electronic key LEXUS RX350 2011 User Guide

31
1

Before driving
1-2. Opening, closing and locking the doors
Smart access system with push-button start
The following operations can be performed simply by carrying the elec-
tronic key (including the card key) on your person, for example in your
pocket.
(The driver should always carry the electronic key.)
Locks and unlocks the side doors (→P. 32)
Locks and unlocks the back door (→P. 32)
Starts the engine (→P. 153)
Electronic keyElectronic key
Electronic key

34
1-2. Opening, closing and locking the doors
nEffective range (areas within which the electronic key is detected)
When locking or unlocking
the doors
The system can be operated
when the electronic key is
within about 2.3 ft. (0.7 m) of
an outside door handle. (Only
the doors detecting the key
can be operated.)
When starting the engine
or changing “ENGINE
START STOP” switch
modes
The system can be operated
when the electronic key is
inside the vehicle.
nOperation signals
A buzzer sounds and the emergency flashers flash to indicate that the doors have
been locked/unlocked. (Locked: Once; Unlocked: Twice)
nWhen the door cannot be locked by the lock sensor on the upper part of the door
handle
Touch both lock sensors on the upper and
lower part of the door handle simultaneously.

37
1-2. Opening, closing and locking the doors
1

Before driving
lWhen the electronic key is in contact with, or is covered by the following metal-
lic objects

38
1-2. Opening, closing and locking the doors
nNotes for locking the doors
lTouching the door lock sensor while wearing gloves may delay or prevent lock
operation. Remove the gloves and touch the lock sensor again.
lWhen the lock operation is performed using the lock sensor, recognition signals
will be shown up to two consecutive times. After this, no recognition signals will
be given.
lIf the door handle becomes wet while the electronic key is within the effective
range, the door may lock and unlock repeatedly. Place the key in a position 6 ft.
(2 m) or more separate from the vehicle while the vehicle is being washed. (Take
care to ensure that the key is not stolen.)
lIf the electronic key is inside the vehicle and a door handle becomes wet during
a car wash, a message may be shown on the multi-information display and a
buzzer will sound outside the vehicle. To turn off the alarm, lock all the doors.
lThe lock sensor may not work properly if it comes into contact with ice, snow,
mud, etc. Clean the lock sensor and attempt to operate it again, or use the lock
sensor on the lower part of the door handle.
lFingernails may scrape against the door during operation of the door handle.
Be careful not to injure fingernails or damage the surface of the door.
nNotes for the unlocking function
lGripping the door handle when wearing a glove may not unlock the door.
lA sudden approach to the effective range or door handle may prevent the
doors from being unlocked. In this case, return the door handle to the original
position and check that the doors unlock before pulling the door handle again.
lIf there is another electronic key in the detection area, it may take slightly longer
to unlock the doors after the door handle is gripped.
nWhen the vehicle is not driven for extended periods
lTo prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2 m)
of the vehicle.
lThe smart access system with push-button start can be deactivated in advance.
(→P. 6 2 1 )

39
1-2. Opening, closing and locking the doors
1

Before driving
nTo operate the system properly
Make sure to carry the electronic key when operating the system. Do not get the
electronic key too close to the vehicle when operating the system from the outside
of the vehicle.
Depending on the position and holding condition of the electronic key, the key may
not be detected correctly and the system may not operate properly. (The alarm may
go off accidentally, or the door lock prevention may not function.)
nIf the smart access system with push-button start does not operate properly
lLocking and unlocking the doors: Use the mechanical key. (→P. 5 8 1 )
lStarting the engine: →P. 5 8 2
nElectronic key battery depletion
lThe standard battery life is 1 to 2 years. (The card key battery life is about a year
and a half.)
lIf the battery becomes low, an alarm will sound in the cabin when the engine
stops. (→P. 5 5 6 )
lAs the electronic key always transmits radio waves, the battery will become
depleted even if the electronic key is not used. The following symptoms indicate
that the electronic key battery may be depleted. Replace the battery when nec-
essary. (→P. 4 9 6 )

45
1-2. Opening, closing and locking the doors
1

Before driving
nSecurity feature
→P. 3 5
nPa n i c m o d e
nBack door operation
The back door can be opened even if it is locked. Lock the back door again when
you leave the vehicle. The back door will not lock automatically after it has been
opened and then closed.
nAlarm
Using the wireless remote control to lock the doors will set the alarm system.
(→P. 1 0 3 )
nReversing the operation of the power back door
Pressing the wireless remote control switch again while the power back door is
operating will cause the operation to reverse.
nConditions affecting operation
→P. 3 6
nIf the wireless remote control does not operate properly
Locking and unlocking the doors: Use the mechanical key. (→P. 5 8 1 )
nElectronic key battery depletion
→P. 3 9
When is pressed for longer than
about one second, an alarm will sound inter-
mittently and the vehicle lights will flash to
deter any person from trying to break into or
damage your vehicle.
To stop the alarm, press any button on the
electronic key.

46
1-2. Opening, closing and locking the doors
nWhen the electronic key battery is fully depleted
→P. 4 9 6
nCustomization
Settings (e.g. door unlocking function) can be changed.
(Customizable features →P. 6 2 1 )

48
1-2. Opening, closing and locking the doors
Locking the front doors from the outside without a key
Move the inside lock button to the lock position.
Close the door.
The door cannot be locked if the “ENGINE START STOP” switch is in
ACCESSORY or IGNITION ON mode, or the electronic key is left
inside the vehicle.
The key may not be detected correctly and the door may be locked.
Rear door child-protector lock
The door cannot be opened from
inside the vehicle when the lock is
set.
These locks can be set to prevent
children from opening the rear
doors. Push down on each rear
door switch to lock both rear
doors.
STEP1
STEP2
nImpact detection door lock release system
In the event that the vehicle is subject to a strong impact, all the doors are unlocked.
Depending on the force of the impact or the type of accident, however, the system
may not operate.
nUsing the mechanical key
The doors can also be locked and unlocked with the mechanical key. (→P. 5 8 1 )
nIf a wrong key is used
The key cylinder rotates freely to isolate inside mechanism.
nCustomization
Settings (e.g. unlocking function using a key) can be changed.
(Customizable features →P. 6 2 1 )

51
1-2. Opening, closing and locking the doors
1

Before driving
nOpening the back door from outside the vehicle (vehicles with a
power back door)
Using the back door opener button*
When the back door is
unlocked: Press the back door
opener button.
When the back door is locked:
While carrying the electronic
key on your person, press and
hold the back door opener but-
ton or press it twice.
*: This setting must be customized
at your Lexus dealer.
Using the wireless remote control
→P. 4 3
nOpening the back door from inside the vehicle (vehicles with a
power back door)
Press the switch to open/close.
Pressing the switch again while
the power back door is operat-
ing will cause the operation to
reverse.

144
2-1. Driving procedures
Driving the vehicle
Starting off on a steep uphill
Make sure that the parking brake is set and shift the shift lever to
D.
Gently depress the accelerator pedal.
Release the parking brake.
The following procedures should be observed to ensure safe driving.
nStarting the engine
→P. 1 5 3
nDriving
With the brake pedal depressed, shift the shift lever to D.
(→P. 1 5 9 )
Release the parking brake. (→P. 164)
Gradually release the brake pedal and gently depress the
accelerator pedal to accelerate the vehicle.
nStopping
With the shift lever in D, depress the brake pedal.
If necessary, set the parking brake.
If the vehicle is to be stopped for an extended period of time, shift the
shift lever to P or N. (→P. 1 5 9 )
n Parking the vehicle
With the shift lever in D, depress the brake pedal.
Set the parking brake. (→P. 1 6 4 )
Shift the shift lever to P. (→P. 1 5 9 )
If parking on a hill, block the wheels as needed.
Press the “ENGINE START STOP” switch to stop the engine.
Lock the door, making sure that you have the electronic key on
your person.
STEP1
STEP2
STEP3
STEP1
STEP2
STEP1
STEP2
STEP3
STEP4
STEP5
STEP1
STEP2
STEP3