maintenance schedule MAZDA MODEL MX-5 MIATA 2002 User Guide

8-14
Maintenance and Care
Owner Maintenance
Form No. 8Q42-EA-01F
5. Pull it out again and examine the level. It’s OK between L and F.
But if it ’s near at or below L, add
enough oil to bring the level to F.
6. Make sure the O-ring is positioned properly before reinserting the
dipstick.
The distance between L and F on the
dipstick represents the following:

Changing Engine Oil and Filter
Change engine oil and filter according to
Scheduled Maintenance (page 8-3).
Please act responsibly
—protect the
environment and take used oil to a
recycling facility. Ask your dealer or a
service station for information. Changing engine oil
1. Warm up the engine for a few minutes
and turn it off. Remove the oil-filler
cap.
2. Remove the drain plug and drain the oil into a suitable container.
3. Replace the plug tightly after the oil has thoroughly drained.
4. Fill the engine with new oil to the F mark on the dipstick.
5. Securely replace the oil-filler cap.
6. Start the engine and inspect around the drain plug for leaks.
7. Turn it off and wait 5 minutes for the oil to return to the oil pan.
Don
’t add engine oil over F. This may
cause engine damage.
L (US qt, Imp qt) 0.8 (0.85, 0.70)
Handling Used Engine Oil:
Continuous contact with used engine
oil is dangerous. It could cause skin
cancer. Always wash with soap and
water immediately after changing oil
and filter.
CAUTION
WARNING
Checking or Changing Engine Oil:
Hot engine oil is dangerous. If the
engine has been running, the engine
oil becomes very hot. You could be
seriously burned. Don ’t check or
change the engine oil when the
engine is hot.
WARNING
Tighten
Loosen
Drain plug
J07L(02MY).book Page 14 Monday, June 11, 2001 4:52 PM

8-16
Maintenance and Care
Owner Maintenance
Form No. 8Q42-EA-01F
If it’s at or near LOW, add enough coolant
to the coolant reservoir to provide
freezing and corrosion protection and to
bring the level to FULL.
Do not overfill.
If new coolant is required frequently,
consult an Authorized Mazda Dealer.

Changing Coolant
Change coolant according to Scheduled
Maintenance (page 8-3). For mixture percentage:
To change coolant
Radiator coolant will damage paint.
Rinse it off quickly.
•
Use only soft (demineralized) water
in the coolant mixture. Water that
contains minerals will cut down on
the coolant
’s effectiveness.
• Don
’t add only water. Always add a
proper coolant mixture.
• The engine has aluminum parts and
must be protected by an ethylene-
glycol-based coolant to prevent
corrosion and freezing.
• DO NOT USE alcohol or methanol
antifreeze. DO NOT MIX alcohol
or methanol with the coolant. This
could damage the cooling system.
• Don
’t use a solution that contains
more than 60 % antifreeze.
This would reduce effectiveness.
CAUTION
CAUTION
Protection Volume
Antifreeze solution Wa t e r
Above −
16° C (3° F) 35% 65%
Above −
26° C (−
15° F) 45 55
Above −
40° C (−
40° F) 55 45
Removing the Cooling System Cap:
Removing the cooling system cap or
drain plug while the engine is
running or hot is dangerous. This
might lead to cooling system and
engine damage and could result in
serious injury from escaping hot
coolant or steam. Turn off the engine
and wait until it ’s cool. Even then, be
very careful when removing the cap
or drain plug. Wrap a thick cloth
around it and slowly turn it
counterclockwise to the first stop.
Step back while the pressure escapes.
When you ’re sure all the pressure is
gone, press down on the cap — still
using a cloth — turn the cap, and
remove it.
WARNING
J07L(02MY).book Page 16 Monday, June 11, 2001 4:52 PM

8-24
Maintenance and Care
Owner Maintenance
Form No. 8Q42-EA-01F
2. Lift off the air filter cover and remove the filter.
3. Wipe inside the air cleaner housing with a damp cloth.
4. Replace the filter.
5. Install in the reverse order of removal.
Replace the filter according to Scheduled
Maintenance (page 8-3). Contamination of either the windshield or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly,
clean the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
Air filter cover
Air filter
Wiper Blades
Hot waxes applied by automatic car
washes have been known to affect the
cleanability of windows.
To prevent damage to the wiper blades,
don’t use gasoline, kerosene, paint
thinner, or other solvents on or near
them.
CAUTION
CAUTION
J07L(02MY).book Page 24 Monday, June 11, 2001 4:52 PM

11-4
Index
Form No. 8Q42-EA-01F
I
IgnitionKeys
............................................ 3-2
Switch
......................................... 5-2
Immobilizer System
......................... 3-28
In Case of Emergency
........................ 7-1
Indicator Lights
................................ 5-22
Cruise set
.................................. 5-28
Headlight high-beam
................ 5-27
O/D OFF
................................... 5-28
Instrument Cluster
........................... 5-17
Interior Care
..................................... 8-48
Interior Light
.................................... 6-37
J
Jump-Starting ................................... 7-13
K
Keyless Entry System ........................ 3-5
Keys
................................................... 3-2
L
Label Information ............................ 10-2
Lane-Change Signals
....................... 5-30
Light Bulbs Replacement
............................. 8-31
Specifications
........................... 10-6
Lighter
.............................................. 6-37
Lighting Control
.............................. 5-29
Lubricant Quality
............................. 10-4
M
Maintenance Introduction
................................. 8-2
Owner maintenance
precautions
................................ 8-11
Owner maintenance
schedule
.................................... 8-10
Scheduled
.................................... 8-3
Manual Transmission Operation
........ 5-8
Mesh Pocket
..................................... 6-40
Meters and Gauges
........................... 5-17
Mirrors Outside mirrors
......................... 3-31
Rearview mirror
........................ 3-32
Money-Saving Suggestions
................ 4-6
O
Odometer and Trip Meter ................ 5-18
Outside Mirrors
................................ 3-31
Overheating
...................................... 7-11
Overloading
...................................... 4-10
P
Paint Damage ................................... 8-41
Parking Brake
..................................... 5-5
Parking in an Emergency
................... 7-2
Power Door Locks
............................. 3-4
Power Steering
................................. 5-13
Fluid
.......................................... 8-19
Power Windows
................................. 3-9
Push-Starting
.................................... 7-15
J07L(02MY)IX.fm Page 4 Monday, June 11, 2001 5:33 PM