wheel Lexus GS250 2014 Manual PDF

5106-3. Do-it-yourself maintenance
GS350_250_OM_OM30E16E_(EE)
XRight-hand drive vehicles
FuseAmpereCircuit
1STOP7. 5Stop lights, high mounted stoplight
2P/ S E AT 1 F/ R30Po w e r s e a t s
3FR P/OUTLET15Po w e r o u t l e t ( f r o n t )
4P/ W- B5Power window master switch
5RR P/OUTLET15Power outlet (rear)
6P/ S E AT 2 F/ R25Po w e r s e a t s
7AV S20AV S
8WIPER30Windshield wipers
9WA S H20Windshield washer
10RH ECU-IG10Navigation system, VDIM, D-SW MODULE
(Blind Spot Monitor, heated steering wheel)
11RH-IG10
Tension reducer, AWD system, power seats,
head-up display, front right-hand door ECU,
“nanoe™”, shift lock system, electric tilt and
telescopic steering column, seat heater/ven-
tilator switches, smart entry & start system
antennas, tire pressure warning system
receiver, driver monitor system
12DOOR FR30
Front right-hand door control system (out-
side rear view mirror defoggers, power win-
dow)
GS350_250_OM_OM30E16E_(EE).book Page 510 Tuesday, July 8, 2014 7:11 PM

517 6-3. Do-it-yourself maintenance
6
Maintenance and care
GS350_250_OM_OM30E16E_(EE)
■Halogen front fog lights (if equipped)
To allow enough working
space, turn the steering wheel
to the opposite side of the bulb
to be replaced.
Remove the 2 fender liner
clips.
Turn the steering wheel to the left
when replacing the right side light
bulb, and turn the steering wheel to
the right when replacing the left
side light bulb.
To take out the clips, turn the head
of the clip to unlock, then remove
by pulling.
While holding the clamp open,
pull and remove the tabs and
open the fender liner.
Unplug the connector while
pressing the lock release.
Replacing light bulbs
1
2
3
GS350_250_OM_OM30E16E_(EE).book Page 517 Tuesday, July 8, 201 4 7:11 PM

519 6-3. Do-it-yourself maintenance
6
Maintenance and care
GS350_250_OM_OM30E16E_(EE)
■Front turn signal lights (vehicles with discharge headlights)
For the left side only: To allow
enough working space, turn
the steering wheel all the way
to the right, then remove the
bolts and take off the cover.
Turn the bulb base counterclockwise.
1
2
XRight sideXLeft side
GS350_250_OM_OM30E16E_(EE).book Page 519 Tuesday, July 8, 201 4 7:11 PM

535
7
7-1. Essential information
When trouble arises
GS350_250_OM_OM30E16E_(EE)
If your vehicle has to be stopped in an emergency
Steadily step on the brake pedal wi
th both feet and firmly depress it.
Do not pump the brake pedal repeatedly as this will increase the effort required to
slow the vehicle.
Shift the shift lever to N.
XIf the shift lever is shifted to N
After slowing down, stop the vehicle in a safe place by the road.
Stop the engine.
XIf the shift lever cannot be shifted to N
Keep depressing the brake pedal with both feet to reduce vehicle
speed as much as possible.
To stop the engine, press and
hold the engine switch for 2 con-
secutive seconds or more, or
press it briefly 3 times or more in
succession.
Stop the vehicle in a safe place by the road.
Only in an emergency, such as if it becomes impossible to stop the vehi-
cle in the normal way, stop the ve hicle using the following procedure:
1
2
3
4
3
Press and hold for 2 seconds or more
or press briefly 3 times or more
4
CAUTION
■If the engine has to be turned off while driving
Power assist for the brakes and steering wheel will be lost, making the brake pedal
harder to depress and the steering wheel heavier to turn. Decelerate as much as
possible before turning off the engine.
5
GS350_250_OM_OM30E16E_(EE).book Page 535 Tuesday, July 8, 201 4 7:11 PM

5367-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If your vehicle needs to be towed
The following may indicate a problem with your transmission. Contact any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or commercial towing service before towing.
●The engine is running but the vehicle will not move.
●The vehicle makes an abnormal sound.
If towing is necessary, we recommen d having your vehicle towed by any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional or commercial towing service, using a wheel-lift
type truck or flatbed truck.
Use a safety chain system for all to wing, and abide by all state/provin-
cial and local laws.
Situations need to contact dealers before towing
GS350_250_OM_OM30E16E_(EE).book Page 536 Tuesday, July 8, 201 4 7:11 PM

5377-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
Do not tow with a sling-type truck to
prevent body damage.
Towing with a sling-type truck
Towing with a wheel-lift type truck
XFrom the frontXFrom the rear
Use a towing dolly under the rear
wheels. Use a towing dolly under the front
wheels.
GS350_250_OM_OM30E16E_(EE).book Page 537 Tuesday, July 8, 201
4 7:11 PM

5387-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
If your Lexus is transported by a flat-
bed truck, it should be tied down at
the locations shown in the illustra-
tion.
If you use chains or cables to tie
down your vehicle, the angles
shaded in black must be 45°.
Do not overly tighten the tie downs
or the vehicle may be damaged.
If a tow truck is not available in an emergency, your vehicle may be tempo-
rarily towed using a cable or chain secured to the emergency towing eye-
let. This should only be attempted on hard surfaced roads for 80 km
(50miles) at low speeds.
A driver must be in the vehicle to steer and operate the brakes. The vehi-
cle’s wheels, drive train, axles, steer ing and brakes must be in good condi-
tion.
Using a flatbed truck
Emergency towing
GS350_250_OM_OM30E16E_(EE).book Page 538 Tuesday, July 8, 201 4 7:11 PM

5397-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
Take out the towing eyelet. (→P. 578, 593)
Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehi-
cle body as shown in the illustration.
Insert the towing eyelet into the
hole and tighten partially by hand.
Tighten down the towing eyelet
securely using a wheel nut
wrench or hard metal bar.
Securely attach a cable or chain to the towing eyelet.
Take care not to damage the vehicle body.
Enter the vehicle being towed and start the engine.
If the engine does not start, turn the engine switch to IGNITION ON mode.
Shift the shift lever to N and release the parking brake.
When the shift lever cannot be shifted: →P. 6 1 4
Installing towing eyelet
1
2
3
4
5
6
7
GS350_250_OM_OM30E16E_(EE).book Page 539 Tuesday, July 8, 201 4 7:11 PM

5407-2. Steps to take in an emergency
GS350_250_OM_OM30E16E_(EE)
■While towing
If the engine is not running, the power assist for the brakes and steering will not func-
tion, making steering and braking more difficult.
■Wheel nut wrench
Wheel nut wrench is installed in trunk. (→P. 5 7 8 , 5 9 3 )
CAUTION
Observe the following precautions.
Failure to do so may result in death or serious injury.
■When towing the vehicle
■While towing
●When towing using cables or chains, avoid sudden starts, etc. which place exces-
sive stress on the towing eyelet, cables or chains. The towing eyelet, cables or
chains may become damaged, broken debris may hit people and cause serious
damage.
●Do not turn the engine switch off.
There is a possibility that the steering wheel is locked and cannot be operated.
■Installing towing eyelet to the vehicle
Make sure that towing eyelet is installed securely.
If not securely installed, towing eyelet may come loose during towing.
2WD models:
Be sure to transport the vehicle with all four
wheels raised off the ground. If the vehicle is
towed with the tires contacting the ground,
the drivetrain and related parts may be dam-
aged or an accident may occur due to a
change in direction of the vehicle.
AW D m o d e l s :
Be sure to transport the vehicle with all four
wheels raised off the ground. If the vehicle is
towed with the tires contacting the ground,
the drivetrain or related parts may be dam-
aged, the vehicle may fly off the truck.
GS350_250_OM_OM30E16E_(EE).book Page 540 Tuesday, July 8, 201 4 7:11 PM

5417-2. Steps to take in an emergency
7
When trouble arises
GS350_250_OM_OM30E16E_(EE)
NOTICE
■To prevent damage to the vehicle when towing using a wheel-lift type truck
Do not tow the vehicle from the rear when the engine switch is off. The steering
lock mechanism is not strong enough to hold the front wheels straight.
■To prevent body damage when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.
GS350_250_OM_OM30E16E_(EE).book Page 541 Tuesday, July 8, 201 4 7:11 PM