height adjustment LAND ROVER DISCOVERY 1999 Workshop Manual

CONTENTS
16 CONTENTS
REAR SUSPENSION ................................................................................ 64-1
DESCRIPTION AND OPERATION
Rear suspension component layout (vehicles with SLS) ............................................................... 64-2
Rear suspension component layout (vehicles without SLS) .......................................................... 64-3
Rear suspension components ........................................................................................................ 64-4
Description ...................................................................................................................................... 64-6
DESCRIPTION AND OPERATION
SLS component layout.................................................................................................................... 64-9
SLS system control diagram ........................................................................................................... 64-10
Description - SLS ............................................................................................................................ 64-12
Operation ........................................................................................................................................ 64-21
ADJUSTMENTS
SLS calibration blocks .................................................................................................................... 64-25
REPAIRS
Wheel hub....................................................................................................................................... 64-27
Road spring - rear ........................................................................................................................... 64-29
Air spring - SLS............................................................................................................................... 64-30
Damper - rear ............................................................................................................................... 64-31
Bushes - radius arm ....................................................................................................................... 64-31
Bushes - Watts linkage ................................................................................................................. 64-34
Sensor - height - SLS ..................................................................................................................... 64-35
Compressor unit - air - SLS ............................................................................................................ 64-35
Filter - intake - SLS ......................................................................................................................... 64-37
Switch - ride height ......................................................................................................................... 64-37
Air valve - SLS ................................................................................................................................ 64-38
Actuator - rear - ACE ...................................................................................................................... 64-39
Bushes - rear long arm - ACE......................................................................................................... 64-41

LIGHTING
ADJUSTMENTS 86-2-1
LIGHTING ADJUST ME NTS
Headlamps beam alignment - up to 03MY
$% 86.40.17
Check
1.Ensure vehicle is unladen and tyres are at
correct pressures.
2. Models with SLS: Ensure vehicle is at
standard ride height.
3. Models with headlamp levelling: Ensure
headlamp levelling switch is set to '0'.
4.Align suitable beam setting equipment to
headlamp.
5.Switch headlamps on and measure main beam
settings. Beam must be 1.4% below the
horizontal and parallel to the vehicle centre line.
If necessary, adjust headlamp to get correct
beam settings.
6.Align beam setting equipment to 2nd headlamp
and repeat check.
7.Switch off headlamps and remove beam setting
equipment.Adjust
1. For RH headlamps: Release fixings and
remove battery cover
2.Remove headlamp access cover.
3.Turn vertical adjuster as necessary to get
correct beam setting. Use a 7 mm Allen key for
models with headlamp levelling, or a 10 mm
spanner for models without headlamp levelling.
4.Turn horizontal adjuster as necessary to get
correct beam setting. Use a 10 mm spanner.
5.Fit headlamp access cover.
6. For RH headlamp adjustment: Fit battery
cover and secure fixings.

LIGHTING
86-2-2 ADJUSTMENTS
Headlamps beam alignment - from 03MY
$% 86.40.17
Check
1.Ensure vehicle is unladen and tyres are set at
the correct pressures.
2. Models with SLS: Ensure vehicle is at the
standard ride height.
3. Models without SLS: Set headlamp leveling
switch to zero.
4.Align beam setting equipment to headlamp.
5.Switch on headlamps. Headlamp setting 1.2%
below horizontal and parallel.
6.Align beam setting equipment to second
headlamp and repeat the check.
Adjust
1.Using a flat blade screwdriver rotate the
headlamp adjusters until correct alignment is
achieved
2.Rotate inboard adjuster for verticle alignment.
3.Rotate outboard adjuster for horizontal
alignment.
4.Adjust 2nd headlamp as detailed above.
5.Switch off headlamps and remove beam setting
equipment.