start stop button MAZDA CX90 2024 Owners Manual

Turning on the alarm
Pressing the panic button for 1 second
or more will trigger the alarm for about
2 minutes and 30 seconds, and the
following will occur:
The horn sounds intermittently.The hazard warning lights flash.
Tu r n i n g off the alarm
The alarm stops by pressing any button
on the key.
Operational Range
The system operates only when the
driver is in the vehicle or within
operat ional range while the key is
being carried.
Starting the hybrid system
NOTE
Starting the hybrid system may be
possible even if the key is outside of
the vehicle and extremely close to a
door and window, however, always
start the hybrid system from the
driver's seat.
If the vehicle is started and the key is
not in the vehicle, the vehicle will not
restart after it is shut off and the
vehicle power is switched off.
The luggage compartment is out of
the assured operational range,
however, if the key (transmitter) is
operable the hybrid system will start.
With the advanced keyless function

1. Interior antenna
2. Operational range

Without the advanced keyless
function

1. Interior antenna
2. Operational range

NOTE
The hybrid system may not start if the
key is placed in the following areas:
Around the dashboardIn the storage compartments such as
the glove compartment or the center
console
Opening/closing
Key
4-7
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04

On roads with high driving resistance
such as deep-snowy or sandy roads,
or on steep slopes, a high load is
applied to the transmission, causing
excessive heat generation. Under
these driving conditions, pay
attention to the following points.
 Stop and hold the vehicle on a
steep slope with the brake pedal,
not the accelerator pedal. Do not
use the accelerator pedal to
prevent the vehicle from rolling.
 Avoid using the accelerator pedal
and the brake pedal at the same
time.
 Start driving the vehicle in the D or
R position according to the
direction of travel (avoid starting in
manual mode).
If you do not follow the above
precautions, the transmission may
overheat. If a message, such as
transmission cooling, is displayed, it
is necessary to temporarily stop the
vehicle to cool the transmission.How to Use the Selector Lever
Operating the Selector Lever
1. Start the hybrid system.
2. Operate the selector lever.
Selector lever
operation Operation condition
Shift from P
position to R position Depress the brake pedal and
press the selector lever button
to operate.
Shift from R
position to N position
Shift the lever without pressing
the selector lever button.
Shift from N
position to D
position
Shift from D
position to N position
Shift from N
position to R position Press the selector lever button
to shift the lever.
Shift from R
position to P
position
Driving
Selector Lever
5-47
CX-90_8KG7-EA-22L_Edition1_new 2022-11-17 16:05:04