interior lights MERCEDES-BENZ CLS 2014 User Guide

Problems with the rear window defroster
ProblemPossible causes/consequences andSolutions
The rear window
defroster has
deactivated
prematurely or cannot
be activated.
The battery has not been sufficiently charged.
XSwitch off any consumers that are not required, e.g. reading
lamps, interior lighting or the seat heating.
When the battery is sufficiently charged, the rear window
defroster can be activated again.
Activating/deactivating air-
recirculation mode
Points to observe before use
You can deactivate the flow of fresh air if
unpleasant odors are enteringthe vehicle
from outside. The air already inside the
vehicle will then be recirculated.
If you switch on air-recirculation mode, the
windows can fog up more quickly, in
particular at low temperatures. Only use air-
recirculation mode briefly to prevent the
windows from fogging up.
The operation of air-recirculation mode is the
same for all control panels.
Activating/deactivating
XTurn the SmartKey to position2in the
ignition lock (Ypage 147).
XTo activate:press thebutton.
The indicator lamp in thebutton lights
up.
iDual-zone automatic climate control: air-
recirculation mode is automatically
activated at high outside temperatures.
3-zone automatic climate control: air-
recirculation mode is automatically
activated at high levels of pollution or at
high outside temperatures.
When air-recirculation mode is activated
automatically,the indicator lamp above the
button does not light up. Outside air
is added after about 30 minutes.
XTo deactivate:press thebutton.
The indicator lamp in thebutton goes
out.
iAir-recirculation mode deactivates
automatically:
Rafter approximately five minutes at
outside temperatures below
approximately 41‡(5†)
Rafter approximately five minutes if
cooling with air dehumidification is
deactivated
Rafter approximately 30 minutes at
outside temperatures above
approximately 41 ‡(5†)if the "Cooling
with air dehumidification" function is
activated
Activating/deactivating theresidual
heat function
The residual heat function is only available in
vehicles for Canada with 3-zoneautomatic
climate control.
It is possible to makeuse of the residual heat
of the engine to continue heatingthe vehicle
for approximately 30 minutes after the engine
has been switched off.The heating time
depends on the temperature that has been
set.
Operating the climate control systems141
Climat ec ontrol

XTurn the SmartKey to position0in the
ignition lock or remove it (Ypage 147).
XTo activate:press thebutton.
The indicator lamp in thebutton lights
up.
iIf the residual heat function is activated,
the windows may fog up on the inside.
iThe blower will run atalow speed
regardless of the airflow setting.
iIf you activatethe residual heat function
at high temperatures, only the ventilation
will be activated. The blower runs at
medium speed.
XTo deactivate:press thebutton.
The indicator lamp in thebutton goes
out.
Residualheat is deactivated automatically:
Rafter approximately 30 minutes
Rwhen the ignition is switched on
Rif the battery voltage drops
Setting the air vents
Important safety notes
GWARNING
Very hot or very cold air can flow from the air
vents. This could result in burns or frostbite in
the immediate vicinityofthe air vents. There
isarisk of injury.
Make sure that all vehicle occupantsalways
maintainasufficient distancetothe air
outlets. If necessary, redirect the airflow to
another area of the vehicle interior.
In order to ensure the direct flow of fresh air
through the air ventsinto the vehicle interior,
please observe the following notes:
Rkeep the air inlet between the windshield
and the hood free of blockages, such as ice,
snow or leaves.
Rnever cover the air ventsorair intakegrilles
in the vehicle interior.
Setting the center air vents
Center air vent,left
Center air vent,right
$Center vent thumbwheel, right
!Center vent thumbwheel, left
XTo open/close:turn thumbwheels$
and!up or down.
Setting the side air vents
Defroster vent
Side air vent
$Control for side air vent
XTo open/close:turn thumbwheel$up or
down.
Setting the glove box air vent
!Close the air vent when heating the
vehicle.
At high outside temperatures, open the air
vent and activatethe "cooling with air
142Setting the air vents
Climate control

the fourth time. When thesymbolis
shown in green in the multifunctiondisplay,
automatic engine switch-off is again
possible.
iAMG vehicles:times which the engine
can be automatically switched off.
iThe HOLDfunction can also be activated
if the engine has been switched off
automatically. It is thennot necessary to
continue applying the brakes duringthe
automatic stop phase. When you depress
the accelerator pedal, the engine starts
automatically and the braking effect of the
HOLDfunction is deactivated.
Automatic engine start
The engine startsautomatically if:
Ryou switchoff the ECO start/stop function
by pressing the ECO button.
Ryou release the brakes when in
transmission positionDorNand when the
HOLDfunction is not active.
Ryou depressthe accelerator pedal.
Ryou engage reverse gearR.
Ryou movethe transmission out of position
P.
Ryou switchtodrive programS,S+orM
(AMG vehicles).
Ryou unfasten your seat belt or open the
driver's door.
Rthe vehicle startstoroll.
Rthe brakesystem requiresthis.
Rthe temperature in the vehicle interior
deviates fromthe set range.
Rthe system detectsmoisture on the
windshield when the air-conditioning
system is switched on.
Rthe charge level of the battery is too low.
iShiftingthe transmission to positionP
does not start the engine.
iIf you shift the transmission fromRtoD,
the ECO start/stop function is available
again once thesymbol reappears in
green in the multifunction display.
Deactivating/activating the ECO start/
stop function
ECO button
XTo switch off (except AMG vehicles):
press button.
Indicator lampand thesymbol in
the multifunction displaygoout.
XTo switch on (except AMG vehicles):
press button.
Indicator lamplights up. If all conditions
for automatic engine switch-off
(Ypage 151) are fulfilled,thesymbol
is shown in green in the multifunction
display.
If not all conditionsfor automatic engine
switch-off (Ypage 151) are fulfilled,the
symbol is shown in yellow in the
multifunction display. If this is the case, the
ECO start/stop function is not available.
XTo switch off (AMG vehicles):press
buttonin drive programC.
or
XSwitch to drive programS,S+orM
(Ypage 159).
Indicator lampand thesymbol in
the multifunction displaygoout.
TheStop/Start activeorStop/Start
inactivemessage in the AMG menu in the
multifunction displaygoes out.
152Driving
Driving and parking

You can determinewhether the multifunction
display shows some messages in miles or
kilometers.
XPress the\norbutton on the
steeringwheel to selecttheSett.menu.
XPress theorbutton to select the
Inst. Clustersubmenu.
XPressto confirm.
XPress theorbutton to select the
Display Unit Speed-/Odometer:
function.
You will see the selected setting:kmor
miles.
XPress thebutton to save the setting.
The selected unit of measurement for
distance applies to:
Rthe digital speedometer in theTripmenu
Rodometer and the trip odometer
Rtrip computer
Rcurrent consumption and the range
Rthe navigation instructions in theNavi
menu
Rcruise control
RDISTRONIC PLUS
RASSYST PLUS service interval display
Selecting the permanent display function
You can determine whether the multifunction
displaypermanently shows your speed or the
outside temperature.
XPress the\norbutton on the
steering wheel to select theSett.menu.
XPress theorbutton to select the
Inst. Clustersubmenu.
XPressto confirm.
XPress theorbutton to select the
Permanent Display:function.
You will see the selected settingOutside
TemperatureorSpeedometer [km/h]
(USA)/Speedometer [mph](Canada).
XPress thebutton to save the setting.
iThe speed is shown in km/h (USA)/mph
(Canada).
Lights
Setting the brightness of the instrument
cluster lighting and switches
The lighting in the instrumentcluster,inthe
displays and the controls in the vehicle
interior can be adjusted using the
Brightness Display/Switches:function.
XPress the\norbutton on the
steeringwheel to selecttheSett.menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
XPress theorbutton to select the
Brightness Display/Switches:
function.
You will see the selected setting.
XPressto confirm.
XPress theorbutton to adjust the
brightness to any level fromLevel 1to
Level 5(bright).
XPress theorbutton to save the
setting.
If the light switch is set to\r,or
,the brightness is dependent upon
the brightness of the ambient light.
iThe light sensor in the instrumentcluster
automatically controls the brightnessof
the multifunction display.
In daylight, the displays in the instrument
cluster are not illuminated.
Switching thedaytime running lamps on/
off
iThis function is not available in Canada.
XPress the\norbutton on the
steeringwheel to selecttheSett.menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
230Menus and submenus
On-board computer and displays

switch-off exterior lighting are on, the
following light up:
RParking lamps
RLow-beam headlamps
RDaytime running lamps
RSide marker lamps
RSurround lighting in the exterior mirrors
Activating/deactivating the interior
lighting delayed switch-off
If you activate theInterior Lighting
Delayfunction,the interior lighting remains
on for 20seconds after you remove the
SmartKey from the ignition lock.
XPress the\norbutton on the
steering wheel to select theSett.menu.
XPress theorbutton to select the
Lightssubmenu.
XPressto confirm.
XPressorto select theLight.
Delayfunction.
When theInterior Lighting Delay
function is activated, the vehicle interior is
displayed in red in the multifunction
display.
XPress thebutton to save the setting.
Vehicle
Activating/deactivating the automatic
door locking mechanism
XPress the\norbutton on the
steering wheel to select theSett.menu.
XPressorto select theVehicle
submenu.
XPressto confirm.
XPressorto select theAuto.
Door Locksfunction.
When theAutomaticDoorLockfunction
is activated, the vehicle doors are displayed
in red in the multifunction display.
XPress thebutton to save the setting.
If you activate theAutomatic Door Lock
function,the vehicle is centrally locked above
aspeed of around9mph (15 km/h).
For further information on the automatic
locking feature, see (Ypage 83).
Activating/deactivating the acoustic
locking verification signal
If you switch on theAcousticLockfunction,
an acoustic signal sounds when you lock the
vehicle.
XPress the\norbutton on the
steering wheel to select theSett.menu.
XPressorto select theVehicle
submenu.
XPressto confirm.
XPress theorbutton to select the
Acoustic Lockfunction.
If theAcousticLockfunction is activated,
thesymbol in the multifunction
displaylights up red.
XPress thebutton to save the setting.
Activating/deactivating the radar sensor
system
XPress the\norbutton on the
steering wheel to select theSett.menu.
XPressorto select theVehicle
submenu.
XPressto confirm.
XPress theorbutton to select
Radar Sensor (See Oper. Manual):.
You will see the selected setting:Enabled
orDisabled.
XPress thebutton to save the setting.
The following systems are switched off when
the radar sensor system is deactivated:
RDISTRONIC PLUS (Ypage 177)
RBAS PLUS (Ypage 67)
RPRE-SAFE®Brake (Ypage 72)
RBlind Spot Assist (Ypage 207)
RActive Blind Spot Assist (Ypage 211)
232Menus and submenus
On-board computer and displays