fuel type MERCEDES-BENZ ML450 HYBRID 2010 W164 Owner's Manual

Vehicle specification ML 450 HYBRID
(164.195)
The quoted data apply only to the standard
vehicle. Contact an authorized Mercedes-
Benz
Center for the corresponding data of all
special bodies and special equipment. Engine ΜL 450 HYBRID
Engine, type
272
Mode of operation
4-stroke engine,
gasoline injection No. of cylinders
6
Bore
3.66 in (92.90 mm)
Stroke
3.39 in (86.00 mm)
Total piston
displacement
213.5 cu in
(3 498 cm 3
) Compression
ratio
11.5:1
Output acc. to
SAE J 1349
1 275 hp/6
000 rpm
(205 kW/6 000 rpm) Maximum torque
acc.

to SAE J 1349 258 lb-ft/
3 000 - 5 500
(350 Nm/
3 000 - 5 500 rpm) Maximum engine
speed
6 000 rpm
Firing order
1-4-3-6-2-5
Poly-V-belt
2 398 mm
Hybrid ΜL 450 HYBRID
Type
Full hybrid
Concept
Two mode
Output EMA
83 hp
(62 kW) Hybrid ΜL 450 HYBRID
Output EMB
80 hp
(60 kW) Maximum torque
EMA
173 lb-ft (235 Nm)
Maximum torque
EMB
192 lb-ft (260 Nm)
System power
335 hp (250 kW)
381 lb-ft (517 Nm) Electrical system ΜL 450 HYBRID
High-voltage
battery
288 V/45 kW
Battery
12 V/70 Ah
Spark plugs, type
Bosch Y 7 MPP33
Spark plugs,
electrode gap
0.031 in (0.8 mm)
Spark plugs,
tightening torque
15 - 18 lb-ft
(20 - 25 Nm) Main dimensions ΜL 450 HYBRID
Overall vehicle
length
188.5 in (4
788 mm) Overall vehicle
width
2 83.6 in (2
124 mm) Overall vehicle
height
69.8 - 73.0 in
(1 774 - 1
854 mm) Wheelbase
114.8 in (2
915 mm) Track, front
64.7 in (1
644 mm) Track, rear
64.8 in (1
647 mm) Ground clearance
7.3 - 10.3 in
(186 - 261 mm)
Turning circle
39.0 ft (11.6 m)
1
Premium fuel required. Performance may vary with fuel octane rating.
2 Exterior rear view mirrors folded out. 36
Technical data 164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 36

Model
ML 450 HYBRID Capacity Fuels, coolants,
lubricants, etc.
Air conditioning
system
— R134a refrigerant
and special
PAG lubricant oil
(never R 12)
Washer system and
headlamp cleaning
system
7.6 US qt (7.2 l) MB Windshield
Washer
Concentrate
6
, see
Operator's Manual
Washer fluid mixing
ratio,
see Operator's
Manual Approved engine oils
Use the table below to determine the
MB sheet number.
Model
ML 450 HYBRID Engine,
type MB
sheet
number
272 229.5
i
MB sheet numbers are printed on the
outside of oil containers. i
For
more information on approved engine
oils, refer to the Operator's Manual.
Coolants The engine coolant is a mixture of water and
anticorrosion/antifreeze.
The cooling system was filled at the factory
with a coolant providing freeze protection to
approximately -35‡ (-37†) and corrosion
protection.
Model
ML 450 HYBRID Approximate freeze protection
-35‡ (-37†) -49‡ (-45†)
Cooling system
5.0 US qt (4.75 l) 5.5 US qt (5.2 l)
Low temperature cooling
system
1.0 US qt (0.95 l) 1.1 US qt (1.05 l)
!
Add premixed coolant solution only.
Adding

water and MB 325.0 Anticorrosion/
Antifreeze separately from each other,
could cause engine damage not covered by
the Mercedes-Benz Limited Warranty.
i For more information on coolants, refer to
the Operator's Manual.
6 Mixed with water or commercially available premixed washer solvent/antifreeze. Technical data
39164_ZA; 2; 2, en-US
d2ureepe,
Version: 2.11.8.1 2009-05-12T15:08:04+02:00 - Seite 39 Z