height MAZDA MODEL CX-7 2007 Quick Tips (in English)
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2007, Model line: MODEL CX-7, Model: MAZDA MODEL CX-7 2007Pages: 14, PDF Size: 1.77 MB
Page 9 of 14

SEATS
Always check the Owner’s Manual for more operating information and safety features 
Shoulder belt
height 
adjustment
To raise: 
Push adjuster up
To lower: 
Pull button (1), slide
down; release button
WARNING: Make sure 
adjuster locks in one of 
its positions
Manual controls
1. Fore-aft adjustment
Lift lever and hold, slide seat,
release lever
2. Raise/lower seat
(Driver’s seat only)
Pull/push lever and release
3. Seat back angle
To adjust: Lift and hold lever,
lean forward or backward 
to tilt seat, release lever4. Head restraint
To raise/lower: Pull up/hold
release button (8) and 
push down
Power driver’s seat*
5. Raise/lower front of seat
Pull/push front of switch vertically
Fore/aft adjustment
Slide switch horizontally 
Raise/lower rear of seat
Pull/push rear of switch vertically
Raise/lower seat 
Pull/push center of switch 
vertically
6. Seatback angle
Press front/rear of switch 
to change angle
7. Lumbar support 
adjustment* 
Pull lever forward repeatedly 
for more support
Seats
Seats
WARNINGS: Do not adjust
seats while driving
Safety belts must always be
worn when vehicle is in motion
Air bags are supplemental 
and do not replace safety 
belt usage
Always wear your safety belt
and properly secure children 
12 and under in the rear seat
Even with a deactivation 
system, never place rear-facing 
infant-safety seat in front 
of any air bag, an infant is 
in serious danger of being 
injured or killed
If you must install a forward-
facing child-safety seat in 
the front seating position,
move vehicle seat as far 
back as possibleSafety belt emergency
locking mode
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more
Automatic locking mode 
(front passenger and all
rear safety belts only)
Must be used when installing
child-safety seat
To activate: Pull webbing fully 
out of retractor, allow belt to
retract until click is heard; 
belt will only tighten
To disengage: Unbuckle belt and
allow webbing to retract fully
Child-safety seatTo install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner’s Manual 
for proper installation and child
seat tether and LATCH system 
instructions
WARNING: Use age 
appropriate child restraints,
see Owner’s Manual and 
state or province laws
1
4
8
3
2
4
8
6
5
7
1
*Denotes optional equipment