maintenance LEXUS LS430 2006 Owner's Manual

259
4-3. Do-it-yourself maintenance
4
Maintenance and care
NOTICE
■If you remove the engine air filter:
Driving with the engine air filter removed may cause e
xcessive engine wear due to
dirt in the air. 
Also, a backfire could cause a fire in the engine compartment.

260
4-3. Do-it-yourself maintenance
Hood
CAUTION
■Pre-driving check
Check that the hood is fully closed and locked. 
If the hood is not locked properly it may open while the vehicle is in motion and
ca
use an accident, which may result in death or serious injury.
Lift the hood to inspect engine components and fluid levels.
Pull the hood release lever.
The hood will pop up slightly.
Lift the hood catch and lift the hood.

261
4-3. Do-it-yourself maintenance
4
Maintenance and care
Positioning the jack
CAUTION
■When raising your vehicle:
Make sure to observe the following to reduce the possibility of death or serious
injur
y.
• Do not put any part of your body or get underneath the vehicle supported only b
y the jack. Always use automotive jack stands or a solid, level, surface.
• Do not start or run the engine while your vehicle is supported by the jack.
• Stop the vehicle on level firm ground, firmly
set the parking brake and put the
selector lever in “P” position.
• Make sure to set the jack properly at the jack point. 
Raising the vehicle with an improperly positioned jack will damage the vehicle
or
may allow the vehicle to fall off the jack.
• Do not raise the vehicle with someone in the vehicle.
• When raising the vehicle, do not place an y ob
jects on top of or underneath the
jack.
When raising your vehicle, position the jack correctly.
Improper placement may damage your vehicle or cause injury.
Dummy

262
4-3. Do-it-yourself maintenance
Engine compartment
Brake fluid reservoir
( P.
2 7 0 )
Fuse Box ( P.298 , P.309 )
Engine oil filler cap 
( P.
2 6 3 )
Engine oil level dipstick 
( P.
2 6 3 )
Washer fluid tank ( P.277 ) Radiator
Condenser
(P.
2 6 9 )
Engine coolant reservoir 
( P.
2 6 8 )
Power steering fluid 
reservoir ( P
.272)
Battery 
(P.
2 7 3 )
1
2
3
4
5
6
7
8
9
10

263
4-3. Do-it-yourself maintenance
4
Maintenance and care
Engine oil
With the engine at operating temperature and turned off, check the oil level on
the dipstick.
■ Checking the engine oil
Park the vehicle on level ground. 
After turning off the engine, wait a few minutes for the oil to drain
back into the bottom of the engine.
Hold a rag under the end and pull the
dipstick out.
Wipe it clean.
Reinsert the dipstick until fully seated.
Holding a rag under the end, pull the dipstick out and check the
oil level.
Low
Full
1
2

264
4-3. Do-it-yourself maintenance
■Adding the engine oil
If the oil level is below or near the low
level mark, add engine oil of the same
type as already in the engine.
Make sure to check the oil type and prepare the items needed before adding.
Remove the oil filler cap.
Add engine oil slowly, checking the dipstick.
Return the filler cap and turn the ca
p clockwise until you hear a
click.
It takes about 1.6 qt. (1.5 L, 1.3 lmp.qt.) to raise the oil level from low to full on the
dipstick.
■ Recommended viscosity
Temperature range anticipated before next oil change.
SAE 5W-30 is the best choice for
goo
d fuel economy, and good starting
in cold weather.
If SAE 5W-30 is not available, SAE
1
0W-30 may be used. However, it
should be replaced with 5W-30 at
the next oil change.
Dummy
Oil gradeILSAC multigrade engine oil.
ItemsClean funnel (only for adding oil)

265
4-3. Do-it-yourself maintenance
4
Maintenance and care
■ How to read oil container labels
The ILSAC (International Lubricant Standardization and approval Commit -
tee) Certification mark is are added to some oil
containers to help you select
the oil you should use.
ILSAC Certification Mark
■Resetting the engine oil maintenance information data (U.S.A. only)
After replacing the engine oil, be sure to
reset the maintenance data. Otherwise,
the engine oil maintenance information may not function correctly. ( P.334 )
Push the "TRIP" button to change t
he trip meter display to blank.
Turn the ignition switch off.
Turn the ignition switch to "ON" while pushing
the trip meter "RESET"
button.
Keep pushing the trip meter "RESET " button for lon
ger than 5 seconds.
"Mileage Reset" appears on
the display, the master warning light comes
on, and a warning tone sounds.

266
4-3. Do-it-yourself maintenance
■Engine oil consumption
●The amount of engine oil consumed depends on the oil viscosity, the quality of
the oil and the way the vehicle is driven.
●More oil is consumed under driving conditions such as high speeds and fre -
quent acceleration and deceleration.
●A new engine consumes more oil, since its pistons, piston rings and cylinder
walls have not become conditioned.
●Oil consumption: Max. 1. 1 qt./600 miles (1.0 L per 1000 km, 0.9 lmp.qt/600
miles).
●If you consume more than 1.1 quarts (1.0 L, 0.91 lmp.qt.) every 300 miles
(500km), see your dealer.
CAUTION
■Used engine oil
●Used engine oil contains potentially harmful contaminants which may cause skin
disorders such as inflammati on or skin cancer, so care should be taken to avoid
prolonged and repeated contact with it. To remove used engine oil from your
skin, wash thoroughly with soap and water.
●Dispose of used oil and filters only in a safe and acceptable manner. Do not dis -
pose of used oil and filters in household trash, in sewers or onto the ground. Call
y
our Lexus dealer, service station or auto parts store for information concerning
recycling or disposal.
●Do not leave used engine oil within the reach of children.

267
4-3. Do-it-yourself maintenance
4
Maintenance and care
NOTICE
■To prevent serious engine damage
Check the oil level regularly.
■When replacing the engine oil
●Be careful not to spill engine oil on the vehicle components.
●Avoid overfilling, or the engine could be damaged.
●Check the oil level on the dipstick every time you refill the vehicle.
●Be sure the engine cap is properly retightened.

268
4-3. Do-it-yourself maintenance
Engine coolant
The coolant level is satisfactory if it is between the “FULL” and “LOW” lines on
the reservoir when the engine is cold.
Reservoir cap
Full line
Low line
If the level is on or below the
“LOW” line, add coolant up to the
“Full” line.
1
2
3
■If the coolant level drops within a short time after replenishing
Visually check the radiator, hoses, engine c
oolant filler cap, radiator cap and drain
cock and water pump. If you cannot find a leak, have your Lexus dealer test the cap
pressure and check for leaks in the cooling system.
■Coolant type selection
Use of improper coolants may dama ge y
our engine cooling system.
Only use “Toyota Super Long Life Coolant” or similar hig
h quality ethylene glycol
based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life
hybrid organic acid technology. (Coolant wi th long-life hybrid organic acid technol-
ogy is a combination of low phosphates and organic acids.)
For the USA : “Toyota Super Long Life Coolant” is a mixture of 50% coolant and 50% di
stilled or deionized water. (Protects to: -35 C (-31F))
For Canada : “Toyota Super Long Life Coolant” is a mixture of 55% coolant and 4
5% distilled or deionized water. (Protects to: -42 C (-44F))
Please contact your Lexus dealer for further details.