weight LEXUS LS430 2003 Factory Repair Manual

HINT:
There is a limitation on laser optical axis adjustment.
Since the laser sensor is installed in the bumper reinforcement, it is important that the laser sensor,
bumper reinforcement, and other related parts are installed properly.
When the sensor is removed from the vehicle for trouble diagnosis or repair, it is necessary to adjust the
laser optical axis after the operation.
1.ADJUST LASER SENSOR
a. Preparation for adjusting the laser optical axis
1. Adjust the tire pressure properly (see INSPECTION
).
2. Luggage in the vehicle, such as in the trunk, should be unloaded.
3. Clean the light-luminous and light-receiving portions of the laser sensor.
HINT:
Prepare a 10 m (32.81 ft) string, with a sharp-pointed weight (plumb bob), and a 5 m (16.41 ft) tape
measure.

Fig. 23: Adjustment Direction Chart
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d. Adjust the reflector height
1. Adjust the reflector so that the center of the SST reflector is the same height as the millimeter
wave radar sensor.
SST 09870-60000 (09870-60010, 09870-60040)
HINT:
Prepare a 10 m (32.81 ft) string, with a sharp-pointed weight (plumb bob), and a 5 m (16.41 ft) tape
measure.

Fig. 477: Installing Crankshaft Bearing Caps
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
HINT:
Place the bearing caps level and let them return to their original position by their own weight.