roof rack LEXUS LS430 2003 Factory Repair Manual

20.REMOVE REAR BUMPER SIDE MOUNTING BRACKET LH
a. Remove the screw and bracket.
21.REMOVE REAR BUMPER SIDE MOUNTING BRACKET RH
a. Remove the screw and bracket.
22.REMOVE REAR BUMPER ARM SUPPORT REINFORCE SUB-ASSY LH
a. Remove the 2 bolts, nut and arm support.
23.REMOVE REAR BUMPER ARM SUPPORT REINFORCE SUB-ASSY RH
a. Remove the 2 bolts, nut and arm support.
24.REMOVE REAR BUMPER RETAINER LOWER LH
a. Remove the 3 screws and retainer lower.
25.REMOVE REAR BUMPER RETAINER LOWER RH
a. Remove the 3 screws and retainer lower.
26.REMOVE ULTRASONIC SENSOR NO. 1 (w/ CLEARANCE SONAR SYSTEM)
a. Remove the 4 retainers and 4 sensors.
27.REMOVE REAR BUMPER molding
HINT:
Remove the double-sided tape completely from the bumper. Double-sided tape interferes with the
installation of the molding to the bumper.
28.REMOVE REAR BUMPER SIDE RETAINER NO. 3 LH
a. Remove the 2 clips and side retainer.
29.REMOVE REAR BUMPER SIDE RETAINER NO. 3 RH
a. Remove the 2 clips and side retainer.
30.INSTALL REAR BUMPER ARM SUPPORT REINFORCE SUB-ASSY LH
a. Install the arm support with the 2 bolts and nut.
Torque: 20 N.m (200 kgf.cm, 15 ft.lbf)
31.INSTALL REAR BUMPER ARM SUPPORT REINFORCE SUB-ASSY RH
a. Install the arm support with the 2 bolts and nut.
Torque: 20 N.m (200 kgf.cm, 15 ft.lbf)
32.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSY
a. Install the reinforcement with the 2 bolts and nut.
Torque: 20 N.m (200 kgf.cm, 15 ft.lbf)
33.INSTALL REAR BUMPER SIDE RETAINER LH
a. Using an air riveter or hand riveter with nose piece, strike waterproof rivets of phis 4.9 mm (0.19
in.) into the side retainer to install the rivet to the bumper cover.