windshield wipers Lexus ES300 1992 Switches

SWITCHES
16
WINDSHIELD WIPER AND
WASHER SWITCH
Windshield wiper operations
Interval
adjuster
Mist wiper
operationFast speed
Slow speed
Intermittent
operation
Washer on
To turn the wipers on, move the lever. To make the washer
squirt, push the button on the end of the lever.
The ignition key must be in the “ON” position.
For mist wiper operation (a single wipe), pull the lever toward
you and release it.
The wipers will operate at intervals when the lever is in the
“INT” position. With the lever in this position, the wipers can be
adjusted to operate at intervals of 2 to 11 seconds depending
on the interval adjuster setting between “S” and “F”Also, the wipers will automatically operate a couple of times
after the washer squirts even with the lever in the “OFF”
position.
If the washer does not work, check to see whether the washer
tank is empty. For information on adding washer fluid, see
“Adding washer fluid” on page 202.
In cold weather, warm the windshield with the defroster before
using the washer. This will help prevent icing, which could
block your vision.
NOTICE:
Do not operate the wipers if the windshield is dry. It may
scratch the glass.
Shifting the windshield wiper position
The wiper blades retract under the hood when the wipers are
turned off. If retraction is obstructed by snow, etc, at the bottom
of the windshield, the wipers should be shifted from the
retracted position to the rest position above the hood level.
When the snow season is over, manually return the wipers to
the retracted position following the procedure given on the next
page.

SWITCHES
184. Turn the ignition switch on. The windshield wipers will
then shift position in accordance with the position of the
connector.
Before closing the hood. check to see that you have not
forgotten any tools, etc., Then lower the hood and make sure
it locks into place. If necessary, press down gently on the front
edge to lock it.
If you are unable to shift the position of windshield wipers,
contact your Lexus dealer.
HEADLIGHT CLEANER SWITCH
(CANADA ONLY)
ON
To spray fluid on the headlights, turn the headlight switch
to the second clickstop and push the switch.
The ignition key must be in the “ON” position.
Check the fluid level of the see-through headlight cleaner tank
every so often.
Use windshield washer fluid for replenishment. For information
or adding fluid, see “Adding washer fluid” on page 202.
NOTICE:
Do not turn the headlight cleaner on with the tank empty.
It may cause the cleaner motor to overheat.