MERCEDES-BENZ C300 4MATIC 2008 W204 Owner's Manual

120 Controls in detail
Power windows
Opening and closing power windows
The door windows are opened and closed
electrically. The switches

for all door windows are on the driver’s
door

for the front passenger door window
are on the front passenger door

for each rear door window are on the
respective rear door
1Left front door window
2Right front door window
3Right rear door window
4Override switch
5Left rear door window
Warning!G
Do not keep any part of your body up against
the side window pane when opening a win-
dow. The downward motion of the pane may
pull that part of your body down between
the window pane and the door frame and
trap it there. If there is a risk of entrapment,
release the switch and press it again to
close the window.
Warning!G
When closing the windows, make sure there
is no danger of anyone being harmed by the
closing procedure.
Activate the override switch (
page 57)
when children are riding in the back seats of
the vehicle. The children may otherwise in-
jure themselves, e.g. by becoming trapped
in the window opening.
The closing of the door windows can be im-
mediately halted by releasing the switch or,
if the switch was pressed past the resis-
tance point and released, by pressing the
lower part of the respective switch again.
The door windows are equipped with the ex-
press-close and automatic reversal func-
tion. If the window encounters an
obstruction that blocks its path in a circum-
stance where you pressed the switch past
the resistance point and released it to close
the window, the automatic reversal function
will stop the window and open it slightly.

121 Controls in detail
Power windows
Switch on the ignition (page 82).
Opening: Press the desired switch1
to 4 (
page 120) to the resistance
point.
The corresponding window will move
down until you release the switch.
Closing: Pull the desired switch1 to
4 (
page 120) to the resistance
point.
The corresponding window will move
up until you release the switch.
If the window encounters an obstruction
that blocks its path in a circumstance where
you are closing the window by pressing and
holding the switch, by pressing and holding
button ‹ on the SmartKey or SmartKey
with KEYLESS-GO*, by pressing and holding
the sensor surface (vehicles with
KEYLESS-GO*) on an outside door handle,
or by pressing and holding button, on
the climate control panel (Canada only), the
automatic reversal function will not operate.
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.iYou can also open or close the windows us-
ing the SmartKey, see “Summer opening fea-
ture” (
page 123) and “Convenience closing
feature” (
page 124).
iOperating the windows from the rear is not
possible if you activate the override switch
(
page 57).
iWith the SmartKey in starter switch
position0 or removed from the starter switch,
the power windows can be operated:

until you open the driver’s or front passenger
door

for approximately 5 minutes if no door was
openedWarning!G
If you press and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.


122 Controls in detail
Power windows
Express-opening: Press the switch1
to4 (
page 120) past the resistance
point and release.
The corresponding window opens com-
pletely.
Express-closing: Pull the switch1
to4 (
page 120) past the resistance
point and release.
The corresponding window closes com-
pletely.
Stopping during Express-operation:
Briefly press the respective power win-
dow switch again.
Warning!G
Driver’s door only:
If within 5 seconds you again press the
switch past the resistance point and re-
lease, the automatic reversal will not oper-
ate.
Warning!G
If a window is blocked while closing and re-
opens, it can be closed with greater force if
you pull the switch to the resistance point
within 2 seconds.
If the window is blocked again and reopens,
you can close it with deactivated anti-trap
protection by pulling the switch again to the
resistance point within 2 seconds.
When closing windows with the anti-trap
protection deactivated, make sure no one
can become trapped, as this could result in
serious or fatal injuries.
!If the upward movement of the window is
blocked during the closing procedure, the win-
dow will stop and open slightly. Remove the ob-
struction, press the respective power window
switch again past the resistance point and re-
lease. If the window still does not close when
there is no obstruction, press and hold the re-
spective power window switch. The side window
will then close without the protection of the au-
tomatic reversal feature.


123 Controls in detail
Power windows
Summer opening feature
If the weather is warm, you can ventilate
the vehicle before driving off by simulta-
neously:

opening the side windows

opening the tilt/sliding sunroof or pan-
orama roof with power tilt/sliding pan-
el* and roller sunblinds
Aim transmitter eye of the SmartKey
towards the sensor in the driver’s out-
side door handle. The SmartKey must
be in close proximity to the driver’s
door handle.
Press button Πto unlock the
vehicle.
Vehicles with tilt/sliding sunroof
Press and hold button Πuntil the
side windows and tilt/sliding sunroof
have reached the desired position.
Release button Πto interrupt pro-
cedure.Vehicles with panorama roof*
If roller sunblinds are retracted:
Press and hold button Œ. The side
windows and roller sunblinds begin to
open/extend after approximately
1 second.
With the side windows and roller blinds
fully opened/extended, press and hold
button
Πagain. The tilt/sliding pan-
el tilts and opens.
If roller sunblinds are extended:
Press and hold button Œ. The side
windows move down and the tilt/slid-
ing panel tilts and opens after approxi-
mately 1 second.
Release button Πto interrupt proce-
dure.
iThe “Summer opening” function can only be
activated via the remote control of the SmartKey
or SmartKey with KEYLESS-GO*.

124 Controls in detail
Power windows
Convenience closing feature
When you lock the vehicle, you can close
the side windows and tilt/sliding sunroof
or panorama roof with tilt/sliding panel*
simultaneously.
Afterward, you can close the roller sun-
blinds* of the panorama tilt/sliding sun-
roof*.Vehicles with SmartKey
Aim transmitter eye of the SmartKey
towards the sensor in the driver’s out-
side door handle. The SmartKey must
be in close proximity to the driver’s
door handle.
Press button ‹ to lock the vehicle.
Vehicles with tilt/sliding sunroof
Press and hold button ‹ until the
side windows and the tilt/sliding sun-
roof are completely closed.
Release button ‹ to interrupt pro-
cedure.
iThe function of the SmartKey overrules the
KEYLESS-GO function.
Warning!G
When closing the windows and the tilt/slid-
ing sunroof or panorama roof with tilt/slid-
ing panel*, make sure there is no danger of
anyone being harmed by the closing proce-
dure.
If potential danger exists, proceed as fol-
lows:

Release button ‹ to stop the closing
procedure. To open, press and hold but-
ton Œ. To continue the closing after
making sure that there is no danger of
anyone being harmed by the closing pro-
cedure, press and hold button‹.
Vehicles with KEYLESS-GO* (Canada only):

Release the sensor surface on the out-
side door handle (
page 125) to stop
the closing procedure.

Immediately pull on the same outside
door handle and hold firmly. The side
windows and the tilt/sliding sunroof or
panorama roof with tilt/sliding panel*
will open for as long as the outside door
handle is held but the door is not
opened.

125 Controls in detail
Power windows
Vehicles with panorama roof*
Press and hold button ‹ until the
side windows and the tilt/sliding panel
are completely closed.
Press and hold button ‹ again.
The roller sunblinds close.
Release button ‹ to interrupt pro-
cedure.
Vehicles with KEYLESS-GO*
(Canada only)
1Sensor surface on door handleThe SmartKey with KEYLESS-GO must be
located outside the vehicle within approxi-
mately 3 ft (1 m) of a door.
Close all doors.
Vehicles with tilt/sliding sunroof
Touch and hold sensor surface1 until
the windows and the tilt/sliding sun-
roof are completely closed.
Release sensor surface1 to interrupt
procedure.Vehicles with panorama roof*
Touch and hold sensor surface1 until
the side windows and the tilt/sliding
panel are completely closed.
Touch and hold sensor surface1
again.
The roller sunblinds close.
Release sensor surface1 to interrupt
procedure.iMake sure you are only touching the sensor
surface.
iMake sure you are only touching the sensor
surface.

126 Controls in detail
Driving and parking
Starting the engine Manual transmission
Gearshift pattern for manual transmission
For more information, see “Manual trans-
mission” (
page 136).
Warning!G
Make sure absolutely no objects are ob-
structing the pedals’ range of movement.
Keep the driver’s footwell clear of all obsta-
cles. If there are any floormats or carpets in
the footwell, make sure the pedals still have
sufficient clearance.
During sudden driving or braking maneuvers
the objects could get caught between the
pedals. You could then no longer brake or
accelerate. This could lead to accidents and
injury.Warning!G
Inhalation of exhaust gas is hazardous to
your health. All exhaust gas contains carbon
monoxide (CO), and inhaling it can cause un-
consciousness and possible death.
Do not run the engine in confined areas
(such as a garage) which are not properly
ventilated. If you think that exhaust gas
fumes are entering the vehicle while driving,
have the cause determined and corrected
immediately. If you must drive under these
conditions, drive with at least one window
fully open.

127 Controls in detail
Driving and parking
Starting: Depress brake pedal.
Make sure the gearshift lever is in
neutral position (no gear selected).
Fully depress clutch pedal.
Otherwise the engine cannot be
started due to the integrated safety
interlock.
Do not depress the accelerator.
Turn the SmartKey in the starter switch
to position3 and hold until the engine
starts.
For information on turning off the engine,
see “Turning off the engine” (
page 134).Automatic transmission*
Gearshift pattern for automatic
transmission
PPark position
RReverse gear
NNeutral
DDrive position
For more information on how to operate
the gear selector lever, see “Automatic
transmission*” (
page 127).SmartKey
Starting: Make sure the gear selector
lever is set toP.
Do not depress the accelerator.
Turn the SmartKey in the starter switch
to position3 and hold until the engine
starts.
For information on turning off the engine
with the SmartKey, see “Turning off the en-
gine” (
page 134).
iYou can also use the “touch-start” function.
Turn the SmartKey to position 3 and release it
again immediately. The engine then starts
automatically.
iYou can also start the engine with the auto-
matic transmission set to N.

128 Controls in detail
Driving and parking
KEYLESS-GO* (Canada only)
You can start your vehicle without the
SmartKey in the starter switch using the
KEYLESS-GO start/stop button on the
starter switch.
The SmartKey with KEYLESS-GO must be
located in the vehicle.1KEYLESS-GO* start/stop button
(Canada only)
Starting: Make sure KEYLESS-GO
start/stop button is inserted in the
starter switch (
page 83).
Make sure the gear selector lever is set
toP.
Depress the brake pedal during the
starting procedure.
Do not depress the accelerator.
Press KEYLESS-GO start/stop button
once.
The engine starts if the SmartKey with
KEYLESS-GO is in the vehicle.For information on turning off the engine
with KEYLESS-GO, see “Turning off the en-
gine” (
page 134).
Warning!G
As long as the SmartKey with KEYLESS-GO
is in your vehicle, the vehicle can be started.
Therefore, never leave children unattended
in the vehicle, as they could otherwise acci-
dentally start the engine.
When leaving the vehicle, always take the
SmartKey with KEYLESS-GO with you and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. A child’s unsupervised ac-
cess to a vehicle could result in an accident
and/or serious personal injury.
iYou can also start the engine with the auto-
matic transmission set to N.
iIf you wish to start the vehicle with the
SmartKey instead of the KEYLESS-GO feature,
remove the KEYLESS-GO start/stop button from
the starter switch and proceed as described in
“Starting with the SmartKey” (
page 127).

129 Controls in detail
Driving and parking
Starting difficulties
The engine does not start. You can hear
the starter.
There could be a malfunction

in the engine electronics, or

in the fuel supply system
Carry out the following steps:
If you are starting the engine with the
SmartKey: Turn SmartKey in starter
switch to position0 and repeat starting
procedure (
page 126).
If you are starting the engine with
KEYLESS-GO*: Close any doors that
may be open to allow for better detec-
tion of the SmartKey with
KEYLESS-GO*.
or
Remove the KEYLESS-GO* start/stop
button from starter switch.
Start the engine with the SmartKey as
radio signals from another source may
be interfering with the SmartKey with
KEYLESS-GO*.
Repeat the starting procedure
(
page 126).
If the engine does not start after several
starting attempts:
Call Roadside Assistance.
Notify an authorized Mercedes-Benz
Center.
The engine does not start. You cannot
hear the starter.
The battery may not be sufficiently
charged.
Get a jump start (page 451).
If the engine will not start despite a jump
start:
Call Roadside Assistance.
Notify an authorized Mercedes-Benz
Center.
Driving off
!Remember that extended starting attempts
can drain the battery.
Warning!G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
(Canada only) from the starter switch, take
it with you, and lock the vehicle. Do not
leave children unattended in the vehicle, or
with access to an unlocked vehicle. Children
could release the parking brake, which
could result in an accident and/or serious
personal injury.
Warning!G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced vehi-
cle control. Your vehicle’s ABS will not pre-
vent this type of loss of control.