engine oil capacity MERCEDES-BENZ SPRINTER 2011 MY11 Operator’s Manual

Modifying the engine power output
Having the engine power output of your
vehicle increased by tampering with the
electronic engine management system will
invalidate the vehicle's general operating
permit and insurance coverage, as well as
your New Vehicle Limited Warranty and
warranty entitlement.
Modifications to the output of the engine
must be reported to the insurance provider
and require the vehicle to be recertified. The
tires, chassis, brake and cooling systems
must be adapted to the increased engine
power output.
Tampering with the electronic engine
management system modifies emission
values and it
will not be possible to guarantee
the operating safety of the engine in every
case. Increases in performance may lead to
malfunctions and consequential damage to
other assemblies.
If you sell the vehicle, failing to inform the
buyer of the modified engine power output
could constitute an offense punishable by
law, depending on the country concerned. Diesel particle filter
! If the vehicle is predominantly used for
short-distance driving, this could lead to a
malfunction in the automatic cleaning
function for the diesel particle filter. As a
result, fuel may accumulate in the engine
oil and cause engine failure.
Therefore, if you mainly drive short
distances, you should

drive on a highway or
on rural roads for 20 minutes every
310 miles (500 km). This ensures sufficient
regeneration of the diesel particle filter. Vehicle alterations
We recommend the use of genuine Sprinter
parts and conversion parts as well as accessories that have been expressly
approved for your vehicle model.
These parts have been subjected to special
tests in order to determine their safety,
reliability and suitability.
!
For safety reasons, have add-on
equipment prepared and installed
according to the

Sprinter body/equipment
mounting directives in force. These body/
equipment mounting directives guarantee
that the chassis and add-on equipment
form a cohesive whole and that the highest
possible level of operating and driving
safety is reached.
We recommend for safety reasons that:
R you carry out no other modifications to
the vehicle.
R you obtain the agreement of the
distributor named on the inside of the
front cover for any deviations from the
approved body/equipment mounting
directives.
Approval by official testing centers or
permission given by authorities do not
eliminate safety risks.
! The wooden or plastic cargo area floor
fitted at the factory is an integral
component of the vehicle structure. The
vehicle body could be damaged if you have
the load area floor removed. This then
affects the securing of loads and the
maximum loading capacity of the lashing
points is no longer guaranteed.
Therefore, do not have the load area floor
removed.
Even seemingly small changes to the vehicle,
such as attaching a radiator cover for winter
driving or as protection against insects, are
not allowed. These could cause the engine
diagnostics to register incorrect data. The
recording of engine diagnostic data is a legal
requirement, and must always be verifiable
and accurate. 18
Introduction

Have the system checked immediately at a
qualified specialist workshop, e.g. at an
authorized Sprinter Dealer.
i There is usually a notice in the engine
compartment to remind
you when the next
brake fluid change is due. Windshield washer system/
headlamp cleaning system
Add windshield washer concentrate to the
washer fluid all year round. G
Warning
Windshield washer concentrate is highly
flammable.
Fire, naked flames

and smoking are therefore
prohibited when you are handling windshield
washer concentrate.
! Only use washer fluid concentrate which
is suitable for plastic lenses. Unsuitable
washer fluid concentrate could damage the
plastic lenses of the headlamps.
Adapt the mixing ratio to the ambient
temperature. If the temperature is above
freezing, use Summerwash to prevent
smearing. If there is a risk of frost, use
Winterwash to prevent the water from
freezing on the windshield.
The washer fluid reservoir has a capacity of
approximately 6.3 US qt (6.0 l). X
Mix the washer fluid to the appropriate
mixing ratio in a container beforehand.
X Remove washer fluid reservoir cap 0046.X
Add washer fluid.
X Replace cap 0046. Engine oil level
You will find information about engine oil
consumption in the "Driving tips" section
(Y page 141).
Check the engine oil level on a regular basis,
e.g. weekly or each time you refuel.
Checking the engine oil level in the
display Depending on the vehicle's equipment, in
vehicles with a diesel engine, the engine oil
level is shown in the display.
Only check the engine oil level when the
engine is at operating temperature.
X
Park the vehicle on a level surface.
X Switch off the engine.
X Wait for five minutes.
X Turn the key to position 2 in the ignition
lock.
The display is activated.
i If at extremely low temperatures no
engine oil level is displayed after five
minutes, repeat the engine oil level check
after a further five minutes.
If an oil level reading is still not displayed,
check the engine

oil level with the dipstick.
Have the oil level display checked at a
qualified specialist workshop, e.g. at an
authorized Sprinter Dealer.
Vehicles without steering wheel buttons
X Press the 007B menu button on the
instrument cluster repeatedly until the
display shows the 00B1 symbol.
The --:-- display flashes

while the oil level
is being measured. Maintenance
171
Operation Z