windshield wipers MERCEDES-BENZ GL320CDI 2007 X164 User Guide

238 Controls in detail
3-zone automatic climate control*
Press button
to decrease or
buttonQ to increase air volume
(
page 232) to the desired level.
The air volume decreases/increases to
the next lower/higher blower speed
and heating switches to the tempera-
ture that was set before the front de-
froster was switched on.
The indicator lamp on button0 or,
depending on vehicle production date,
button| goes out. The indicator
lamp on button9 comes on.
or
Turn temperature control1
and/or7 (
page 232) slightly in any
direction.
Heating switches to the temperature
that was set before the front defroster
was switched on.
The indicator lamp on button0 or,
depending on vehicle production date,
button| goes out. The indicator
lamp on button9 comes on.Deactivating
Press button0 or, depending on
vehicle production date, button|
(
page 232).
The indicator lamp on the button goes
out. Defrosting is turned off.
The previous settings are once again in
effect.Windshield fogged on the outside
Switch the windshield wipers on
(
page 64).
Press buttonU (page 232).
The indicator lamp on buttonU
goes out. Air volume and air
distribution are controlled separately
for each zone.
If the automatic air distribution and
air volume are switched off:
Press buttons8 andY
(
page 232).
iThe air conditioning compressor remains on
even if the indicator lamp in button0 or, de-
pending on vehicle production date, button|
goes out. This helps to prevent the windshield
from fogging.
iTo switch off, you can also press
button´ orU (
page 232).
iKeep this setting selected only until the
windshield is clear again.

380 Operation
Engine compartment
The hood lock release lever is located in
the driver’s footwell.
1Release lever
Pull release lever1 downwards.
The hood is unlocked. Handle2 pro-
trudes slightly from the radiator grille.
If not, lift the hood slightly.2Handle for opening the hood
Press and hold handle2.
The hood is unlocked.
Pull up on the hood in direction of ar-
row and then release it.
The hood will be automatically held
open at shoulder height by gas-filled
struts.ClosingLet the hood drop from a height of
approximately 1 ft (30 cm).
The hood will lock audibly.
Check to make sure the hood is fully
closed.
If you can raise the hood at a point
above the headlamps, then it is not
properly closed. Open it again and let it
drop with somewhat greater force.

with the engine running

while starting the engine

when the ignition is switched on
!To avoid damage to the windshield wipers or
hood, never open the hood if the wiper arms are
folded forward away from the windshield.
Warning!G
When closing the hood, use extreme caution
not to catch hands or fingers. Be careful that
you do not close the hood on anyone.
Make sure that the hood is securely en-
gaged before driving off. Do not continue
driving if the hood can no longer engage af-
ter an accident, for example. The hood could
otherwise come loose while the vehicle is in
motion and endanger you and others.


428 Operation
Vehicle care
Automatic car wash
You can have your car washed in an auto-
matic car wash from the start. Automatic
car washes without brushes are prefera-
ble.
To protect the filter system, switch the
climate control system (
page 218) or
the automatic climate control system*
(
page 232) to air recirculation mode.
If the vehicle is very dirty, prewash it
before running it through the automatic
car wash.When taking the vehicle through an auto-
matic conveyor type car wash, observe the
following instructions.Vehicles with SmartKey:
With the vehicle at a standstill and the
ignition switched on shift the automatic
transmission to neutral positionN.
If engaged, release the parking brake
(
page 60).
Switch off the ignition and leave the
SmartKey in the starter switch.
Vehicles with KEYLESS-GO*:
With the vehicle at a standstill, depress
the brake pedal and keep it pressed.
With the ignition switched on shift the
automatic transmission to park
positionP.
Release the brake pedal.
Remove the KEYLESS-GO* start/stop
button from the starter switch
(
page 43).
!Do not clean your vehicle in an automatic
touchless car wash which use caustic spray.
Otherwise the caustic spray will damage the
paint or ornamental moldings.
!Make sure that the windshield wiper switch
is set to0 (
page 64). Otherwise, e.g. the rain
sensor could activate and cause the wipers to
move unintentionally. This may lead to vehicle
damage.
Due to the width of the vehicle, fold in exterior
rear view mirrors prior to running the vehicle
through an automatic car wash to prevent
damage to the mirrors.
Warning!G
When leaving the SmartKey or SmartKey
with KEYLESS-GO* in the starter switch, do
not leave children unattended in the vehicle.
It is possible for children to switch on the
ignition which could result in unsupervised
use of vehicle equipment. Unsupervised use
of vehicle equipment could result in an
accident and/or serious personal injury.

431 Operation
Vehicle care
Cleaning the Rear View Camera lens*
1Camera lens
Only use clean water and a soft,
non-scratching cloth to clean the
camera lens1.
Be careful not to apply wax to camera
lens1 when waxing the vehicle. If
necessary, remove the wax using the
Mercedes-Benz approved Car Shampoo
with plenty of water.Cleaning the windows and the wiper
blades
Fold the wiper arms forward until they
engage.
Clean the wiper blade inserts with a
clean cloth and detergent solution.
!Do not clean the camera and the area
around the camera:

with a high-pressure cleaner

with a dry cloth and high pressure

with aggressive cleaning agents
You could otherwise damage the camera.
Warning!G
For safety reasons, switch off wipers and re-
move SmartKey from starter switch
(vehicles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status
0) before cleaning the windshield
and/or the wiper blades. Otherwise, the
wiper motor could suddenly turn on and
cause injury.
!Do not pull on the wiper blade inserts. They
could tear.


520 Practical hints
Replacing wiper blades
Front wiper blades
Removing
Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
Make sure the vehicle’s on-board
electronics have status0
(
page 44).
Fold the wiper arms forward until they
engage.
1Wiper blade
2Cover
3Attachment
4Tab
5Removing
Press tabs4 together and tilt wiper
blade1 to detach tabs4 on both
recesses of attachment3.
Wiper blade1 is released on one end.
Maintaining its tilted position, slide
wiper blade1 out of attachment3 in
direction of arrow5.
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch (vehi-
cles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status
0) before replacing a wiper blade.
Otherwise the motor could suddenly turn on
and cause injury.
Warning!G
Wiper blades are components that are sub-
ject to wear and tear. Replace the wiper
blades twice a year, preferably in the spring
and fall. Otherwise the windows will not be
properly wiped. As a result, you may not be
able to observe surrounding traffic condi-
tions and could cause an accident.
!Never open the hood when the wiper arms
are folded forward.
Hold on to the wiper when folding the wiper arm
back. If released, the force of the impact from
the tensioning spring could crack the windshield.
Do not allow the wiper arms to contact the wind-
shield glass without a wiper blade inserted.
Make sure the wiper blades are properly
installed. Improperly installed wiper blades may
cause windshield damage.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Light Truck Center.
!Do not pull on the wiper blade inserts. They
could tear.

521 Practical hints
Replacing wiper blades
Installing
1Installing
2Tab
3Attachment
4Guide tab
5Cover
Slide the wiper blade into
attachment3 in direction of
arrow1.
Make sure guide tab4 will be placed
under cover5 when fully inserting the
wiper blade into attachment.
Let tab2 latch into both recesses of
attachment3.
Check if the wiper blade is securely
fastened.
Fold the wiper arm backward to rest on
the windshield.
Make sure you hold on to the wiper arm
when folding it back.
Rear wiper blade
Warning!G
For safety reasons, switch off wipers and
remove SmartKey from starter switch
(vehicles with KEYLESS-GO*: Make sure the
vehicle’s on-board electronics have
status
0) before replacing a wiper blade.
Otherwise the motor could suddenly turn on
and cause injury.
!Hold on to the wiper when folding the wiper
arm back. If released, the force of the impact
from the tensioning spring could crack the rear
window.
Do not allow the wiper arm to contact the rear
window glass without a wiper blade inserted.
Make sure the wiper blade is properly installed.
Improperly installed wiper blades may cause
rear window damage.
For your convenience, we recommend that you
have this work carried out by an authorized
Mercedes-Benz Light Truck Center.

579 Index
Instruments and controls see Cockpit
Interior lighting 151
Delayed shut-off 180
Interior rear view mirror 52
Antiglare positions 210
Auto-dimming mirrors* 211
Interior storage spaces see
Storage compartments
Intermittent wiping
Windshield wipers 64
J
Jack 496, 497
Lifting the vehicle 524
Jump starting 538
K
Key, Mechanical 500
Key, SmartKey 114
Batteries 122, 506
Battery check lamp 114
Checking battery condition 122
Closing the power windows
(Convenience closing feature) 252
Closing the tilt/sliding sunroof*
(Convenience closing feature) 252Closing, Power tailgate* 128
Factory setting 116
Locking/unlocking 40, 71, 114
Locking/unlocking, Global
setting 116
Loss of 122
Messages in the
multifunction display 480
Opening the power windows
(Summer opening feature) 251
Opening the tilt/sliding sunroof*
(Summer opening feature) 251
Remote control 114
Replacing batteries 506
Selective setting 116
Starter switch positions 42
Starting the engine 57
Turning off the engine 70
Key, SmartKey with KEYLESS-GO*
Batteries 122, 506
Battery check lamp 117
Checking battery condition 122
Closing the power windows
(Convenience closing feature) 252Closing the tilt/sliding sunroof*
(Convenience closing feature) 252
Closing/locking, Power
tailgate* 129
Factory setting 120
Important notes 119
Locking/unlocking 41, 71, 117
Locking/unlocking, Global
setting 120
Loss of 122
Messages in the
multifunction display 479, 480
Opening the power windows
(Summer opening feature) 251
Opening the tilt/sliding sunroof*
(Summer opening feature) 251
Remote control 117
Replacing batteries 506
Selective setting 121
Start/stop button 43
Starter switch positions 42, 43
Starting the engine 59
Turning off the engine 70

592 Index
Vehicle status message memory
menu 169
Vehicle tool kit 495
Vehicle washing 427
VIN 551
Voice control system*
Button on multifunction steering
wheel 30, 158
Hands-free microphone 34
W
Warning indicators
Parktronic* 292
Warning lamps see Lamps, Indicator and
warning
Warning sounds
Distance warning function* 274
Distronic* 265
Exterior lamps 145
Parking brake 61
Parktronic* 294
Seat belt telltale 88Warranty coverage 10, 549
Washer fluid see Windshield washer fluid
Washer reservoir level 567
Washing the vehicle 425
Wear pattern, Tires 419
Weights, Vehicle 559
Wheel
Bolts 496
Change 524
Removing 526
Spare 499, 524
Tightening torque 528
Wheel, Tires and 385
Wheels
Sizes 555
Window curtain air bags 80
Windows see Power windows
Windows, cleaning 431
Windshield
Cleaning 431
Cleaning wiper blades 431
Cleaning, Windshield washer fluid 65
Defogging 224, 238
Infrared reflecting* 345
Washer fluid 384, 561, 567Windshield washer fluid
Messages in the
multifunction display 487
Mixing ratio 567
Refilling 384
Reservoir level 384
Wiping with 65
Windshield washer system 384, 567
Windshield wipers 63
Cleaning wiper blades 431
Fast continuous wiping 64
Fast intermittent wiping 64
Rear window wiper/washer 65
Replacing wiper blades 520
Slow continuous wiping 64
Slow intermittent wiping 64
Winter driving 420
Snow chains 421
Tires 420
Winter driving instructions 355
Winter tires 420
Wood trims, cleaning 434