warning light LUCID AIR 2022 Owners Manual

Horn 68Drive Selector 69Using the Drive Selector 69
Vehicle Creep 69
Drive Modes 70
Using Neutral 70
Drive Modes 70
Limited Power Mode 70
Mirrors 72
Adjusting the Exterior Side Mirror Position 72
Interior Rear View Mirror 72
Exterior Lights 73
Exterior Lights Control 73
High Beam Headlights 73
Rear Fog Light 74 Turn Signals 74Hazard Warning Lights 75
Interior Lights 76
Interior Lights 76
Ambient Lighting 76
Wipers and Washers 77
Wipers 77
Washers 77
Brakes 78Braking Systems 78
Anti-Lock Braking System (ABS) 78
Regenerative Braking 79
Vehicle Hold 80
Parking Brake 80
Brake Pad Wear 81
Lucid Stability Control 82
Lucid Stability Control 82
Getting Maximum Range 83
Driving Tips to Maximize Range 83
Heating, Ventilation Air Conditioning 84
Temperature Control 84
Defrost 85
Interior Equipment 86
Sun Visors 86
Glove Box 86

Hood
Hood Opening and Closing
In the case of an unlatched hood,
the red Door Open warning indicator appears on the Cockpit Panel. If this
occurs, Lucid recommends you stop
the vehicle in a safe location and place the
vehicle in P (Park). Then check if the hood is correctly closed.
If the vehicle is in D (Drive) or R (Reverse) and
the hood is unlatched, it will be highlighted
red.
Opening the hood
Note: All electrical unlatching of the hood is
disabled when the vehicle is in motion.
To electronically open and close the hood: -Use the Lucid mobile app.
- On the Pilot Panel, select
and press
the
hood opening icon.
- On the Pilot Panel, select
>
DOORS and press the hood
opening icon.
- On the Left Pilot Panel, press the
hood opening icon.
- Press and hold the key fob within
6.5 feet (2 m) of the front trunk.
Once you have successfully unlatched the
hood, you may raise it. The hood has two gas
struts to aid in opening and to hold it in the
open position.
Note: In frigid temperatures, you may find that
the gas struts do not hold the hood open as
firmly as they do in warmer temperatures.
Closing the hood automatically
To close the hood using the power-assist
system:
-Use the Lucid mobile app.
- Select
and press the hood
close icon on the Pilot Panel.
- Select
> DOORS and press the
hood close icon on the Pilot Panel.
- Press and release the close button on
the front edge of the frunk.
Automatic movement stop
If anything obstructs the hood to prevent it
from opening or closing, it will stop moving.
Note: The Cockpit Panel alerts you if the hood
stops automatically.
If the hood stops due to an obstruction,
remove it and try to open or close again. If it cannot be opened or closed a second time,
try to operate the hood manually.
Closing the hood manually
Note: Some models may come equipped with
Power Opening and Closing Hood systems.
Opening and Closing24

Curtain airbagsWARNING: Make sure that passengers
do not lean their heads against the
doors. In the event of a collision,
the curtain airbag deploys from the
headliner and may cause injury.WARNING: Never hang or attach
heavy objects from the grab handles
on the headliner. The hooks are for
lightweight garments (not for hard
objects).
The curtain airbags are designed to protect
the head in severe frontal crashes with a lateral component, severe side impacts, orrollovers. They do not inflate in all frontal
impacts and do not inflate alone in a rear
impact.
Note: Curtain airbags can help prevent
occupants from being thrown from the vehicle
in the event of a vehicle rollover.
Obstruction of Airbags
WARNING: Do not allow passengers to
obstruct the operation of the airbags
by placing feet, knees, any other part
of the body, or any other objects in
contact with, or in close proximity to,
an airbag module.WARNING: Do not attach or position
items on an airbag cover that could
interfere with the inflation of the
airbag or be propelled inside your
vehicle and injure occupants.WARNING: Never place your arm over
an airbag cover. A deploying airbag
can cause serious fractures or other
injuries.
For the airbags to correctly deploy,
obstructions cannot intervene between an
airbag and the occupant.
The following are examples of the type
of obstructions that could impede the
correct operation of the airbags or jeopardize
personal safety in the event of an airbag
deployment:
-Accessories attached to or obscuring an
airbag cover (for example, attached to
the roof lining, door pillar trim, or the
front seat backrests)
- Items of hand luggage, or other objects
placed on an airbag cover
- Feet, knees, or any other part of the
anatomy in contact with, or in close
proximity to, an airbag cover
- Head, arms, or any part of the anatomy
in contact with, or in close proximity to,
a seat-mounted side airbag
- Objects (such as items of clothing)
hanging from the handles attached to the headliner
- Objects (such as items of clothing or
cushions) draped over the part of the
front seat containing the airbag
- Seat covers/accessory seat covers over
a front seat; in particular, seat covers
that have not been designed for use
with seat-mounted side airbags. If
in doubt, consult your Lucid Service
Center .Seating & Safety Restraints49

If you think the passenger airbag status is incorrect, check for the following:-Objects lodged underneath the seat
- Objects wedged between the seat cushion and the center console
- Objects hanging off the back off the seat
- Cargo interference with the seat
- Rear-seat passengers pushing or pulling on the front passenger seat
Any of the conditions listed above may cause the occupancy sensor to incorrectly interpret the
weight of the occupant or object as either heavier or lighter than the real weight.
Depending on the input received from the occupancy sensor, the passenger airbag status indicator
operates as follows:Front Passenger Seat OccupancyPassenger Airbag StatusPassenger Airbag Status
IndicatorAirbag SRS Warning
IndicatorCompletely empty/ low-weight
object *1DeactivatedOFF-Child restraint seat with infantDeactivated *2OFF-ChildDeactivated*3OFF-AdultActivated*4ON-System malfunctionDeactivatedOFFON
*1
A low-weight object or occupant is classified as weighing less than 52 lb (23.5 kg). The movement
of a low-weight occupant or object while your vehicle is in motion may cause the status indicator to
switch states occasionally.
*2 Never install a rear-facing child restraint system on the front passenger seat. A forward-facing
child restraint system should only be installed on the front passenger seat when it is unavoidable.
*3 For some children (a child in a seat, booster seat, or convertible seat), the system may not
recognize them as a child. Factors that may affect this can be the physique or posture.
*4 The system judges a person of adult size as an adult. When a smaller adult sits in the front
passenger seat, the system may not recognize them as adults, depending on their physique and
posture.
Note: It is possible to receive an intermittent indicator status with an empty seat. This is part of
the system

High beam headlights activeLow high-voltage battery State of Charge (SoC)12V battery charging system fault detectedHigh temperature detected for high-voltage batteryLow temperature detected for high-voltage battery
Brake System Warning. Call Lucid Service Center.Brake System Warning. Call Lucid Service Center.Excessive brake wear detected
Left turn signal active
Driving & Operating59

Hazard Warning Lights
Note: The hazard warning lights can be
operated even when a key fob is not in the
vehicle.
To turn on the hazard warning lights, press the switch located on the overhead console.
All turn signals will flash along with the turn
signal indicators on the Center Cockpit Panel.
Press the switch again to switch off the
hazard warning lights.
Note: You should only use hazard warning
lights in an emergency to warn other road
users of a breakdown or other potential
danger. Remember to switch off when the
hazardous situation has been resolved.
After a collision
If you are involved in a collision that causes
the airbags to be deployed, the hazard
warning lights will automatically switch on.
Driving & Operating75

ABS warning indicatorThe ABS indicator displays on
the Cockpit Panel, along with a
notification message. If illuminated,
the ABS is disabled. Contact a Lucid
Service Center as soon as possible to have
the fault repaired.CAUTION: Even when ABS is disabled,
the pedal-operated braking system
remains operational. Be aware that
braking distances may increase and
wheels may lock under heavy braking.
Regenerative Braking
WARNING: If driving the vehicle in
reduced traction conditions (that is,
icy or snowy conditions), the use
of High regenerative braking level
may cause traction control to operate
more frequently. Lucid recommends
switching to Standard level when
driving in such conditions.
Whenever the vehicle is moving and your foot
is off the accelerator, regenerative braking
slows the vehicle and feeds energy back to
the high-voltage battery.
While you should still use the brake
pedal whenever needed to stop safely, you
can take advantage of regenerative braking
by anticipating your stops and reducing
accelerator pedal position.
Note: If regenerative braking is aggressively
slowing your vehicle (such as when your foot
is completely off the accelerator pedal at highway speeds), the brake lights turn on to
alert others that you are slowing down.
During regenerative braking, the charge/power
meter that arcs over the speedometer shows the current amount of energy being generated
and fed back to the high-voltage battery.
The amount of generated energy being fed
back to the high-voltage battery can vary
depending on the current state of the battery
and the regenerative braking setting being used. For example, regenerative braking maybe limited if the battery is extremely hot or
cold or if the battery is already charged to its
maximum allowable level.
Regenerative braking settings
On the Pilot Panel, press
> Vehicle
> Drive Settings, then press to select between
two levels of Regenerative Braking:
-Standard - Provides the standard
amount of regenerative braking.
When you release the accelerator, the
vehicle takes longer to slow down and
coasts further than if set to High.
- High - Provides the maximum amount of
regenerative braking.
When you release the accelerator, the
vehicle slows down faster, reducing the
need to use the brakes.
Note: Should regenerative braking levels be
limited, you

Interior Equipment
Sun Visors
To use a sun visor, fold it down from its
stowed position. Sun visors can also pivot
towards the side window by releasing it from
the retaining clip.
Note: Make sure the sun visor is secured
by the retaining clip when returning it to its
stowed position.
Both sun visors have a covered mirror. Raise the cover to use the mirror; an integrated light
automatically turns On. The light turns Off
when the cover is closed.
Sun visor battery replacement
WARNING: Each sun visor contains
three coin/button type batteries.
These batteries contain toxic and
corrosive substances. Batteries are
a chemical burn hazard and should never be ingested. If a battery is
swallowed, it can cause serious
internal burns and may even lead to
death.
- Keep new and used batteries out of
the reach of children.
- If you think batteries may have
been swallowed or placed inside any part of the body, seek
immediate medical attention.
Due to the unique design of your vehicle, the
sun visors use batteries to power the mirror
lights.
Note: The batteries have an estimated life
of approximately two years based on typical
usage.
To replace the batteries:
With the sun visor in its stowed position, slide
the battery holder towards the front of the
vehicle.
Remove the old batteries.
Install new batteries and avoid touching the
flat surfaces of the batteries if possible, as
finger marks can reduce battery life. Wipe
the batteries clean before installation. Fit the
battery with the “+” side facing upwards.
Reinstall the battery holder in the sun visor.
Note: Always replace all three batteries with
new CR2032 batteries.
Glove Box
The glove box is opened using the Pilot Panel.
Select
> GLOVEBOX. To close, push the
glove box cover until it latches.
Driving & Operating86

user is encouraged to try to correct the
interference by one or more of the following
measures:
-Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on
a circuit different from that to which thereceiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
12 Volt Power SocketWARNING: Close the cover when not
in use. If this outlet is mishandled, it
may cause an electric shock.CAUTION: The 12 Volt power socket
should not be used with a cigarette
lighter. Lighters could potentially
cause heat damage to the socket.
A 12 Volt power socket is located in the trunk.
Remove the RH floor panel to access the
power socket.
Although the power socket is primarily
provided for use with the tire repair kit, it can
also be used for other accessories requiring
up to 15A or a maximum of 180 watts.
Driving & Operating90

-The target vehicle will not be highlighted
Once the accelerator is released, Adaptive
Cruise Control should automatically resume
and return to the cruise speed set by the
driver. The Cockpit Panel displays the active
Adaptive Cruise Control mode.
Adjusting following distanceWARNING: It is your responsibility as
the driver to determine and maintain
a safe following distance at all times.
Do not rely on Adaptive Cruise Control
to maintain an accurate or appropriate
following distance.WARNING: Never depend on Adaptive
Cruise Control to adequately slow
down the vehicle to avoid a collision.
Always watch the road in front of you
and be prepared to take corrective
action at all times. Failure to do so
can result in a collision with the risk
of serious injury or death.
To adjust the vehicle