headlamp MAZDA MODEL TRIBUTE 4WD 2001 User Guide
[x] Cancel search | Manufacturer: MAZDA, Model Year: 2001, Model line: MODEL TRIBUTE 4WD, Model: MAZDA MODEL TRIBUTE 4WD 2001Pages: 232, PDF Size: 1.74 MB
Page 200 of 232

BULBS
Replacing exterior bulbs
Check the operation of the following lamps frequently:
²Headlamps
² Fog lamps (if equipped)
² High-mount brakelamp
² Brake lamps
² Turn signals
² License plate lamp
² Tail lamps
² Back-up lamps
Do not remove lamp bulbs unless they can be replaced immediately with
new ones. If a bulb is removed for an extended period of time,
contaminants may enter the lamp housings and affect lamp performance.
Replacing headlamp bulbs 1. Make sure that the headlamp control is in the OFF position.
2. Open the hood.
3. Disconnect the electrical connector from the bulb by
pulling rearward.
Maintenance and care
200
Page 201 of 232

4. Remove the rubber boot fromthe lamp assembly by pulling on
one of the tabs.
5. Squeeze the retainer spring together releasing it from bulb
hooks and rotate it away from
the bulb.
6. Without turning, carefully pull bulb out of headlamp assembly.
Handle a halogen headlamp bulb
carefully and keep out of
children's reach. Grasp the bulb
only by its plastic base and do
not touch the glass. The oil from
your hands could cause the bulb
to break the next time the
headlamps are operated.
NOTE: If the bulb is accidentally touched, it should be cleaned with
rubbing alcohol before being used. 7. Insert the glass end of the new bulb into the headlamp assembly. When the bulb's three metal tabs are aligned with the grooves in the
plastic base, push the bulb into the lamp assembly until the bulb's
metal base contacts the rear of the lamp assembly.
8. Rotate the retainer spring over the bulb plastic base and secure it on the bulb hooks.
Maintenance and care
201
Page 202 of 232

9. Install rubber boot on the lamp assembly.
10. Connect the electrical connector into the rear of the plastic base until it ªsnaps.º
Replacing brake/tail/turn/backup lamps bulbs
The brake/tail/turn/backup lamp bulbs are located in the tail lamp
assembly, one just below the other. Follow the same steps to replace
either bulb:
1. Open the liftgate to expose the lamp assemblies.
2. Remove the two screws from the lamp assembly.
3. Carefully remove the lamp assembly by pulling it rearward.
4. Twist the bulb socket counterclockwise and remove
from lamp assembly.
5. Pull the bulb straight out of the socket and push in the new
bulb.
6. To complete installation, follow the removal procedure in
reverse order.
Replacing front position lamp bulbs
1. Make sure that the headlamp control is in the OFF position.
2. Open the hood. The position lamps are located on the bottom half ofeach headlamp.
Maintenance and care
202
Page 204 of 232

Replacing front parking lamp/turn signal bulbs
For bulb replacement, see an authorized Mazda dealer.
Replacing high-mount brake lamp bulbs
For bulb replacement, see an authorized Mazda dealer.
Replacing the interior bulbs
Check the operation of the following interior bulbs frequently:
²interior overhead lamp
² map lamp
For bulb replacement, see an authorized Mazda dealer.
USING THE RIGHT BULBS
Replacement bulbs are specified in the chart below. Headlamp bulbs
must be marked with an authorized ªD.O.T.º for North America and an
ªEº for Europe to assure lamp performance, light brightness and pattern
and safe visibility.
NOTE: The correct bulbs will not damage the lamp assembly or void the
lamp assembly warranty and will provide quality bulb burn time.
Function Number of bulbs Trade number
Park/turn lamps (front) 2 3157 AK (amber)
Headlamps 2 9007
Rear stop/tail lamps 2 3157K
Rear turn lamps 2 3156K
Rear license plate lamps 2 3156K/168
Backup lamp 2 3156K
Rear/turn/sidemarker 2 916NA (amber)
Fog lamp (if equipped) 2 899
Cargo lamp 1 211-2
Interior overhead lamp 1 912 (906)
Front door courtesy lamp 1 168
Map lamps 2 168 (T10)
Ashtray lamp 1 161
All replacement bulbs are clear in color except where noted.
To replace all instrument panel lights - see your dealer.
Maintenance and care
204
Page 205 of 232

AIMING THE HEADLAMPS
The headlamps on your vehicle are properly aimed at the assembly plant.
If your vehicle has been in an accident the alignment of your headlamps
should be checked by your authorized Mazda dealer.
VERTICAL AIM ADJUSTMENT1. Park the vehicle on a level surface approximately 7.6 meters (25 feet) from a vertical wall or screen directly in front of it.
² (A) 2.4 meter (8 feet)
² (B) Center height of lamp to ground
² (C) 7.6 meters (25 feet)
² (D) Horizontal reference line
2. Measure the height from the center of your headlamp to the ground and mark a 2.4 meter (8 foot) horizontal reference line on the
vertical wall or screen at this height (a piece of masking tape works
well). The center of the lamp is marked by a 3.0 mm circle on the
headlamp lens.
3. Turn on the low beam headlamps to illuminate the wall or screen and open the hood. Cover the left-hand headlamp with an opaque
cloth.
A
D
B
C
Maintenance and care
205
Page 206 of 232

4. On the wall or screen you willobserve a light pattern with a
distinct horizontal edge of high
intensity light towards the right.
If this edge is not at the
horizontal reference line, the
beam will need to be adjusted.
5. Locate the vertical adjuster on the headlamp, then us ea7mm
hex socket or T20 Torx driver to turn the adjuster either
counterclockwise (to adjust down) or clockwise (to adjust up)
aligning the upper edge of the light pattern up to the horizontal line.
After market photometric aimers are not recommended for use on
Mazda vehicles.
6. Move the opaque cloth to cover the right-hand headlamp and repeat steps 4 and 5 for the left-hand headlamp.
7. HORIZONTAL AIM IS NOT REQUIRED FOR THIS VEHICLE AND IS NON-ADJUSTABLE.
8. Close the hood and turn off the lamps.
CLEANING AND CARING FOR YOUR VEHICLE
Contact your local Mazda dealership for a list of Mazda-approved
cleaners, polishes and waxes.
Washing your vehicle
Wash your vehicle regularly with
cold or lukewarm water. Never use
strong detergents or soap. If your
vehicle is particularly dirty, use a
quality car wash detergent. Always
use a clean sponge, washing glove
or similar device and plenty of water
for best results. To avoid spots,
avoid washing when the hood is still
warm, immediately after or during
exposure to strong sunlight.
During winter months, it is especially important to wash the
vehicle on a regular basis. Large quantities of dirt and road salt
are difficult to remove and also cause damage to the vehicle.
Maintenance and care
206
Page 227 of 232

Four-Wheel Drive vehiclesdescription ..............................120
driving off road .......................121
indicator light ...................12, 121
preparing to drive your
vehicle .....................................110
Fuel ............................................189 calculating fuel economy .......194
cap .....................................14, 193
capacity ...................................212
choosing the right fuel ...........192
comparisons with EPA fuel
economy estimates .................197
detergent in fuel .....................193
filling your vehicle
with fuel ..................189, 193, 195
filter, specifications ................194
fuel pump shut-off switch .....134
gauge .........................................16
improving fuel economy ........194
low fuel warning light ................9
octane rating ...................192, 214
quality ......................................192
running out of fuel .................193
safety information relating to
automotive fuels .....................189
Fuses ..................................135±136
G
Garage door opener ....................47
Gas cap (see Fuel cap) ......14, 193
Gas mileage
(see Fuel economy) .................194
Gauges .........................................15 engine coolant temperature
gauge .........................................15
fuel gauge ..................................16
odometer ...................................17
speedometer .............................16 tachometer ................................16
GAWR
(Gross Axle Weight Rating) .....124 calculating ...............................126
definition .................................124
driving with a heavy load ......124
location ....................................124
GVWR (Gross Vehicle
Weight Rating) ..........................124 calculating .......................124, 126
definition .................................124
driving with a heavy load ......124
location ....................................124
H
Hazard flashers .........................134
Head restraints ...........................69
Headlamps ...................................49 aiming ......................................205
bulb specifications ..................204
daytime running lights .............49
flash to pass ..............................50
high beam ...........................11, 50
replacing bulbs .......................200
turning on and off ....................49
warning chime ..........................14
Heating ........................................20 heating and air conditioning
system .......................................20
Hood ..........................................162
I
Ignition .................................39, 214
Infant seats
(see Safety seats) .................93±94
Inspection/maintenance (I/M)
testing ........................................199
Index
227
Page 228 of 232

Instrument panelcleaning ...................................210
cluster ..........................................8
lighting up panel and
interior .......................................18
location of components ..............8
J
Jack ............................................142 positioning ...............................142
storage .....................................142
Jump-starting your vehicle ......147
K
Keys .......................................61±63 key in ignition chime ...............14
positions of the ignition ...........39
L
Lamps bulb replacement
specifications chart ................204
cargo lamps ...............................18
daytime running light ...............49
fog lamps ...................................50
headlamps .................................49
headlamps, flash to pass ..........50
instrument panel, dimming .....18
interior lamps ...................48, 204
replacing bulbs .......200, 202±204
Lane change indicator
(see Turn signal) ........................50
Liftgate ........................................56
Lights, warning and indicator ......8 air bag ........................................10
anti-lock brakes (ABS) ....10, 108
anti-theft ...................................11 brake ..........................................10
charging system ........................12
cruise indicator .........................11
door ajar ....................................12
fuel cap light .............................14
high beam .................................11
low coolant ................................13
low fuel ........................................9
oil pressure ...............................12
overdrive off ..............................13
safety belt .................................10
service engine soon ....................8
turn signal indicator .................11
Load limits .................................124 GAWR ......................................124
GVWR ......................................124
trailer towing ..........................124
Loading instructions .................126
Locks childproof ..................................53
doors ..........................................52
Lubricant specifications ...........214
M
Manual transaxle .......................116 fluid, checking and adding ....179
reverse .....................................118
Manual transmission fluid capacities ........................212
Mirrors cleaning ...................................211
fold away ...................................19
side view mirrors (power) .......18
Moon roof ....................................47
Motorcraft parts ........................194
Index
228