repositioned and has provided
the opportunity to commonise the switches with other
Land Rover models. The switches and components
located in the console are as follows:
Cigar lighter (if fitted)
Headlamp levelling control
LH and RH heated front seat switches (if fitted)
LH and RH front window lift switches
Front fog lamp switch (if fitted)
Rear fog lamp switch
Rear wash/wipe switch
Rear wiper switch
Hazard warning lamp switch
Heated rear window switch
Heated front screen switch (if fitted)
A central cut-out in the console provides for the
installation of the radio, where fitted, or a coin tray for
markets without a standard radio installation.
ProCarManuals.com