low beam MAZDA MODEL SPEED MX-5 MIATA 2005 Owners Manual
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2005, Model line: MODEL SPEED MX-5 MIATA, Model: MAZDA MODEL SPEED MX-5 MIATA 2005Pages: 298, PDF Size: 3.03 MB
Page 115 of 298

Black plate (115,1)
SignalWarning/Indicator Lights Page
Immobilizer System Warning Light 5-26
Headlight High-Beam Indicator Light5-27
O/D OFF Indicator Light5-27
Cruise Set Indicator Light5-27
Turn-Signal/Hazard Warning Indicator Lights5-27
qBrake System Warning Light
This warning has the following functions:
Parking brake warning
The light comes on when the parking
brake is applied with the ignition switch
in the START or ON position. It goes off
when the parking brake is fully released.
Low brake fluid level warning/
Electronic brake force distribution
system warning
If the light stays on after the parking brake
is fully released, you may have a brake
problem.
Drive to the side of the road and park off
the right-of-way. Low brake fluid level warning
You may notice that the pedal is harder to
push or that it may go closer to the floor.
In either case, it will take longer to stop
the vehicle.
1. With the engine stopped, check the
brake fluid level immediately and add
fluid as required (page 8-20).
2. After adding fluid, check the light again.
If the warning light remains on, or if the
brakes do not operate properly, do not
drive the vehicle. Have it towed to an
Authorized Mazda Dealer.
Even if the light goes off, have your brake
system inspected as soon as possible.
Electronic brake force distribution
system warning
If the electronic brake force distribution
control unit determines that some
components are operating incorrectly, the
control unit may turn the brake system
warning light on.
Driving Your Mazda
Warning/Indicator Lights and Beep Sounds
5-23
MX-5 Miata_8T72-EA-04G_Edition2 Page115
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G
Page 121 of 298

Black plate (121,1)
Lighting Control
qHeadlights
To turn on the lights, turn the headlight
switch on the end of the control lever.
Switch Position
Headlights Off Off On
Taillights
Parking lights
License lights
Side-marker lights Off On On
NOTE
To prevent discharging the battery, don't
leave the lights on while the engine is
off.
q
Lights-On Reminder
If lights are on and the key is removed
from the ignition switch, a beep sound
will be heard when any door is opened.
qHeadlight High-Low Beam
Push the lever forward for high beam.
Pull it back for low.
High beam
Low beam
q Flashing the Headlights
To flash the headlights, pull the lever fully
toward you. The headlight switch need
not be on, and the lever will return to the
normal position when released.
Driving Your Mazda
Switches and Controls
5-29
MX-5 Miata_8T72-EA-04G_Edition2 Page121
Tuesday, August 31 2004 11:24 AM
Form No.8T72-EA-04G
Page 251 of 298

Black plate (251,1)
Your Mazda's headlights and fog lights
have replaceable halogen bulbs.
WARNING
Handling Halogen Bulbs:
When a halogen bulb breaks, it is
dangerous. These bulbs contain
pressurized gas. If one is broken, it
will explode and serious injuries could
be caused by the flying glass.
If the glass portion is touched with
bare hands, body oil could cause the
bulb to overheat and explode when lit.
Never touch the glass portion of the
bulb with your bare hands and always
wear eye protection when handling or
working around halogen bulbs.
Children and Halogen Bulbs:
Playing with a halogen bulb is
dangerous. Serious injuries could be
caused by dropping a halogen bulb or
breaking it some other way.
Always keep halogen bulbs out of the
reach of children.
qReplacing Exterior Light Bulbs
Replacing a headlight bulb
1. Make sure the ignition switch is turned
off and the headlight switch is off.
2. Lift the hood and find the high and low beam bulbs in the rear of the headlight
unit.
The outboard bulb is the LOW beam,
and the inboard one is the HIGH beam.
Refer to Light Bulbs (page 8-34). 3. Turn the socket and bulb assembly
counterclockwise and remove it while
holding the rubber socket cover in
place. Carefully remove the headlight
bulb from its socket in the reflector by
gently pulling it straight backward out
of the socket.
4. Disconnect the bulb from the electrical connector by pressing the tab on the
connector with your finger and pulling
the bulb upward.
High beam bulb
Low beam bulb
5. Install the new bulb in the reverse orderof removal.
NOTE
Use the protective cover and carton for
the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.
Replacing a fog light bulbí
Due to the complexity and difficulty of
the procedure, the bulbs should be
replaced by an Authorized Mazda Dealer.
Front turn signal lights/Parking lights
1. Turn the socket and bulb assemblycounterclockwise and remove it.
Maintenance and Care
Owner Maintenance
8-35íSome models.
MX-5 Miata_8T72-EA-04G_Edition2 Page251
Tuesday, August 31 2004 11:25 AM
Form No.8T72-EA-04G
Page 290 of 298

Black plate (290,1)
qLight Bulbs
Exterior light
Light bulb Category
Wattage ECE R SAE
Headlights High beam 60 HB3
―
Low beam 51 HB4 ―
Front turn signal lights/Parking lights 27/8 ―#1157NA
Fog lights
í55 H11 ―
Side-marker lights 3.8 ―#194
Rear turn signal lights 21 WY21W ―
Brake lights/Taillights 21/5 W21/5W #7443
High-mount brake light 21 P21W ―
Reverse lights 21 W21W #7440
License plate lights/Trunk lights 5 W5W ―
Interior light
Light bulb Wattage
Overhead light 8
q Tires
NOTE
The tires have been optimally matched with the chassis of your vehicle.
When replacing tires, Mazda recommends that you replace tires of the same type
originally fitted to your vehicle. For details, contact an Authorized Mazda Dealer.
Check the tire pressure label for tire size and inflation pressure. Refer to Tire Inflation
Pressure on page 8-31.
Standard tire Tire size Inflation pressure
Front Rear
195/50 R15 82V 180 kPa (1.8 kgf/cm
2, 26 psi)180 kPa (1.8 kgf/cm2, 26 psi)
205/45 R16 83W
205/40 R17 80W 200 kPa (2.0 kgf/cm
2, 29 psi) 220 kPa (2.2 kgf/cm2, 32 psi)
Temporary spare tire
Tire size Inflation pressure
T115/70 D14 88M 420 kPa (4.2 kgf/cm
2, 60 psi)
T105/70 D15 85M
10-6íSome models.
Specifications
MX-5 Miata_8T72-EA-04G_Edition2 Page290
Tuesday, August 31 2004 11:25 AM
Form No.8T72-EA-04G
Page 295 of 298

Black plate (295,1)
D
Dimensions ....................................... 10-5
Door Locks ......................................... 3-9
Driving In Flooded Area ................... 4-12
Driving Tips ........................................ 4-8Automatic transmission .............. 5-13
Break-in period ............................ 4-8
Driving in flooded area .............. 4-12
Hazardous driving ........................ 4-9
Money-saving suggestions ........... 4-8
Rocking the vehicle ...................... 4-9
Turbocharged vehicles ............... 4-13
Winter driving ............................ 4-10
E
Emergency Starting ........................... 7-13Flooded engine ........................... 7-13
Jump-starting .............................. 7-13
Push-starting .............................. 7-15
Emergency Towing ........................... 7-16
Emission Control System .................... 4-4
Engine Coolant ....................................... 8-18
Exhaust gas .................................. 4-6
Hood release .............................. 3-18
Oil .............................................. 8-15
Overheating ................................ 7-11
Starting ......................................... 5-3
Engine Compartment Overview ........ 8-14
Engine Coolant Overheating ................................ 7-11
Engine Coolant Temperature
Gauge ................................................ 5-20
Exhaust Gas ........................................ 4-6
Exterior Care ..................................... 8-44
F
Flasher Hazard warning .......................... 5-34
Headlights .................................. 5-29
Flat Tire ............................................... 7-3 Changing ...................................... 7-5
Spare tire and tool storage ............ 7-3
Fluids Classification .............................. 10-4
Owner maintenance ................... 8-12
Fog Lights ......................................... 5-30
Foot Brake .......................................... 5-4
Front seats ........................................... 2-2
Fuel Filler lid and cap ........................ 3-17
Gauge ......................................... 5-20
Requirements ............................... 4-2
Tank capacity ............................. 10-5
Fuses ................................................. 8-38 Panel description ........................ 8-40
Replacement ............................... 8-38
G
Glove Box ......................................... 6-70
H
Hazard Warning Flasher .................... 5-34
Hazardous Driving .............................. 4-9
HeadlightsControl ....................................... 5-29
Flashing ...................................... 5-29
High-low beam .......................... 5-29
On reminder ............................... 5-29
Hood Release .................................... 3-18
Horn .................................................. 5-33
Index
11-3
MX-5 Miata_8T72-EA-04G_Edition2 Page295
Tuesday, August 31 2004 11:25 AM
Form No.8T72-EA-04G