Lexus IS250C 2010 Owner's Manual
IS250C 2010
Lexus
Lexus
https://www.carmanualsonline.info/img/36/29959/w960_29959-0.png
Lexus IS250C 2010 Owner's Manual
Trending: tow, emergency towing, load capacity, jacking, USB port, start, automatic transmission fluid
Page 511 of 586
510
5-2. Steps to take in an emergency
10_IS250C/350C_U
■Overheating
If you observe the following, your vehicle may be overheating.
●The engine coolant temperature gauge enters the red zone or a loss of power is
experienced.
●Steam is coming from under the hood.
CAUTION
■To prevent an accident or injury when inspecting under the hood of your vehicle
●If steam is seen coming from under the hood, do not open the hood until the
steam has subsided. The engine compartment may be very hot, causing serious
injury such as burns.
●Keep hands and clothing away from the fan and other belts while the engine is
running.
●Do not loosen the radiator cap while the engine and radiator are hot.
Serious injury, such as burns, may result from hot coolant and steam released
under pressure.
Add engine coolant if required.
Water can be used in an emer-
gency measure if engine coolant
is unavailable. (→P. 5 3 1 )
Have the vehicle checked at your nearest Lexus dealer as soon as pos-
sible.
STEP6
Page 512 of 586
5
When trouble arises
511
5-2. Steps to take in an emergency
10_IS250C/350C_U
NOTICE
■When adding engine coolant
Wait until the engine has cooled down before adding engine coolant.
When adding coolant, do so slowly. Adding cool coolant to a hot engine too quickly
can cause damage to the engine.
Page 513 of 586

512
5-2. Steps to take in an emergency
10_IS250C/350C_U
If the vehicle becomes stuck
CAUTION
■When attempting to free a stuck vehicle
If you choose to rock the vehicle back and forth to free it, make sure the surround-
ing area is clear, to avoid striking other vehicles, objects or persons. The vehicle
may also lunge forward or lunge back suddenly as it becomes free. Use extreme
caution.
■When shifting the shift lever
With automatic transmission vehicles, be careful not to shift the shift lever with the
accelerator pedal depressed.
This may lead to unexpected rapid acceleration of the vehicle that may cause an
accident and result in death or serious injury.
Carry out the following procedures if the tires spin or the vehicle becomes
stuck in mud, dirt, or snow.
Stop the engine. Set the parking brake and shift the shift lever
in P (vehicles with an automatic transmission) or N (vehicles
with a manual transmission).
Remove the mud, snow, or sand from around the stuck tire.
Place wood, stones or some other material to help provide
traction under the tires.
Restart the engine.
Shift the shift lever to the D or R position (vehicles with an auto-
matic transmission) or 1 or R position (vehicles with a manual
transmission) and carefully apply the accelerator to free the
vehicle.
Turn off TRAC and VSC if these functions are hampering your
attempts to free the vehicle. (→ P. 2 0 6 )
STEP1
STEP2
STEP3
STEP4
STEP5
Page 514 of 586
5
When trouble arises
513
5-2. Steps to take in an emergency
10_IS250C/350C_U
NOTICE
■To avoid damaging the transmission and other components
●Avoid spinning the wheels and do not rev the engine.
●If the vehicle remains stuck after trying these procedures, the vehicle may require
towing to be freed.
Page 515 of 586

514
5-2. Steps to take in an emergency
10_IS250C/350C_U
If the retractable hardtop does not close
Unlock the trunk. (→P. 4 7 )
Open the trunk fully.
If the retractable hardtop does not clos e when the switch is pressed, check
that all operating conditions are met. ( →P. 8 6 )
If the retractable hardtop will not close even though all operating condi-
tions have been met, there may be a malfunction. Immediately have the
vehicle inspected by your Lexus dealer.
As a temporary measure, the following procedure can be performed to
manually close the retractable hardtop.
■ Notes for manually closin g the retractable hardtop
● This procedure requires 2 people.
● There is some risk of damage to the vehicle during the procedure,
such as when applying considerable force or removing and
installing various parts. If you are unsure of how to perform this
procedure properly, it is recommended that you contact your
Lexus dealer.
● Protect your hands with gloves etc. when placing them in narrow
spaces.
● Before starting the procedure, turn the “ENGINE START STOP”
switch off.
STEP1
STEP2
Page 516 of 586
5
When trouble arises
515
5-2. Steps to take in an emergency
10_IS250C/350C_UPulling the yellow rings attached to
the left and right sides of the trunk,
raise the front end of the trunk lid.
Holding the parts in the same
places as those shown in the illus-
trations, lift the trunk lid and move
it as far as possible toward the rear
of the vehicle.
Performing this procedure by hold-
ing parts other than those indi-
cated may result in damage to the
vehicle or serious injury.
STEP3
STEP4
Page 517 of 586
516
5-2. Steps to take in an emergency
10_IS250C/350C_URemove the 2 screws and cover
from each trunk lid hinge.
Remove the bolts and brackets.
STEP5
STEP6
Page 518 of 586
5
When trouble arises
517
5-2. Steps to take in an emergency
10_IS250C/350C_UDetach the connector on each
trunk lid hinge.
Remove the bolts and connector
brackets.
Remove the 2 bolts and side pack-
age tray from each trunk lid hinge.
Support each side package tray by
hand to prevent it from falling
down.
STEP7
STEP8
STEP9
Page 519 of 586
518
5-2. Steps to take in an emergency
10_IS250C/350C_URemove the board on the rear
side.
Remove the board on the front
side.
Remove the 6 bolts and rear plate.
Remove the 4 bolts and front plate.
STEP10
STEP 11
STEP 12
STEP 13
Page 520 of 586
5
When trouble arises
519
5-2. Steps to take in an emergency
10_IS250C/350C_UUsing an open-end wrench, turn
the six-sided part of the silver rod
as far as possible.
The plate brackets will rise up.
Using a hexagon wrench, remove
the 2 bolts and lock on the left and
right sides of the vehicle.
The lock on the left side of the vehi-
cle can be removed. However, the
lock on the right side of the vehicle
cannot be removed completely as
it is attached to a wire harness.
Holding the parts in the same
places as those shown in the illus-
tration, carefully raise the roof
panel and move it toward the front
of the vehicle.
Performing this procedure by hold-
ing parts other than those indi-
cated may result in damage to the
vehicle or serious injury.
Let go of the roof panel once it
begins to lower on its own.
The roof panel will not lower com-
pletely.
STEP 14
STEP 15
STEP 16
Trending: bulb, fuel filter, heating, transmission, transmission fluid, charging, wheel bolts