manual transmission Lexus ES300 1998 Owner's Manuals (in English)

DRIVING TIPS
156
Brakes and safety chains
Lexus recommends trailers with brakes that conform to any
applicable federal and state/provincial regulations.
 A safety chain must always be used between the towing vehicle and the
trailer. Leave sufficient slack in the chain for turns. The chain should
cross under the trailer tongue to prevent the tongue from dropping to
the ground in case it becomes damaged or separated. For correct
safety chain procedures, follow the hitch or trailer manufacturer's
recommendations.
CAUTION
 If the total trailer weight exceeds 450 kg (1000 lb.), trailer
brakes are required.
 Never tap into your vehicle's hydraulic system as it will
lower its braking effectiveness.
 Never tow a trailer without using a safety chain securely
attached to both the trailer and the vehicle. If damage
occurs to the coupling unit or hitch ball, there is possible
danger of the trailer wandering over into another lane.
Tires
Ensure that your vehicle's tires are properly inflated. Adjust the tire
pressure to the recommended cold tire pressure indicated below:
Tire pressure, kPa (kgf/cm
2 or bar, psi)
Front 220 (2.2, 32)
Rear 220 (2.2, 32)
 The trailer tires should be inflated to the pressure recommended by the
trailer manufacturer in respect to the total trailer weight.
Trailer lights
Trailer lights must comply with federal, state/provincial and local
regulations. See your local recreational vehicle dealer or rental agency for
the correct type of wiring and relays for your trailer. Check for correct
operation of the turn signals and stop lights e ach time you hitch up. Direct
splicing may damage your vehicle's electrical system and cause a
malfunction of your lights.
Break±in schedule
 Lexus recommends that you do not tow a trailer with a new vehicle or a
vehicle with any new power train component (engine, transmission,
differential, wheel bearing, etc.) for the first 800 km (500 miles) of driving.
Maintenance
If you tow a trailer, your vehicle will require more frequent maintenance
due to the additional load. For this information, please refer to the
scheduled maintenance information in the ºOwner's Manual Supplement/
Maintenance Scheduleº.
 Retighten all fixing bolts of the towing ball and bracket after
approximately 1000 km (600 miles) of trailer driving.
Pre±towing safety check
Check that your vehicle remains level when a loaded or unloaded trailer is
hitched. Do not drive if the vehicle has an abnormal nose±up or
nose±down condition, and check for improper tongue load, overload, worn
suspension or other possible causes.
 Make sure the trailer cargo is securely loaded so that it cannot shift.
 Check that your rear view mirrors conform to any federal, state/provincial
or local regulation. If they do not, install required rear view mirrors\
appropriate for towing purposes.

DRIVING TIPS
158

Crosswinds and rough roads will adversely affect handling of your vehicle
and trailer, causing sway. Pay attention to the rear from time to time to
prepare yourself for being passed by large trucks or buses, which may
cause your vehicle and trailer to sway. If swaying happens, firmly grip the
steering wheel and reduce speed immediately but gradually. Never
increase speed. If it is necessary to reduce speed, brake slowly. Steer
straight ahead. If you make no extreme correction with the steering or
brakes, your vehicle and trailer will stabilize.
 Be careful when passing other vehicles. Passing requires considerable
distance. After passing a vehicle, do not forget the length of your trailer
and be sure you have plenty of room before changing lanes.
 In order to maintain efficient engine braking and electrical charging
performance, do not use overdrive.
 Because of the added load of the trailer, your vehicle's engine may overheat
on hot days (at temperatures over 30C [85 F]) when going up a long or
steep gr ade with a trailer. If the engine coolant temperature gauge indicates
overheating, immediately turn off the air conditioning (if in use), pull your
vehicle off the road and stop in a safe spot. See ºIf your vehicle overheatsº\
on page 166 of this manual.
 Always place wheel blocks under both the vehicle and trailer wheels when
parking. Apply the parking brake firmly. Put the transmission in ºPº.
Avoid parking on a slope with a trailer, but if it cannot be avoided, do so
only after performing the following: 1. Apply the brakes and keep them applied.
2. Have someone place wheel blocks under both the vehicle and trailer
wheels.
3. When the wheel blocks are in place, release your brakes slowly until the
blocks absorb the load.
4. Apply the parking brake firmly.
5. Shift into ºPº and turn off the engine.
When restarting out after parking on a slope:
1. With the transmission in ºPº position, start the engine. Be sure to k\
eep the
brake pedal depressed.
2. Shift into the º2º, ºLº or ºRº position.
3. Release the parking brake and brake pedal and slowly pull or back away
from the wheel blocks. Stop and apply your brakes.
4. Have someone retrieve the blocks.
CAUTION

Do not exceed 72 km/h (45 mph) or the posted towing speed
limit, whichever is lower. Because instability (swaying) of
a towing vehicle±trailer combination usually increases as
the speed increases, exceeding 72 km/h (45 mph) may cause
loss of control.
Slow down and downshift before descending steep or long downhill
grades. Do not make sudden downshifts.
 Avoid holding the brake pedal down too long or too fr equently. This
could cause the brakes to overheat and result in reduced braking
efficiency.