child lock LEXUS LX570 2015 User Guide

15111-7. Safety information
Before driving
LX570_OM_OM60L96U_(U) Installing child restraints Follow the child restraint system manufacturer’s instructions. Firmly
secure the child restraints to the ou tboard second seats using the LATCH
anchors or a seat belt. Attach the to p tether strap when installing a child
restraint.
The lap/shoulder belt can be used if your child restraint system is not com-
patible with the LATCH (Lower Anch ors and Tethers for Children) system.
Child restraint LATCH anchors
LATCH anchors are provided
for the outboard second seats.
(Buttons display ing the location
of the anchors are attached to
the seats.)
Seat belts equipped with a child
restraint locking mechanism
(ALR/ELR belts except driver’s
seat belt)
Anchor bracket (for top tether
strap) Anchor brackets are provided
for all second seats.

1541-7. Safety information
LX570_OM_OM60L96U_(U) Installing child restraints using a se at belt (child restraint lock function
belt)
■ Rear-facing  Infant seat/Convertible seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position. (  P. 71)
Place the child restraint system on
the second seat facing the rear of
the vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.STEP 1
STEP 2
STEP 3

1551-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the sh oulder belt and
then allow it to retract slightly in
order to activate the ALR lock
mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system down into th e second seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended. STEP 4
STEP 5

1561-7. Safety information
LX570_OM_OM60L96U_(U) ■ Forward-facing  Convertible seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position. (  P. 71)
Place the child restraint system on
the seat facing the front of the
vehicle.
Run the seat belt through the child
restraint system and insert the
plate into the buckle. Make sure
that the belt is not twisted.STEP 1
STEP 2
STEP 3

1571-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) Fully extend the shoulder strap
and then allow it to retract slightly
into the ALR lock mode. Lock mode allows the seat belt to
retract only.
While pushing the child restraint
system into the second seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place. After the shoulder belt has
retracted to a point where there is
no slack in the belt, pull the belt to
check that it cannot be extended.
If the child restraint system has a top tether strap, the top tether
strap should be latched onto the top tether strap anchor.
(  P. 152) STEP 4
STEP 5
STEP 6

1581-7. Safety information
LX570_OM_OM60L96U_(U) ■ Booster seat
Fold the seatback while pulling the
seatback angle lever. Return the
seatback and secure it at the first
lock position.
Place the child restraint system on
the seat facing the front of the
vehicle.
Sit the child in the child restraint
system. Fit the seat belt to the child
restraint system according to the
manufacturer’s instructions and
insert the plate in to the buckle.
Make sure that the belt is not
twisted. Check that the shoulder belt is cor-
rectly positioned over the child’s
shoulder, and that the lap belt is as
low as possible. (  P. 91)STEP 1
STEP 2
STEP 3

1611-7. Safety information
1
Before driving
LX570_OM_OM60L96U_(U) ■
Laws and regulations pertaining to Anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications
can be used.
This vehicle is designed to conform to the SAE J1819.
CAUTION■
When installing a booster seat
Do not fully extend the shoulder belt to prevent the belt from going to ALR lock
mode: (  P. 95)
ALR mode causes the belt to tighten only which could cause injury or discomfort to
the child. ■
When installing a child restraint system
Follow the directions given in the child restraint system installation manual and fix
the child restraint syst em securely in place.
If the child restraint system is not correctly fixed in place, the child or other passen-
gers may be seriously injured or even kill ed in the event of sudden braking, sudden
swerving or an accident. ●
If the driver’s seat interferes with the child
restraint system and prevents it from being
attached correctly, attach the child
restraint system to the right-hand second
seat. ●
Child restraint system installed on the third
seat should not contact the second seat-

1621-7. Safety information
LX570_OM_OM60L96U_(U) CAUTION■
When installing a child restraint system
●
When using the LATCH anchors for a child restraint system, move the seat as far
back as possible, with the seatback close to the child restraint system. ●
When a booster seat is installed, always ensure that the shoulder belt is posi-
tioned across the center of the child’s shoulder. The belt should be kept away
from the child’s neck, but not so that it could fall off the child’s shoulder. Failing to
do so may result in death or serious inju ry in the event of su dden braking, sudden
swerving or an accident. ●
Ensure that the belt and tab are securely locked and the seat belt is not twisted.●
Shake the child restraint sy stem left and right, and forward and backward to
ensure that it has be en securely installed.●
After securing a child restraint system, never adjust the seat.●
Follow all installation instructions provid ed by the child rest raint system manufac-
turer. ●
Only put a forward-facing child restraint
system on the front seat when unavoidable.
When installing a forward-facing or
booster child restrain t on the front passen-
ger seat, move the seat as far back as pos-
sible even if the AIR BAG OFF indicator
light illuminates. Failing to do so may result
in death or serious injury if the airbags
deploy (inflate).

5
When trouble arises
8755-2. Steps to take in an emergency
LX570_OM_OM60L96U_(U) ■
Stopping the engine
Shift the shift lever to “P ” and press the “ENGINE START STOP” switch as you nor-
mally do when stopping the engine. ■
Replacing the key battery
As the above procedure is a temporary meas ure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted.
(  P. 784)■
Changing “ENGINE START STOP” switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the
“ENGINE START STOP” switch.
The engine does not start and modes will be changed each time the switch is
pressed. (  P. 178)■
Alarm
Using the mechanical key to lock th e doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered. (  P. 121)
CAUTION■
When using the mechanical key and operating the power windows and moon
roof
Operate the power window or moon roof after checking to make sure that there is
no possibility of any passenger having any of their body parts caught in the window
or moon roof.
Also, do not allow children to operate the mechanical key. It is possible for children
and other passenger s to get caught in power window and moon roof.

940
LX570_OM_OM60L96U_(U) Abbreviation list
Abbreviation/Acronym list ABBREVIATIONS MEANING
4WD Four Wheel Drive
A/C Air Conditioning
ABS Anti-lock Brake System
AFS Adaptive Front-lighting System
AHC Active Height Control Suspension
AI-SHIFT Artificial Intelligence Shift control
ALR Automatic Locking Retractor
AVS Adaptive Variable Suspension
CRS Child Restraint System
DISP Display
ECT Electronic Controlled Transmission
EDR Event Data Recorder
ELR Emergency Locking Retractor
GAWR Gross Axle Weight Rating
GCWR Gross Combination Weight Rating
GPS Global Positioning System
GVWR Gross Vehicle Weight Rating
HI High
I/M Emission inspection and maintenance
INT Intermittent