brake LEXUS RC200T 2017 Manual PDF

6088-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
Indicates a malfunction in the automatic headlight
leveling system A buzzer also sounds.
 Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
Indicates a malfunction in:
• The Automatic High Beam system (if equipped); or
• The LED headlight system
A buzzer also sounds.
 Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
RC F only
Indicates that the brake pads are worn out A buzzer also sounds.
 Have the vehicle inspected by any authorized Lexus
dealer or repairer, or another duly qualified and
equipped professional.
Indicates that the accelerator and brake pedals are
being depressed simultaneously, and the brake override
system is operating. ( P. 237)
 Release the accelerator or brake pedal.
Warning messageDetails/Actions
(Flashes)

6118-2. Steps to take in an emergency
8
When trouble arises
RC200t_RC F_EE(OM24728E)
(If equipped)
Indicates that the Automatic High Beam switch is
pressed while the headlights are in low beam.  Turn the high beam on and press the Automatic High Beam switch again.
(If equipped)
Indicates that, since the VSC (Vehicle Stability Control)system was turned off, the pre-crash brake system oper-ation is stopped
Operation of the pre-crash brake assist is also stopped. Turn the VSC on. (P. 352)
(If equipped)
Indicates that the PCS (Pre-Crash Safety system) is not currently functional because the grille cover or the sen-
sor is dirty  Check the grille cover and the sensor and clean
them if they are dirty.
Indicates that operation of large electricity consuming
systems such as the air conditioning system are sus- pended Stop using unnecessary electric components to
reduce electricity consumpt ion. Wait a while until the electric power supply is restored.
Warning messageDetails/Actions
(Flashes)

6158-2. Steps to take in an emergency
8
When trouble arises
RC200t_RC F_EE(OM24728E)
OnceCon- tinuous
An attempt was made to lock the
doors using the smart entry & start system while the electronic key wasstill inside the vehicle.
 Retrieve the electronic key from the vehicle and lock thedoors again.
An attempt was made to lock either
door by opening a door and putting the inside lock button into the lockposition, then closing the door by
pulling on the outside door handle with the electronic key still inside thevehicle.
 Retrieve the electronic key from the vehicle and lock thedoors again.
An attempt was made to lock the
doors other than using the smart entry & start system while the elec-tronic key was still inside the vehicle.
 Retrieve the electronic key from the vehicle and lock the
doors again.
Once
The electronic key has a low battery.
 Replace the electronic key bat- tery. ( P. 563)
Once
The steering lock could not be released within 3 seconds of the
engine switch being pressed.  Press the engine switch while depressing the brake pedal and
moving the steering wheel left and right.
InteriorbuzzerExteriorbuzzerWarning messageDetails/Actions
(Flashes)
(Flashes)

6168-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
Once
Indicates a malfunction in the smart
entry & start system  Have the vehicle inspected by any authorized Lexus dealer or
repairer, or another duly quali- fied and equipped professional.
Once
• When the doors were unlockedwith the mechanical key and thenthe engine swit ch was pressed,
the electronic key could not be detected in the vehicle.• The electronic key could not be
detected in the vehicle even after the engine switch was pressedtwo consecutive times.
 Touch the electronic key to the engine switch while depressingthe brake pedal.
Once
During an engine starting procedurein the event that the electronic key
was not functioning properly ( P. 652), the engine switch was touchedwith the electronic key.
 Press the engine switch within 10 seconds of the buzzer sound-ing.

Indicates that: • With the engine switch off, the
doors were unlocked and then the driver’s door was opened andclosed
• The engine switch was turned to ACCESSORY mode withoutstarting the engine
• The shift lever was shifted to P or N from another position with theengine switch in IGNITION ON
mode.  Press the engine switch while depressing the brake pedal.
InteriorbuzzerExteriorbuzzerWarning messageDetails/Actions
(Flashes)
(Flashes)

6198-2. Steps to take in an emergency
8
When trouble arises
RC200t_RC F_EE(OM24728E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the engine.
●Turn on the emergency flashers. (P. 580)
If you have a flat tire (vehicles with a spare tire)
Your vehicle is equipped with a spare tire. The flat tire can be replaced with
the spare tire.
For details about tires: P. 535
WARNING
■If you have a flat tire
Do not continue driving with a flat tire. Driving even a short distance with a flat tire can damage the tire and the wheel beyond
repair, which could result in an accident.
Before jacking up the vehicle

6288-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
Raise the vehicle until the tire is
slightly raised off the ground.
Remove all the wheel nuts and the
tire.
When resting the tire on the ground,
place the tire so that the wheel design faces up to avoid scratching the wheelsurface.
4
5
WARNING
■Replacing a flat tire
●Do not touch the disc wheels or the area around the brakes immediately after thevehicle has been driven.
After the vehicle has been driven the disc wheels and the area around the brakes will be extremely hot. Touching these areas wi th hands, feet or other body parts while changing a tire, etc. may result in burns.
●Failure to follow these precautions could cause the wheel nuts to loosen and the tireto fall off, resulting in death or serious injury.
• Never use oil or grease on the wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tightened, leading to bolt or disc wheel damage. In addition, the oil or grease can cause the wheel nuts to loosen and the wheel may fall off, causing a serious accident. Remove any oil or
grease from the wheel bolts or wheel nuts. • Have the wheel nuts tightened with a torque wrench to 103 N•m (10.5 kgf•m,76 ft•lbf) as soon as possible after changing wheels.
• Do not attach a heavily damaged wheel or nament, as it may fly off the wheel while the vehicle is moving.• When installing a tire, only use wheel nuts that have been specifically designed for
that wheel. • If there are any cracks or deformations in the bolt screws, nut threads or bolt holesof the wheel, have the vehicle inspected by any authorized Lexus dealer or
repairer, or another duly qualif ied and equipped professional.

6328-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
WARNING
■When using the spare tire
●Remember that the spare tire provided is specifically designed for use with your vehi- cle. Do not use your spare tire on another vehicle.
●Do not use more than one spare tires simultaneously.
●Replace the spare tire with a standard tire as soon as possible.
●Avoid sudden acceleration, abrupt steerin g, sudden braking and shifting operations
that cause sudden engine braking.
■When the spare tire is attached
The vehicle speed may not be correctly detected, and the following systems may not
operate correctly:
■Speed limit when using the spare tire
Do not drive at speeds in excess of 80 km/h (50 mph) when a spare tire is installed on the vehicle.
The spare tire is not designed for driving at high speeds. Failure to observe this precau- tion may lead to an accident cau sing death or serious injury.
■After using the tools and jack
Before driving, make sure all the tools and jack are securely in place in their storage location to reduce the possibility of personal injury during a collision or sudden brak- ing.
NOTICE
■Driving with tire chains and the spare tire
Do not fit tire chains to the spare tire. Tire chains may damage the vehicle body and adversely affect driving performance.
■When replacing the tires
When removing or fitting the wheels, tires or the tire pressure warning valve and trans- mitter, contact any authorized Lexus dealer or repairer, or another duly qualified andequipped professional as the tire pressure warning valve and transmitter may be dam-
aged if not handled correctly.
• ABS & Brake assist
•VSC •TRC• Cruise control (if equipped)
• Dynamic radar cruise control (if equipped)• PCS (if equipped)
•EPS • Adaptive Variable Suspension System (if equipped)
• LDA (Lane departure alert)
(if equipped) • VDIM (Vehicle Dynamics IntegratedManagement)
• Tire pressure warning system • Lexus parking assist monitor (if equipped)
• Lexus parking assist-sensor (if equipped)• Navigation system (if equipped)

6348-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the engine.
●Turn on the emergency flashers. (P. 580)
●Check the degree of the tire damage.
A tire should only be repaired with the
emergency tire puncture repair kit if
the damage is caused by a nail or screw
passing through the tire tread.
• Do not remove the nail or screw
from the tire. Removing the object
may widen the opening and
disenable emergency repair with the
kit.
• To avoid sealant leakage, move the vehicle until the area of the puncture, if
known, is positioned at the top of the tire.
■A flat tire that cannot be repaired with the emergency tire puncture repair kit
In the following cases, the tire cannot be repaired with the emergency tire puncture repair kit. Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
●When the tire is damaged due to driving without sufficient air pressure
●When the tire lost air pressure due to a crack or damage in the tire sidewall
●When the tire is visibly separated from the wheel
●When the cut or damage to the tread is 4 mm (0.16 in.) long or more
●When the wheel is damaged
●When 2 or more sharp objects, such as nails or screws, have passed through the tread on a single tire
●When there is more than one hole or cut in the damaged tire
●When the sealant has expired
Before repairing the vehicle

6468-2. Steps to take in an emergency
RC200t_RC F_EE(OM24728E)
WARNING
■When fixing the flat tire
Observe the following precautions. Failure to do so may result in death or serious injury.
●Stop your vehicle in a safe and flat area.
●Do not touch the wheels or the area around the brakes immediately after the vehicle has been driven.
After the vehicle has been driven, the wheels and the area around the brakes may be extremely hot. Touching these areas with hands, feet or other body parts may result inburns.
●Connect the valve and hose securely with the tire installed on the vehicle.
• If the hose is not properly connected to the valve, air leakage may occur or sealant may be sprayed out.
• If the hose comes off the valve while inflating the tire, there is a risk that the hose will move abruptly due to air pressure.• After inflation of the tire has completed, the sealant may splatter when the hose is
disconnected or some air is let out of the tire.
●Follow the operation procedure to repair the tire. If the procedure is not followed, the
sealant may spray out.
●Keep back from the tire while it is being repaired, as there is a chance of it bursting while the repair operation is being performe d. If you notice any cracks or deforma-
tion of the tire, turn off the compressor sw itch and stop the repair operation immedi- ately.
●The kit may overheat if operated for a long period of time. Do not operate the com-
pressor continuously for more than 35 minutes.
●Parts of the kit become hot during operatio n. Be careful handling the kit during and after operation. Do not touch the metal part around the connecting area between the
bottle and compressor. It will be extremely hot.
●Do not attach the vehicle speed warning sticker to an area other than the one indi- cated. If the sticker is attached to an area where an SRS airbag is located, such as the
pad of the steering wheel, it may preven t the SRS airbag from operating properly.
■Driving to spread the liquid sealant evenly
●Drive the vehicle carefully at a low speed. Be especially careful when turning and cor-
nering.
●If the vehicle does not drive straight or you feel a pull through the steering wheel, stop the vehicle and check the following:
• Tire condition. The tire may have separated from the wheel. • Tire inflation pressure. If tire inflation pressure is 130 kPa (1.3 kgf/cm2 or b ar, 1 9 p si)or below, this may indica te severe tire damage.

6498-2. Steps to take in an emergency
8
When trouble arises
RC200t_RC F_EE(OM24728E)
One of the following may be the cause of the problem:
●One or both of the battery terminals may be disconnected.
●The battery may be discharged. (P. 654)
●There may be a malfunction in the steering lock system.
Contact any authorized Lexus dealer or repairer, or another duly qualified and equipped professional if the problem cannot be repaired, or if repair procedures are unknown.
When the engine does not start, the foll owing steps can be used as an interim
measure to start the engine if the engine switch is functioning normally:
Set the parking brake.
Shift the shift lever to P.
Turn the engine switch to ACCESSORY mode.
Press and hold the engine switch for about 15 seconds while depressing the
brake pedal firmly.
Even if the engine can be started using the above steps, the system may be mal-
functioning. Have the vehicle inspected by any authorized Lexus dealer or
repairer, or another duly qualified and equipped professional.
The starter motor does not turn over , the interior lights and headlights
do not turn on, or the horn does not sound.
Emergency start function
1
2
3
4