oil dipstick LAND ROVER DEFENDER 1999 Workshop Manual
[x] Cancel search | Manufacturer: LAND ROVER, Model Year: 1999, Model line: DEFENDER, Model: LAND ROVER DEFENDER 1999Pages: 667, PDF Size: 8.76 MB
Page 56 of 667
LUBRICANTS, FLUIDS AND CAPACITIES
3
INFORMATION CAPACITIES
The following capacity figures are approximate and are provided as a guide only.
Capacities (approx.)* Litres Pints
Engine sump oil - Td5 7.20...................................................... 12.67
Extra when refilling after fitting new filter 1.00.......................... 1.76
Manual gearbox 2.38............................................................... 4.19
Transfer gearbox oil 2.30......................................................... 4.00
Front differential 1.70............................................................... 3.00
Rear differential
90 Models 1.70............................................................... 3.00
110 Models 2.26............................................................. 4.00
Power steering box and reservoir LHD 2.90............................ 5.00
Power steering box and reservoir RHD 3.40............................ 6.00
Swivel pin housing oil/grease (each) 0.35................................ 0.60
Fuel tank usable fuel
90 Models 60.00............................................................... 13.20 gall
110 & 130 Models 75.00................................................... 16.50 gall
Cooling system - Td5 13.00....................................................... 22.88
Washer bottle 3,0................................................................... 5.28
NOTE: * All levels must be checked by dipstick or level plugs as applicable.
ANTI-FREEZE
PERCENTAGE CONCENTRATION - 50%
PROTECTION - LOWER TEMPERATURE LIMIT
Complete protection
Vehicle may be driven away immediately from cold,
-33°C (-36°F).
Safe limit protection
Coolant in semi-frozen state. Engine may be started
and driven away after warm-up period, -41°C (-42°
F).
Lower protection
Prevents frost damage to cylinder head, block and
radiator. Thaw out before starting engine, -47°C (-53°
F).
CAUTION: Anti-freeze content must never
be allowed to fall below 50% otherwise
damage to the engine is liable to occur.
Also, anti-freeze content should not exceed 60%
as this will greatly reduce the cooling effect of the
coolant.RECOMMENDED FUEL
Diesel fuel oil, distillate, diesel fuel, automotive gas or
Derv to British standard 2869, Class A1 or A2
Using diesel fuel with a class rating lower than stated
above could seriously impair vehicle performance.
ProCarManuals.com
Page 60 of 667
MAINTENANCE
1
MAINTENANCE UNDERBONNET VIEW - Td5
LHD shown
1.Engine oil dipstick
2.Coolant expansion tank
3.Air cleaner
4.Brake/clutch fluid reservoir filler cap5.Windscreen washer reservior
6.Auxiliary drive belt
7.Engine oil filler cap
8.PAS fluid reservoir
ProCarManuals.com
Page 73 of 667
10MAINTENANCE
14
MAINTENANCE ENGINE OIL
WARNING: Avoid excessive skin contact
with used engine oil. Used engine oil
contains potentially harmful contaminants
which may cause skin cancer or other serious
skin disorders.
1.Remove underbelly panel.See CHASSIS AND
BODY, Repair.
2.Position suitable container beneath sump.
3.Clean arear around drain plug.
4.Remove oil drain plug, discard sealing washer.
5.Allow oil to drain.
6.Fit new sealing washer to oil drain plug.
7.Fit engine drain plug and tighten to23 Nm (17
lbf.ft).
8.Fill engine with recommended grade of oil to
correct mark on dipstick.See LUBRICANTS,
FLUIDS AND CAPACITIES, Information.
9.Fit underbelly panel.See CHASSIS AND
BODY, Repair.CENTRIFUGE ROTOR - Td5
1.Renew centrifuge rotor.See ENGINE , Repair.
ProCarManuals.com
Page 88 of 667
ENGINE
3
DESCRIPTION AND OPERATION 1.Oil dipstick tube
2.Screw - oil dipstick tube to camshaft carrier
3.Oil dipstick
4.2nd piston ring
5.Piston
6.Small-end bush
7.Connecting rod
8.Big-end bearing cap
9.Connecting rod bolt (2 off per connecting rod)
10.Top piston ring
11.Oil control ring
12.Circlips (2 off per gudgeon pin)
13.Gudgeon pin
14.Big-end bearing shells
15.Dowels to cylinder head (2 off)
16.Gearbox shim plate
17.Rear crankshaft seal and housing
18.Screws - crankshaft seal flange to engine block (5 off)
19.Bolts - Gearbox shim plate to cylinder block (2 off)
20.Main oil gallery plug (rear)
21.Oil filter adaptor gasket
22.Oil filter adaptor thermostat
23.Oil filter adaptor assembly
24.Oil filter adaptor insert
25.Oil filter adaptor to cylinder block bolts (3 off)
26.Oil filter
27.Oil pressure switch
28.Oil cooler banjo bolts (2 off)
29.O-rings - oil cooler banjo bolts (2 off)
30.Oil cooler to cylinder block bolts (7 off)
31.Centrifuge assembly
32.Centrifuge to cylinder block bolts (3 off)
33.Centrifuge oil drain pipe
34.Oil drain pipe to sump gasket
35.Centrifuge to oil drain pipe gasket
36.Oil cooler plugs (3 off)
37.Oil cooler assembly
38.Oil cooler matrix ’O’ rings (2 off)
39.Oil cooler matrix
40.Oil cooler gasket
41.Coolant and PAS pump assembly bracket
42.Bracket bolts (5 off + 1 stud/nut)
43.Cylinder block
44.Dowels - timing chain cover (2 off)
45.Oil gallery delivery plug
46.Cross drilling plug
47.Coolant jacket plug
48.Core plugs (3 off)
ProCarManuals.com