buttons MAZDA MODEL TRIBUTE 2008 Quick Tips (in English)

SEATS
Always check the Owner’s Manual for more operating information and safety features
Shoulder belt
height
adjustment
To raise/lower belt:
Squeeze and hold
release buttons (1)
and slide up/down.
WARNING: Make sure
adjuster locks in one
of its positions.
Beltminder
Intermittently sounds chime
and illuminates seat belt warning
lamp when driver’s seat belt
is unbuckled and occupied.
Manual controls
1. Fore/aft adjustment
Raise lever and hold, slide seat,
release lever.
2. Seatback angle
Pull lever up to adjust seatback
angle, release lever at
desired angle.
WARNINGS: Do not adjust
seats while driving.
Seat belts must always be
worn when vehicle is in motion.
Air bags are supplemental
and do not replace seat
belt usage.
Always wear your seat belt
and properly secure children
12 and under in the rear seat.
Even with a deactivation
system, never place rear-facing
infant-safety seat in front
of any air bag, an infant is
in serious danger of being
injured or killed.
If you must install a forward-
facing child-safety seat in
the front seating position,
move vehicle seat as far
back as possible.Child-safety seat
To install in rear outboard seats:
Use dual locking mode retractor
seat belts; see Owner’s Manual
for proper installation and child
seat tether and LATCH system
instructions.
WARNING: Use age
appropriate child restraints,
see Owner’s Manual and
state or province laws.
Seats
Seats
*Denotes optional equipment
Seat belt emergency
locking mode
Belts lock only on hard acceleration,
braking, cornering or impacts of
about 5 mph or more.
Automatic locking mode
(all seat belts except
driver’s seat belt)
Must be used when installing
child-safety seat.
To activate: Pull webbing fully
out of retractor, allow belt to
retract until click is heard;
belt will only tighten.
To disengage: Unbuckle belt and
allow webbing to retract fully.
Passenger air bag sensing
system,see Getting Started
4
8
2
1
765
3
3 . Manual lumbar adjustment*
Rotate clockwise/counterclock-
wise to increase/decrease
firmness.
4. Head restraint
To raise/lower: Pull up/hold
release button (8) and push down.
Power driver’s seat*
5. Raise/lower front of seat
Pull/push front of switch up/down.
6. Fore/aft adjustment
Slide entire switch horizontally.
Raise/lower seat cushion
Pull/push entire switch vertically.
7. Raise/lower rear of seat
Pull/push back of switch up/down.
WARNING: Never ride in
a moving vehicle with any
seat in a reclined position
because you will not get
the full protection from
seat belts.
1 1