alarm MAZDA MODEL CX-3 2018 Smart Start Guide (in English)

4 MAZDAUSA.COM
ADVANCED KEYLESS ENTRY SYSTEM
This system allows you to lock and unlock t\Xhe doors without taking the key out.While Carrying the Advanced Key:•
Unlock the driver’s door by pushing
the driver’s door request switch once.
•
Unlock all doors by pushing the
driver’s door request switch once or twice (depending on personalization
setting, p. 10) OR by pushing the passenger’s door request switch once.
•
Lock all doors (and liftgate) by
pushing any request switch once.
•
To open the liftgate from outside
the vehicle: Open the p\.ower liftgate using the liftgate opener.
NOTE: Only vehicles equipped with th\.e
Advanced Keyless Entry \fystem allow you to lock and unlock \.the doors with the
door request switches (without taking the key out of your purse or pocket).
Vehicles equipped with th\.e Keyless Entry \fystem do not have request switches on the doors/liftgate. To lock and unlock \.the doors, the corresponding
transmitter button must be pushed.
Refer to your Owner’s Manual for additional details about
“Personalization Features”.
Door request switch
Lock
Unlock
Panic
alarm
Liftgate
request switch Liftgate

opener
CAUTION:
The key may not
be detected if
placed in the cup holder or too far
from the \fTART/
\fTOP ENGINE button. If the RED
KEY indicator light illuminates
in the instrument
cluster, the key is not being
detected. Move the key closer to
the \fTART/\fTOP
ENGINE button.
CAUTION:
Make sure the
engine is OFF and take the key with
you when leaving the vehicle.
When locking the doors using
the inside door
switches, be
careful not to leave the key
inside the vehicle
to prevent lock-out.
ADVAN\bED KEYLE\f\f ENTRY
(IF EQUIPPED)
2940109_18b CX-3 SSG_060817.indd 46/8/17 2:37 PM

6 MAZDAUSA.COM
TIRE PRESSURE MONITORING SYSTEM (TPMS)
For your safety, the CX\f3 is
equipped with TPMS that detects low tire pressure in one or more
tires. If the tire pressure starts
getting low in one or more tires, the system alerts the driver by
turning on a light in the instrument
cluster (p. 40\f41) and sounding an
alarm.
WHAT TO DO? Don’t ignore the TPM\f warning light. \ftop and check
your tire pressure (when tires are cold) and inflate the tires to the proper pressure. Properly inflated tires are safer, last longer, and increase fuel economy.
In the following cases, the TPMS must be “initialized” so the system
can operate normally.
• The tire pressure is adjusted (up or down) in one or more tires.
• A tire rotation is performed.
• Any tire or wheel is replaced.
•
The vehicle’s battery is disconnected, replaced or completely dead.
INITIALIZATION PROCESS
(TPMS WARNING LIGHT IS ILLUMINATED)
1 Park the vehicle in a safe place and firmly apply \.the parking brake.
2
Let the tires cool, then adjust the tire pressure to the specified
pressure (see tire label located on the driver’s side door jamb a\.rea)
on all four tires.
3 \fwitch the ignition ON\., but leave the vehicle parked.
4
Push and hold the \.TPM\f “\fet \fwitch" (left side of dash) until the
TPM\f warning light in the instrument cluster flashes twice and a beep sound is heard once.
NOTE: Drastic changes in temperature or altitude can affect the air
pressure in the tires and may cause the TPM\f warning light to turn on.
Verify the tire pressures when driving thr\.ough extreme temperature or altitude changes.
TPMS “Set Switch”
TIRE PRE\f\fURE MONITORING \fY\fTEM
CAUTION:
If the TPM\f “\fet
\fwitch” is pushed
without adjusting the tire pressure,
the system
cannot detect the normal tire
pressure. The
TPM\f warning light may not turn
on, even if the tire pressure is low, or it may turn on if
the tire pressure is normal.
2940109_18b CX-3 SSG_060817.indd 66/8/17 2:37 PM