buttons MAZDA MODEL SPEED MX-5 MIATA 2005 Owners Manual

Black plate (46,1)
qTransmitter
Integrated key type
Lock button
Unlock button
Trunk button Panic button
Non-key type
Unlock button
Lock button
Panic button
Trunk button
NOTE
l(U.S.A.)
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may cause
undesired operation.
l(CANADA)
This device complies with RSS-210
of Industry CANADA. Operation is
subject to the following two
conditions: (1) this device may not
cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
NOTE
If the lock and unlock buttons are
pressed sequentially, the hazard
warning lights may not flash correctly.
Lock button
To lock the doors, press the lock button
and the hazard warning lights will flash
once.
To confirm that all the doors have been
locked, press the lock button again within
5 seconds. If they are closed and locked,
the horn will sound and the hazard
warning lights will flash once.
3-4
Knowing Your Mazda
Doors and Locks
MX-5 Miata_8T72-EA-04G_Edition2 Page46
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (50,1)
3. Install a new battery (CR2025 orequivalent) into the front portion of the
holder with the positive pole (
)
facing up. Press on the B portion of the
battery to set the battery.
Front of
holder
Front
cover Back cover
B
CAUTION
Do not press any buttons when
replacing the battery. The electronic
code could be altered and cause the
keyless entry system to malfunction.
If the keyless entry system fails to
operate, contact an Authorized Mazda
Dealer.
4. Align the front and back covers and snap the transmitter shut.
qService
If you have a problem with the keyless
entry system, consult an Authorized
Mazda Dealer.
If your transmitter is lost or stolen, bring
all remaining transmitters to an
Authorized Mazda Dealer as soon as
possible for a replacement and to make
the lost or stolen transmitter inoperative.
CAUTION
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user's
authority to operate the equipment.
3-8
Knowing Your Mazda
Doors and Locks
MX-5 Miata_8T72-EA-04G_Edition2 Page50
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (63,1)
lBefore lowering or raising the top, stop
in a safe place off the right-of-way and
park on a level surface.
lMake sure nothing is on the top or near
the back window when raising or
lowering the top.
Even small objects may interfere and
cause damage.
lWhen lowering the top, make sure
objects inside the vehicle aren't blown
away by the wind.
lSecure all loose objects inside before
driving with the top down.
lTo help prevent burglary or vandalism
and to ensure that the passenger
compartment stays dry, close the top
securely and lock all doors when
leaving the vehicle.
lDon't drive through an automatic car
wash; it may damage the top.
lDon't raise or lower the top when the
temperature is below 5 °C (41 °F) ; this
will damage the top material.
lDon't lower the top when it's wet. If the
top dries while folded, it will
deteriorate and shrink.
lLowering the top while it's wet can
also cause water to drip into the
passenger compartment.
lDon't raise or lower the top when the
wind is strong; the wind could damage
the top.
qLowering the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition. 3. Pull down the sunvisors.
Sunvisor
Sunvisor
4. Remove all objects in the top storage
area.
WARNING
Objects in the Storage Area:
Putting heavy or sharp objects in the
top storage area is dangerous.
During a sudden stop or collision, they
can become projectiles that might hit
and injure passengers.
Don't place heavy or sharp objects in
the top storage area.
5. Push the unlock buttons and fully release the top latches.
Unlock button
Top latch
Knowing Your Mazda
Doors and Locks
3-21
MX-5 Miata_8T72-EA-04G_Edition2 Page63
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (65,1)
qRaising the Convertible Top
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors.
Sunvisor Sunvisor
4. Undo the fasteners and straps.
5. Remove the top covering and store it
properly in the trunk.
6. Unlock the top latches and open them fully.
7. Hold the top lift handle and pull the top up and forward until it's against the
windshield header.
Windshield header
8. After securely hooking the top latchesonto the windshield header, push each
latch up with the palm of your hand
until the lock buttons click and the
latches are locked.
CAUTION
Make sure the top is securely locked by
pushing up on it.
Driving with the top unlocked could
damage the top.
NOTE
Make sure the top is securely locked by
pushing up on it. If it still sounds loose
(rattles) after being locked by the top
latches, have it inspected at an
Authorized Mazda Dealer.
Knowing Your Mazda
Doors and Locks
3-23
MX-5 Miata_8T72-EA-04G_Edition2 Page65
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (68,1)
WARNING
Fastening Mechanisms:
It is dangerous to place your hands or
fingers near the fastening
mechanisms. Your hands or fingers
could be caught and injured by the
mechanism. Always keep your hands
and fingers away from the fastening
mechanisms when moving the top.
lWhen removing the hardtop, make sure
the operation is performed by 2
persons.
lBefore removing or installing the
hardtop, be sure you are parked out of
traffic in a flat area near the location
your top is to be stored.
lWhen removing the hardtop, make sure
objects inside the vehicle aren't blown
away by the wind.
lSecure all loose objects inside before
driving with the hardtop removed.
lDon't drive through an automatic car
wash; it may damage the hardtop.
lDon't remove or install the hardtop
when the wind is strong; the wind
could damage the hardtop.
lBefore removing the hardtop, lower the
antenna.
lRemoving the hardtop while it's wet
can cause water to drip into the
passenger compartment.
qRemoving the Detachable
Hardtop
1. Park the vehicle on a level surface and
firmly set the parking brake.
2. Lower the side windows, then turn off the ignition.
3. Pull down the sunvisors.
Sunvisor Sunvisor
4. Push the unlock buttons and fully
release the top latches.
Unlock button
Top latch
3-26
Knowing Your Mazda
Doors and Locks
MX-5 Miata_8T72-EA-04G_Edition2 Page68
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (69,1)
5. Push the unlock buttons and fullyrelease the side latches.
Unlock button
Side latch
6. Disconnect the rear window defrostercoupler.
Rear window defroster coupler
7. Slide the hardtop rearward whilepressing down on the rear deck latches
to unlock the latches.
Rear deck latch
Hardtop
8. Lift the hardtop straight off the body toprevent damage to the rear deck latches
and studs.
Rear deck stud
WARNING
Windshield's Edges:
Not being careful of the windshield's
edges when getting into or out of the
vehicle is dangerous. The windshield's
edges could scratch and cause
injuries.
Be careful of the windshield's edges
when getting into or out of the vehicle.
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lUse extreme care when carrying the
hardtop to prevent scratching or
other damage to it.
Knowing Your Mazda
Doors and Locks
3-27
MX-5 Miata_8T72-EA-04G_Edition2 Page69
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (71,1)
5. Align the rear deck latches with therear deck studs and set the hardtop
squarely onto the body.
Rear deck stud
Hardtop
Rear deck latch
Rear deck latch
6. Slide the hardtop forward while pressing down on the rear deck latches
to lock the latches, and then verify that
they are secure by attempting to lift the
rear of the hardtop.
Rear deck latch
CAUTION
lBe careful not to strike the body with
any of the protruding hardtop
latches.
lThe rear defogger grid and the
defogger cord could be damaged
when removing or installing the top.
Make sure the rear defogger grid
isn't folded and the defogger cord
isn't caught between the vehicle's
body and the top.
7. Push each top latch up with the palm of your hand until the lock buttons click
and the latches are locked.
Knowing Your Mazda
Doors and Locks
3-29
MX-5 Miata_8T72-EA-04G_Edition2 Page71
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (72,1)
8. Push each side latch down with thepalm of your hand until the lock
buttons click and the latches are
locked.
Side latch
CAUTION
After installation, verify that all latches
are secure. Operating the vehicle with
unlocked latches may cause hardtop
damage or loss.
9. Reconnect the rear window defroster coupler.
Rear window defroster coupler
NOTE
If the top rattles even when all latches
are secure, drive slowly and contact an
Authorized Mazda Dealer for
inspection.
qDetachable Hardtop Appearance
Care
Refer to detachable hardtop maintenance
(page 8-47) for information on detachable
hardtop appearance care.
3-30
Knowing Your Mazda
Doors and Locks
MX-5 Miata_8T72-EA-04G_Edition2 Page72
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (152,1)
qOperating the Radio
Band selector button Satellite button*
Display
Channel preset buttons Scan button
Manual tuning dial
*For reception of optional SIRIUS digital satellite radio. Used on vehicles equipped with the separately sold SIRIUS digital satellite radio\
unit.For information on use, read the manual accompanying the SIRIUS unit.
Subscription of SIRIUS digital satellite radio service is available in the U.S. (Except Alaska and Hawaii). Seek tuning
button
Auto memory
button/Electric
serial number
button*
Radio ON
Press a band selector button (
)to
turn the radio on.
Band selection
Successively pressing the band selector
button (
) switches the bands as
follows: FM1 →FM2 →AM.
The selected mode will be indicated. If
FM stereo is being received, “ST ”will be
displayed.
NOTE
If the FM broadcast signal becomes
weak, reception automatically changes
from STEREO to MONO for reduced
noise, and the “ST ”indicator will go
out.
Tuning
The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
NOTE
If the power supply is interrupted (fuse
blows or the battery is disconnected),
the preset channels will be canceled.
Manual tuning
Turning the manual tuning dial will
change the frequency higher or lower.
6-26
Interior Comfort
Audio System
MX-5 Miata_8T72-EA-04G_Edition2 Page152
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G

Black plate (164,1)
qOperating the In-Dash CD Changerí
Display CD slot
Disc-in indicator CD play button
Random button
Repeat button
Disc up button Reverse button
Load button
Power/Volume dial
Channel preset buttons
CD eject
button
Scan button
Fast-forward
button
Track up
button
Track down
button
Disc down
button
Inserting the CD
The CD must be label-side up when
inserting. The auto-loading mechanism
will set the CD and begin play. There will
be a short lapse before play begins while
the player reads the digital signals on the
CD.
The disc number, the track number and
the elapsed play back time for the current
track will be displayed.NOTE
lWhen the clock is displayed, the
elapsed play back time will not be
displayed. To display the elapsed
play back time, turn the audio
control dial to the right. Turn the dial
to the left to return to the previous
display.
lA CD cannot be inserted while the
display reads “WAIT ”. A beeping
sound can be heard during this
waiting time. Simultaneously
pressing the power/volume dial and
the load button (
) for about 2
seconds will turn this beeping sound
ON or OFF.
6-38
Interior Comfort
íSome models.
Audio System
MX-5 Miata_8T72-EA-04G_Edition2 Page164
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G