wheel lexus LC500 2018 Manual PDF

341
6
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
Maintenance and care
2Slightly loosen the wheel nuts (one
turn).
3 Turn the tire jack portion by
hand until the notch of the jack is in
contact with the jack point.
The jack point guides are located under the rocker panel. They indicate the jack
point positions.
4 Raise the vehicle until the tire is
slightly raised off the ground.
5 Remove all the wheel nuts and the
tire.
When resting the tire on the ground, place
the tire so that the wheel design faces up to avoid scratching the wheel surface.
1 Remove any dirt or foreign matter
from the wheel contact surface.
TireWheel chock positions
Front left-
hand side
Behind the rear right-hand
side tire
Front right-
hand side
Behind the rear left-hand
side tire
Rear left-
hand side
In front of the front right-
hand side tire
Rear right-
hand side
In front of the front left-hand
side tire
A
WARNING
■Replacing a tire
Do not touch the disc wheels or the area around the brakes immediately after the vehicle has been driven.
After the vehicle has been driven the disc wheels and the area around the brakes will be extremely hot. Touching these
areas with hands, feet or other body parts while changing a tire, etc. may result in burns.
Installing the tire

342
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to
come off.
2 Install the tire and loosely tighten
each wheel nut by hand by approxi-
mately the same amount.
Turn the wheel nuts until the washers come
into contact with the disc wheel.
Disc wheel
Washer
3 Lower the vehicle.
4 Firmly tighten each wheel nut two
or three times in the order shown in
the illustration.
Tightening torque: 140 N•m (14.3 kgf•m, 103.3 ft•lbf)
5 Stow the jack and all tools.
A
B

344
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
WARNING
■When installing the tire
Failure to follow these precautions could cause the wheel nuts to loosen and the tire to fall off, resulting in death or serious
injury.
●Never use oil or grease on the wheel bolts or wheel nuts.Oil and grease may cause the wheel
nuts to be excessively tightened, lead- ing to bolt or disc wheel damage. In addition, the oil or grease can cause
the wheel nuts to loosen and the wheel may fall off, causing a serious accident. Remove any oil or grease from the
wheel bolts or wheel nuts.
●Have the wheel nuts tightened with a torque wrench to 140 N•m (14.3 kgf•m, 103.3 ft•lbf) as soon as possible
after changing wheels.
●Do not attach a heavily damaged wheel ornament, as it may fly off the wheel while the vehicle is moving.
●When installing a ti re, only use wheel
nuts that have been specifically designed for that wheel.
●If there are any cracks or deformations in the bolt screws, nut threads or bolt
holes of the wheel, have the vehicle inspected by any authorized Lexus retailer or Lexus authorized repairer,
or any reliable repairer.
■After using the tools and jack
Before driving, make sure all the tools and jack are stored securely in place. Failure to do so may cause injury in case
of a collision or sudden braking.
NOTICE
■Repairing or replacing tires, wheels, tire pressure warning valves, trans-mitters and tire valve caps
 P.335

345
6
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
Maintenance and care
■Effects of incorrect tire inflation pres- sure
Driving with incorrect tire inflation pressure may result in the following:
●Reduced fuel economy
●Reduced driving comfort and poor han-dling
●Reduced tire life due to wear
●Reduced safety
●Damage to the drivetrain
If a tire needs frequent inflating, have it checked by any authorized Lexus retailer or Lexus authorized repairer, or any reliable
repairer.
■Instructions for checking tire inflation pressure
When checking tire inflation pressure, observe the following:
●Check only when the tires are cold.If your vehicle has been parked for at least 3 hours or has not been driven for
more than 1.5 km or 1 mile, you will get an accurate cold tire inflation pressure read-ing.
●Always use a tire pressure gauge.It is difficult to judge if a tire is properly
inflated based only on its appearance.
●It is normal for the tire inflation pressure
to be higher after driving as heat is gen- erated in the tire. Do not reduce tire infla-tion pressure after driving.
●Passengers and luggage weight should be placed so that the vehicle is balanced.
Tire inflation pressure
Make sure to maintain proper tire
inflation pressure. Tire inflation
pressure should be checked at least
once per month. However, Lexus
recommends that tire inflation
pressure be checked once every
two weeks.
WARNING
■Proper inflation is critical to save tire performance
Keep your tires properly inflated. If the tires are not properly inflated, the following conditions may occur which
could lead to an accident resulting in death or serious injury:
●Excessive wear
●Uneven wear
●Poor handling
●Possibility of blowouts resulting from overheated tires
●Air leaking from between tire and
wheel
●Wheel deformation and/or tire dam- age
●Greater possibility of tire damage while driving (due to road hazards,
expansion joints, sh arp edges in the road, etc.)
NOTICE
■When inspecting and adjusting tire inflation pressure
Be sure to put the tire valve caps back on. If a valve cap is not installed, dirt or mois-
ture may get into the valve and cause an air leak, resulting in decreased tire infla-tion pressure.

346
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
When replacing wheels, care should
be taken to ensure that they are equiv-
alent to those removed in load capac-
ity, diameter, rim width and inset*.
Replacement wheels are available at
any authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
*: Conventionally referred to as offset.
Lexus does not recommend using the
following:
 Wheels of different sizes or types
 Used wheels
 Bent wheels that have been straight-
ened
■When replacing wheels
The wheels of your vehicle are equipped with tire pressure warning valves and trans-
mitters that allow the tire pressure warning system to provide advance warning in the event of a loss in tire inflation pressure.
Whenever wheels are replaced, tire pres- sure warning valves and transmitters must be installed. ( P.335)Use only Lexus wheel nuts and
wrenches designed for use with
your aluminum wheels.
 When rotating, repairing or chang-
Wheels
If a wheel is bent, cracked or heavily
corroded, it should be replaced.
Otherwise, the tire may separate
from the wheel or cause a loss of
handling control.
Wheel selection
WARNING
■When replacing wheels
●Do not use wheels that are a different
size from those recommended in the Owner’s Manual, as this may result in a loss of handling control.
●Never use an inner tube in a leaking
wheel which is designed for a tubeless tire. Doing so may result in an acci-dent, causing death or serious injury.
■Use of defective wheels prohibited
Do not use cracked or deformed wheels.
Doing so could cause the tire to leak air during driving, possibly causing an acci-dent.
NOTICE
■Replacing tire pressure warning
valves and transmitters
●Because tire repair or replacement
may affect the tire pressure warning valves and transmitters, make sure to have tires serviced by any authorized
Lexus retailer or Lexus authorized repairer, or any reliable repairer or other qualified service shop. In addi-
tion, make sure to purchase your tire pressure warning valves and transmit-ters at any authorized Lexus retailer or
Lexus authorized repairer, or any reli- able repairer.
●Ensure that only genuine Lexus wheels are used on your vehicle.
Tire pressure warning valves and trans- mitters may not work properly with non-genuine wheels.
Aluminum wheel precautions

347
6
-$@-$I@0.@0.&@ &&

6-3. Do-it-yourself maintenance
Maintenance and care
ing your tires, check that the wheel
nuts are still tight after driving 1600
km (1000 miles).
 Be careful not to damage the alumi-
num wheels when using tire chains.
 Use only Lexus genuine balance
weights or equivalent and a plastic
or rubber hammer when balancing
your wheels.
1 Turn the engine switch switch> off.
2 Open the glove box.
3 Remove the panel.
4 Unlock the filter cover ( ), pull
the filter cover out of the claws
( ), and remove the filter cover.
Air conditioning filter
The air conditioning filter must be
changed regularly to maintain air
conditioning efficiency.
Removing the air conditioning
filter
A
B

361
7
-$@-$I@0.@0.&@ &&

7-1. Essential information
When trouble arises
seconds or more, or press it briefly
3 times or more in succession.
5 Stop the vehicle in a safe place by
the road.
WARNING
■If the engine has to
be turned off while driving
Power assist for the steering wheel will be lost, making the steering wheel heavier to turn. Decelerate as much as
possible before turning off the engine .

362
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
7-2.Steps to take in an emergency
If your vehicle needs to be
towed
If towing is necessary, we recom-
mend having your vehicle towed by
any authorized Lexus retailer or
Lexus authorized repairer, or any
reliable repairer or commercial
towing service, using a wheel-lift
type truck or flatbed truck.
Use a safety chain system for all
towing, and abide by all state/pro-
vincial and local laws.
WARNING
Observe the following precautions. Failure to do so may result in death or
serious injury.
■When towing the vehicle
LC500: Be sure to transport the vehicle with all four wheels raised off the ground. If the vehicle is towed with the tires con-
tacting the ground, the drivetrain and related parts may be damaged or an accident may occur due to a change in
direction of the vehicle.
LC500h: Be sure to transport the vehi- cle with all four wheels raised off the
ground. If the vehicle is towed with the tires contacting the ground, the drive-train and related parts may be damaged,
an accident may occur due to a change in direction of the vehicle or electricity generated by the operation of the motor
may cause a fire to occur depending on the nature of the damage or malfunction.
■While towing
●When towing using cables or chains, avoid sudden starts, etc. which place excessive stress on the towing eyelets,
cables or chains. The towing eyelets, cables or chains may become dam-aged, broken debris may hit people,
and cause serious damage.
●Do not turn the engine switch off.This may lead to an accident as the
rear wheels will be locked by the park- ing lock. Also, there is a possibility that the steering wheel is locked and can-
not be operated.
■Installing towing eyelets to the vehi- cle
Make sure that towing eyelets are installed securely.
If not securely installed, towing eyelets may come loose during towing.

363
7
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
When trouble arisesIn the following situations, it is not pos-
sible to be towed by another vehicle
using cables or chains, as the rear
wheels may be locked due to the park-
ing lock. Contact any authorized Lexus
retailer or Lexus authorized repairer,
or any reliable repairer or commercial
towing service.
 There is a malfunction in the shift
control system. ( P.166, 170, 381)
 There is a malfunction in the engine
immobilizer system system>. ( P.70)
 There is a malfunction in the smart
entry & start system. ( P.389)
 The 12-volt battery is discharged.
( P.392)
The following may indicate a problem
with your transmission. Contact any
authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer or commercial towing service
before towing.
 LC500: The engine is running but
the vehicle does not move.
 LC500h: The hybrid system warn-
ing message is shown on the multi-
information display and the vehicle
does not move.
 The vehicle makes an abnormal
sound.
Do not tow with a sling-type truck to
prevent body damage.
NOTICE
■To prevent damage to the vehicle when towing using a wheel-lift type truck
●Do not tow the vehicle from the rear
when the engine switch is off. The steering lock mecha-nism is not strong enough to hold the
front wheels straight.
●When raising the vehicle, ensure ade- quate ground clearance for towing at the opposite end of the raised vehicle.
Without adequate clearance, the vehi- cle could be damaged while being towed.
■To prevent damage to the vehicle
when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.
■To prevent damage to the vehicle during emergency towing
Do not secure cables or chains to the
suspension components.
Situations when it is not possible
to be towed by another vehicle
Situations when it is necessary to
contact dealers before towing
Towing with a sling-type truck

364
-$@-$I@0.@0.&@ &&

7-2. Steps to take in an emergency
From the front
Use a towing doll y under the rear
wheels.
From the rear
Use a towing doll y under the front
wheels.
If your vehicle is transported by a flat-
bed truck, it should be tied down at the
locations shown in the illustration.
If you use chains or cables to tie down
your vehicle, the angles shaded in
black must be 45°.
Do not overly tighten the tie downs or
the vehicle may be damaged.
If a tow truck is not available in an
emergency, your vehicle may be tem-
porarily towed using cables or chains
secured to the emergency towing eye-
lets. This should only be attempted on
hard surfaced roads for short distances
at under 30 km/h (18 mph).
A driver must be in the vehicle to steer
and operate the brakes. The vehicle’s
wheels, drive train, axles, steering and
brakes must be in good condition.
Towing with a wheel-lift type
truck
Using a flatbed truck
Emergency towing