maintenance schedule MAZDA MODEL MPV 2005 (in English) User Guide

Black plate (270,1)
qChanging Coolant (Without Rear
Heater)
Change coolant according to Scheduled
Maintenance (page 8-3).
CAUTION
lUse only soft (demineralized) water
in the coolant mixture. Water that
contains minerals will cut down on
the coolant's effectiveness.
lDon't add only water. Always add a
proper coolant mixture.
lThe engine has aluminum parts and
must be protected by an ethylene-
glycol-based coolant to prevent
corrosion and freezing.
lDO NOT USE alcohol or methanol
antifreeze. DO NOT MIX alcohol or
methanol with the coolant. This
could damage the cooling system.
lDon't use a solution that contains
more than 60 % antifreeze.
This would reduce effectiveness.
For mixture percentage:
ProtectionVolume
Antifreeze
solutionDemineralizedwater
Above–16°C (3°F) 35% 65%
Above–26°C (–15°F) 45% 55%
Above–40°C (–40°F) 55% 45%
To change coolant
WARNING
Removing the Cooling System Cap:
Removing the cooling system cap
while the engine is running or hot is
dangerous. This might lead to cooling
system and engine damage and could
result in serious injury from escaping
hot coolant or steam. Turn off the
engine and wait until it's cool. Even
then, be very careful when removing
the cap. Wrap a thick cloth around the
cap and slowly turn it
counterclockwise to the first stop.
Step back while the pressure escapes.
When you're sure all the pressure is
gone, press down on the cap―still
using a cloth―turn the cap, and
remove it.
1. Remove the cooling system cap.
F
L
Tighten Loosen
TightenLoosen
2. Only when the engine is cool, remove
the radiator drain plug and drain the
coolant into a suitable container.
Properly dispose of the used coolant.
3. Flush out the system with running
water.
8-14
Maintenance and Care
Owner Maintenance
Mazda MPV_8T50-EA-04G_Edition1 Page270
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (271,1)
4. Drain the system completely. Insert and
tighten the plug. Add as much
ethylene-glycol-based coolant mixture
and water as necessary to provide
freezing and corrosion protection.
5. In extremely cold climates, add the
mixture percentage recommended in
the coolant mixture percentage table.
6. Run the engine at idle with the cooling
system cap off. Slowly add additional
coolant if necessary.
7. At this point, wait until the engine
reaches normal operating temperature;
then depress the accelerator two or
three times. Add more coolant, if
necessary, until the system is full.
8. Install the cooling system cap. Inspect
all connections for leaks. Inspect the
level in the coolant reservoir one more
time.
qChanging Coolant (With Rear
Heater)
Have an Authorized Mazda Dealer change
the coolant according to the Scheduled
Maintenance (page 8-3).
Brake Fluid
qInspecting Brake Fluid Level
Inspect the fluid level in the reservoir
regularly. It should be kept at MAX.
The level normally drops with
accumulated distance, a condition
associated with wear of brake linings. If it
is excessively low, have the brake system
inspected by an Authorized Mazda
Dealer.
Maintenance and Care
Owner Maintenance
8-15
Mazda MPV_8T50-EA-04G_Edition1 Page271
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (276,1)
Air Filter
CAUTION
Don't drive without an air filter. This
could result in excessive engine wear.
This air filter may be cleaned with
compressed air and reused, or replaced,
depending on its condition. Unless it is
very dirty, simply shake it to remove
foreign particles. Each time you inspect it,
wipe inside the air cleaner housing with a
damp cloth.
qReplacing the Air Filter
NOTE
If the vehicle is operated in very dusty
or sandy areas, replace the filter more
often than recommended intervals.
1. Remove the bolt and unfasten the
clamps on the air cleaner housing.
2. Separate the air cleaner housing and
remove the filter.
Air filterAir cleaner housing
3. Wipe inside the air cleaner housing
with a damp cloth.
4. Clean or replace the filter.
5. Install in the reverse order of removal.
Replace the filter according to Scheduled
Maintenance (page 8-3).
8-20
Maintenance and Care
Owner Maintenance
Mazda MPV_8T50-EA-04G_Edition1 Page276
Monday, June 28 2004 4:0 PM
Form No.8T50-EA-04G

Black plate (334,1)
H
Headlights
Control ....................................... 5-33
Flashing ...................................... 5-33
High-low beam .......................... 5-33
On reminder ............................... 5-33
Hood Release .................................... 3-23
Horn .................................................. 5-38
I
Ignition
Switch .......................................... 5-2
Illuminated Entry System ................. 6-46
Immobilizer System .......................... 3-27
Indicator Lights ................................. 5-24
Cruise Main ................................ 5-31
Cruise set .................................... 5-32
Headlight high-beam .................. 5-30
O/D OFF .................................... 5-30
Security ...................................... 5-30
Shift position .............................. 5-31
TCS ............................................ 5-31
TCS OFF .................................... 5-31
Turn-signal/hazard warning ....... 5-32
Instrument Cluster ............................. 5-20
Interior Care ...................................... 8-47
Interior Lights ................................... 6-46
J
Jump-Starting .................................... 7-19
K
Keyless Entry System ......................... 3-3
L
Label Information ............................. 10-2
Lane-Change Signals ........................ 5-34
Liftgate .............................................. 3-17
Light Bulbs
Replacement ............................... 8-30
Specifications ............................. 10-6
Lighter ............................................... 6-49
Lighting Control ............................... 5-33
Lubricant Quality .............................. 10-4
Luggage Compartment Light ............ 6-48
M
Maintenance
Introduction .................................. 8-2
Owner maintenance precautions ... 8-8
Owner maintenance schedule ....... 8-7
Scheduled ..................................... 8-3
Map Lights ........................................ 6-47
Mirrors
Outside mirrors .......................... 3-31
Rearview mirror ......................... 3-32
Money-Saving Suggestions ................ 4-7
Moonroof .......................................... 3-24
O
Odometer and Trip Meter .................. 5-21
Outside Mirrors ................................. 3-31
Overhead Console ............................. 6-53
Overhead Lights ................................ 6-46
Overheating ....................................... 7-16
Overloading ...................................... 4-11
P
Paint Damage .................................... 8-42
Parking Brake ..................................... 5-4
11-4
Index
Mazda MPV_8T50-EA-04G_Edition1 Page334
Monday, June 28 2004 4:1 PM
Form No.8T50-EA-04G