wheel torque Lexus ES300 1998 Owner's Manuals (in English)
[x] Cancel search | Manufacturer: LEXUS, Model Year: 1998, Model line: ES300, Model: Lexus ES300 1998Pages: 249, PDF Size: 2.18 MB
Page 180 of 249
IN CASE OF AN EMERGENCY
172
40E012
9. Lower the vehicle completely and tighten the wheel nuts.
Turn the jack handle counterclockwise to lower the vehicle.
Use only the wheel nut wrench to tighten the nuts. Do not use other tools \
or
any additional leverage other than your hands, such as a hammer, pipe or your
foot. Make sure the wrench is securely engaged over the nut.
Tighten each nut a little at a time in the order shown. Repeat the process unti\
l
all the nuts are tight.
CAUTION
When lowering the vehicle, make sure all portions of your
body and all other persons around will not be injured as the
vehicle is lowered to the ground.
As soon as possible after changing wheels, have the wheel
nuts tightened by torque wrench at 103 N´m (10.5 kgf´m, 76
ft´lbf.).
10. After changing the wheel, check the air pressure of the replaced tire.
Stow all the tools, jack and flat tire securely.
If the pressure of the replaced tire is low, drive slowly to the nearest service
station and fill to the correct pressure.
Do not forget to reinstall the tire valve cap as dirt and moisture could get into
the valve core and possible cause air leakage. If the cap is missing, put a new
one on as soon as possible.
This is the same procedure for changing or rotating your tires.
CAUTION
Before driving, make sure all the tools, jack and flat tire are
securely in place in their storage location to reduce the
possibility of personal injury during a collision or sudden
braking.
Page 212 of 249
CHASSIS
204
± STEERING
Wheel freeplay
Power steering fluid type
Less than 30 mm (1.2 in.)
Automatic transmission fluid DEXRONII or III
± TIRES AND WHEELSTire size
Recommended cold tire inflation pressure Vehicle load up to 4 occupants
Vehicle loaded up to vehicle capacity weight
Spare tire
Trailer towing (conventional and snow tires)
Wheel size
Wheel nut torque
P205/65 R15 92V
180 kPa (1.8 kgf/cm
2 or bar, 26 psi) (Both front and rear)
220 kPa (2.2 kgf/cm2 or bar, 32 psi) (Both front and rear)
220 kPa (2.2 kgf/cm2 or bar, 32 psi)
220 kPa (2.2 kgf/cm2 or bar, 32 psi) (Both front and rear)
15 x 6 JJ
103 N´m (10.5 kgf´m, 76 ft´lbf.)