check engine MERCEDES-BENZ E WAGON 2006 S211 Owner's Guide
[x] Cancel search | Manufacturer: MERCEDES-BENZ, Model Year: 2006, Model line: E WAGON, Model: MERCEDES-BENZ E WAGON 2006 S211Pages: 521
Page 390 of 521
389 Practical hints
What to do if …
Display
Display message
Possible cause/consequence
Possible solution
ESP
Display malfunction
Visit workshop
The ESP
® or the ESP
® display is
malfunctioning.
Continue driving with added caution.
Have the system checked at an authorized
Mercedes-Benz Center as soon as possible.
Failure to follow these instructions increases
the risk of an accident.
P
Gear selector lever
in Park
You have attempted to turn off the
engine with the KEYLESS-GO*
start/stop button with the gear se-
lector lever not inP. You have
opened the driver’s door with the
gear selector lever not inP.
Place the gear selector lever in positionP.
P/N
Shift to
Neutral or Park
You have attempted to start the en-
gine with the KEYLESS-GO*
start/stop button while the gear se-
lector lever was in positionR orD.
Place the gear selector lever in positionP
orN. Make sure the brake pedal is de-
pressed.
Page 396 of 521
395 Practical hints
What to do if …
Symbol messagesDisplay symbol
Display messages
Possible cause/consequence
Possible solution
#
Low voltage
Switch off
consumers
The battery has insufficient voltage.
Turn off unnecessary electrical con-
sumers.
Visit workshop
The battery was charged with a battery
charger or jump started.
Have the battery checked at a service
station.
The battery is no longer charging.
Possible causes:
alternator malfunctioning
broken poly-V-belt
Do not forget that the brake system re-
quires electrical energy and may be oper-
ating with restricted capability.
Considerably greater brake pedal force is
required and the stopping distance is in-
creased.
Stop immediately in a safe location or
as soon as it is safe to do so and
check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise
the engine will overheat due to an in-
operative water pump which may re-
sult in damage to the engine. Notify
an authorized Mercedes-Benz Center.
If it is intact:
Drive immediately to the nearest
authorized Mercedes-Benz Center.
Adjust driving to be consistent with
reduced braking responsiveness.
Page 400 of 521
399 Practical hints
What to do if …
Display symbol
Display messages
Possible cause/consequence
Possible solution
(USA only);(Canada only)3
Brake fluid
Visit workshop
There is insufficient brake fluid in the
reservoir.
Risk of accident! Stop the vehicle in a
safe location as soon as it is safe to do
so and notify an authorized
Mercedes-Benz Center. Do not add
brake fluid! This will not solve the
problem.
Warning!
G
Driving with the message
Brake fluid
Visit workshop
displayed can result in an
accident. Have your brake system checked
immediately.
If there is a malfunction in the electrohy-
draulic brake system, we recommend that
the vehicle be transported with all wheels
off the ground using flatbed or appropriate
wheel lift/dolly equipment.
A tow bar must be used if circumstances do
not permit the use of the recommended
towing methods and the vehicle requires
towing with all four wheels on the ground.
Towing the vehicle with all four wheels on
the ground is only permissible for distances
u p t o 3 0 m i l e s ( 5 0 k m ) a n d a t a s p e e d n o t t o
exceed 30 mph (50 km/h). For more infor-
mation, refer to “Towing the vehicle”
(page 458).
If the electrohydraulic brake system enters
its emergency operation mode, the driver
must apply significantly greater brake pedal
pressure and depress the pedal much fur-
ther than normal to obtain braking effect. If
necessary, apply full pressure to the brake
pedal. Brakes may only be applied to the
front wheels. Stopping distance is in-
creased!
Do not add brake fluid before checking the
brake system. Overfilling the brake fluid res-
ervoir can result in spilling brake fluid on hot
engine parts and the brake fluid catching
fire. You can be seriously burned.!If you find that the brake fluid in the
brake fluid reservoir has fallen to the
minimum mark or below, have the
brake system checked for brake pad
thickness and leaks.
Page 401 of 521
400 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause/consequence
Possible solution
ú
(USA only)
±
(Canada only)
Engine
Service
There may be a malfunction in the:
fuel injection system
ignition system
exhaust system
fuel system
Have the measuring system checked
by an authorized Mercedes-Benz
Center.
B
Coolant
Check level
The coolant level is too low.
Add coolant (
page 321).
If you have to add coolant frequently,
have the cooling system checked by
an authorized Mercedes-Benz Center.
Warning!
G
Do not spill antifreeze on hot engine parts.
Antifreeze contains ethylene glycol which
may burn if it comes into contact with hot
engine parts. You can be seriously burned.
!Do not ignore the low engine coolant
level warning. Extended driving with
the message and symbol displayed
may cause serious engine damage not
covered by the Mercedes-Benz Limited
Warranty.
Do not drive without sufficient amount
of coolant in the cooling system. The
engine will overheat causing major en-
gine damage.
Page 403 of 521
402 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause/consequence
Possible solution
Ï
Coolant
Stop, engine off
The poly-V-belt could be broken.
Stop the vehicle in a safe location as soon as it is
safe to do so and immediately turn off the engine.
Check the poly-V-belt.
If it is broken:
Do not continue to drive. Otherwise the engine
will overheat due to an inoperative water pump
which may result in damage to the engine. Notify
an authorized Mercedes-Benz Center.
If it is intact:
Do not continue to drive the vehicle with this mes-
sage displayed. Doing so could result in serious
engine damage that is not covered by the
Mercedes-Benz Warranty.
Drive immediately to the nearest authorized Mer-
cedes-Benz Center.
Coolant
Visit workshop
The cooling fan for the coolant is
malfunctioning.
Observe the coolant temperature display.
Have the fan replaced as soon as possible.
Page 405 of 521
404 Practical hintsWhat to do if …When the message
Add 1 Qt.
(Canada:
1 Liter
) engine oil at next
refueling
(E 500, E 55 AMG) or
Check oil
level at next refueling
(E 350) appears
while the engine is running and at operat-
ing temperature, the engine oil level has
dropped to approximately the minimum
level.When this occurs, the warning will first
come on intermittently and then stay on if
the oil level drops further.
Visually check for oil leaks. If no obvious oil
leaks are noted, drive to the nearest ser-
vice station where the engine oil should be
topped to the required level with an ap-
proved oil specified in the Factory Ap-
proved Service Products pamphlet.
Display symbol
Display messages
Possible cause/consequence
Possible solution
:
USA only:Add 1 Qt. engine oil
at next refuelingCanada only:Add 1 Liter engine oil
at next refueling
E 500, E 55 AMG only:
The engine oil level is too low.
Check the engine oil level
(page 317) and add engine oil as re-
quired (
page 319).
If you must add engine oil frequently,
have the engine checked for possible
leaks.
Check oil level
at next refueling
E 350 only:
The engine oil has dropped to a critical
level.
Check the engine oil level
(page 318) and add oil as required
(page 319).
If you must add engine oil frequently,
have the engine checked for possible
leaks.!The engine oil level warnings should
not be ignored. Extended driving with
the symbol displayed could result in
serious engine damage that is not
covered by the Mercedes-Benz Limited
Warranty.
Page 406 of 521
405 Practical hints
What to do if …
Display symbol
Display messages
Possible cause/consequence
Possible solution
:
Engine oil level
Stop, engine off
E 500, E 55 AMG only:
There is no oil in the engine. There is a
danger of engine damage.
Carefully bring the vehicle to a halt as
soon as possible.
Turn off the engine.
Add engine oil (
page 319) and
check the engine oil level
(
page 317).
Engine oil level
Visit workshop
E 500, E 55 AMG only:
The engine oil has dropped to a critical
level.
Check the engine oil level
(page 317) and add oil as required
(page 319).
If you must add engine oil frequently,
have the engine checked for possible
leaks.
Change engine oil
Visit workshop
E 500, E 55 AMG only:
It may be that there is water in the engine
oil.
Have the engine oil and the cooling
system checked.
Page 407 of 521
406 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause/consequence
Possible solution
:
Engine oil level
Reduce oil level
E 500, E 55 AMG only:
You have added too much engine oil.
There is a risk of damaging:
the engine
the catalytic converter
Have oil siphoned or drained off. Ob-
serve all legal requirements with re-
spect to its disposal.
Oil sensor malfunction
Visit workshop
E 500, E 55 AMG only:
The measuring system is malfunctioning.
Have the measuring system checked
by an authorized Mercedes-Benz
Center.
Change engine oil
Visit workshop
E 500, E 55 AMG only:
It may be that there is water in the engine
oil.
Have the engine oil and the cooling
system checked.
Page 408 of 521
407 Practical hints
What to do if …
Display symbol
Display messages
Possible cause/consequence
Possible solution
%
Hood open
You are driving with the hood open.
Close the hood (
page 315).
F
Key
Check battery
The SmartKey with KEYLESS-GO* batter-
ies are discharged.
Change the batteries (
page 429).
Key
not recognized
The SmartKey with KEYLESS-GO* is not
recognized while the engine is running
because
the SmartKey with KEYLESS-GO* is
not in the vehicle
there is strong radio-frequency inter-
ference
Stop the vehicle in a safe location as
soon as it is safe to do so.
Search for the SmartKey.
Otherwise the vehicle cannot be cen-
trally locked nor can the engine be
started again after the engine is
stopped.
Key
not recognized
The SmartKey with KEYLESS-GO* is mo-
mentarily not recognized.
Change the position of the SmartKey
in the vehicle.
Operate the vehicle with the
SmartKey in the starter switch if nec-
essary.
Key
still in vehicle
A SmartKey with KEYLESS-GO* left in the
vehicle was recognized while locking the
vehicle from the outside.
Take the SmartKey out of the vehicle.
Keyless Go
Check system
The KEYLESS-GO* system is malfunction-
ing.
Visit an authorized Mercedes-Benz
Center as soon as possible.
Page 409 of 521
408 Practical hintsWhat to do if …Display symbol
Display messages
Possible cause/consequence
Possible solution
F
Do not
forget key
This display appears (for a maximum of
60 seconds) if the driver’s door is opened
with the engine shut off and no SmartKey
in the starter switch.
This message is only a reminder.
Insert SmartKey in the starter switch.
Take the SmartKey with
KEYLESS-GO* with you when leaving
the vehicle.
Remove key
You have forgotten to remove the
SmartKey.
Remove the SmartKey from the start-
er switch.
Replace key
There is no additional code available for
SmartKey or SmartKey with
KEYLESS-GO*.
Visit an authorized Mercedes-Benz
Center as soon as possible.
A
Reserve fuel
The fuel level has dropped below the re-
serve mark.
Refuel at the next gas station
(page 312).
Check gas cap
See Operator’s Manual
A loss of pressure has been detected in
the fuel system. The fuel cap may not be
closed properly or the fuel system may be
leaky.
Check the fuel cap (
page 312).
If it is not closed properly:
Close the fuel cap.
If it is closed properly:
Have the fuel system checked by an
authorized Mercedes-Benz Center.