button MERCEDES-BENZ SL500 2003 R230 Owner's Manual

22 At a glanceMultifunction steering wheel
Multifunction steering wheel
Item
Page
1
Left multifunction display in
speedometer
110
2
Right multifunction display in
tachometer
110
Operating control system
111
3
Selecting the submenu or
setting the volumeç
down / to decrease
æ
up / to increase
4
Telephone*: press buttoní
to take a call
ì
to end a call
Item
Page
5
Menu systems: Press buttonè
for next system
ÿ
for previous system
6
Moving within a menu:
Press buttonj
for next display
k
for previous display

23 At a glance
Center console
Center console
Upper part
Item
Page
1
Central locking switch
92
2
Hazard warning flasher
on/off switch
105
3
Central unlocking switch
92
4
Center and side air vent
adjustment
147
5
COMAND system, see
separate operating in-
structions
113
6
Automatic climate control
149
7
Right cup holder
190
8
KEYLESS-GO* start/stop
button
30
9
Ashtray
Cigarette lighter
196
197
10
Left cup holder
190

24 At a glanceCenter consoleLower part
Item
Page
1
Parking assist (Parktronic
system)* deactivation
switch
186
2
Active Body Control (ABC)
switch
183
3
Tow-away alarm switch
77
4
Hardtop open/close con-
trol with buttons for roll bar
159
61
5
Exterior rear view mirror
adjustment
35
Item
Page
6
Vehicle level control switch
184
7
ESP control switch
71
8
Thumbwheel for setting
distance for Distronic*
179
9
Distance warning func-
tion* on/off switch
179
10
Program mode selector for
automatic transmission
141
11
Selector lever for
automatic transmission
137

25 At a glance
Overhead control panel
Overhead control panel
Item
Page
1
Left reading lamp on/off
106
2
Temperature sensor for
automatic climate control
147
3
Right reading lamp on/off
106
4
Interior lighting control
106
5
Hands-free microphone
for Tele Aid (emergency
call system), telephone*
and voice control system*
(see separate operating
instructions)
199
6
Rear view mirror
35,
145
7
Garage door opener
208
8
Tele Aid (emergency call
system) button
200

28 Getting startedUnlockingThe “Getting started” section provides an
overview of the vehicle’s most basic func-
tions. First-time Mercedes-Benz owners
should pay special attention to the infor-
mation given here.
If you are already familiar with the basic
functions described here, the “Controls in
detail” section will help you with further in-
formation. The corresponding page refer-
ences are at the end of each segment.
UnlockingUnlocking with the SmartKeyElectronic key with remote control1‹
Lock button
2
Š
Unlock button for trunk lid
3
Œ
Unlock button
4
Â
Panic button

Press unlock button3
Œ
on the key.
The indicator lamps light up for a short
time. The locking knobs in the doors
move up.

Get in the vehicle and insert the key in
the starter switch.iThe SBC brake system is activated.iOpening a door causes the windows on
that side of the car to open slightly.
They will return to the up position when
the door is closed.

30 Getting startedUnlockingUnlocking with KEYLESS-GO*
The functions of the KEYLESS-GO card are
nearly identical to those of the key, except
that it cannot be used to open the retract-
able hardtop. When using the key and the
card at the same time, the key overrules
the card.

Grasp the door handle.
The turn signal lamps blink once. The
locking knobs on the doors move up.Pressing the KEYLESS-GO start/stop but-
ton on the selector lever corresponds to
turning the key to the various starter
switch positions.
1KEYLESS-GO start/stop button
Before you press the KEYLESS-GO
start/stop button, the vehicle’s on-board
electronics have the status0 (as with key
removed).
Make sure the gear selector lever is set
toP.
Do not depress the brake pedal.
iThe KEYLESS-GO card must be outside
the vehicle to unlock it.
Warning!
G
When leaving the vehicle, always take the
key and the KEYLESS-GO card with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. Unsupervised use of vehi-
cle equipment may cause an accident
and/or serious personal injury.iThe SBC brake system is activated.

31 Getting started
Unlocking
Position 1
Press the KEYLESS-GO start/stop but-
ton once.
Power supply for some electrical con-
sumers, such as seat adjustment.Ignition (or Position 2)

Press the KEYLESS-GO start/stop but-
ton twice.
Power supply for all electrical consum-
ers. All the lights in the instrument
cluster light up.
More information can be found in the
“Controls in detail” section (
page 84).
For information on starting the engine us-
ing the KEYLESS-GO start/stop button,
see Starting with KEYLESS-GO
(
page 40).
iIf you now press the KEYLESS-GO
start/stop button twice, the power
supply is again switched off.
iIf you now press the KEYLESS-GO
start/stop button once, the power sup-
ply is again switched off.

33 Getting started
Adjusting
The seat adjustment switch is located in
the door.
1Seat fore and aft adjustment
2Seat height
3Seat cushion tilt
4Backrest tilt
5Seat cushion depth
6Head restraint height
Switch on the ignition by turning the
key in the starter switch to position2
or pressing the KEYLESS GO*
start/stop button twice.Seat fore and aft adjustment

Press the switch forward or backward
in the direction of arrow1.
Seat height

Press the switch up or down in the di-
rection of arrow2.
Seat cushion tilt

Press the switch up or down in the di-
rection of arrow3 until your upper legs
are lightly supported.
Backrest tilt

Press the switch forward or back in the
direction of arrow4.Seat cushion depth

Press the switch forward or back in the
direction of arrow5.
Head restraint height

Press the switch up or down in the di-
rection of arrow6.
!When moving the seat, be sure that
nothing is in the auxiliary cup holder
and that there are no items in the foot-
well or behind the seats. Otherwise the
seats could be damaged.
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint to support the back of
the head approximately at ear level.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.

35 Getting started
Adjusting
Steering column, height
Move the stalk up or down in the direc-
tion of arrow2. Make sure that your
legs can move freely and that all the
displays (including malfunction and in-
dicator lamps) on the instrument clus-
ter are clearly visible.
Mirrors
Adjust the inside and exterior rear view
mirrors before driving so that you have a
good view of the road and traffic condi-
tions.
Inside rear view mirror
Manually adjust the inside rear view
mirror.Exterior rear view mirror
The buttons are located on the lower part
of the center console.
1Driver’s side mirror
2Passenger side mirror
3Adjustment button
iThe memory function (
page 99) lets
you store the steering wheel adjust-
ment together with the adjustment for
the seat and the exterior rear view mir-
rors.

36 Getting startedAdjusting

Make sure that the ignition is switched
on.
All the lights in the instrument cluster
light up.

Press button1 for the left mirror or
button2 for the right mirror.

Push adjustment button3 up, down,
left or right according to the setting de-
sired.More information can be found in the
“Controls in detail” section (
page 145).
Warning!
G
Exercise care when using the passenger
side exterior rear view mirror. The mirror
surface is convex (outwardly curved surface
for a wider field of view). Objects in mirror
are closer than they appear. Check your in-
side rear view mirror or glance over your
shoulder before changing lanes. Warning!
G
In case of an accident, liquid electrolyte may
escape the mirror housing if the mirror glass
breaks.
Electrolyte has an irritating effect. Do not al-
low the liquid to come into contact with
eyes, skin, clothing, or respiratory system.
In case it does, immediately flush the affect-
ed area with water, and seek medical help if
necessary.
!Electrolyte drops coming into contact
with the vehicle paint finish can only be
completely removed while in their liq-
uid state and by applying plenty of wa-
ter.iThe memory function (
page 99) lets
you store the steering wheel adjust-
ment together with the adjustment for
the seat and the exterior rear view mir-
rors.
!If an exterior rear view mirror housing
is forcibly pushed forward or rearward,
reposition it by applying firm pressure
until it snaps into place. The mirror
housing is now properly positioned and
you can adjust the mirror normally.